NEC Neax 2400 Imx Callcenterworx Enterprise Acd System Manual
Have a look at the manual NEC Neax 2400 Imx Callcenterworx Enterprise Acd System Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 1168 NEC manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
CHAPTER 4 NDA-24282 (E) Pag e 1 42 Revision 1.0 PA-4DATA (4DAT) (b) LT Connector Lead Accommodation when this circuit card is mounted in PIMB Figure 4-13 LT Connector Leads Accommodation of PIMB LT Connector Accommodation 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50LT1, 3, 5, 8, 10 Connector1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 2526 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50LT0, 2, 4, 6, 7, 9 Connector 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 2526 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50LT1,3, 5, 8, 10 Connector1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23 LT0 PIMB LT Connector Name Slot No. Group No. LT1LT2LT3LT4LT5LT7LT8LT9LT10 03 0207 0611 1015 1419 1823 2215 14 13 1207 06 05 0415 14 13 1223 22 21 20 Highway Block012678 934510 11 LT6 23 22 21 2007 06 05 0415 14 13 1223 22 21 20 01 0005 0409 0813 1217 1621 2011 10 09 0803 02 01 0011 10 09 0819 18 17 16 19 18 17 1603 02 01 0011 10 09 0819 18 17 16 03 02 01 0007 06 05 04 8 910 11 4 56 7 2 3 0 1 * 1 Accommodated in *1Accommodated in *2 FM FMAccommodated in *3 FM * 1 * 1 * 1 * 1 * 1 * 2 * 2 * 2 * 2 * 2 * 3 * 3 * 3 * 3 * 3
NDA-24282 (E) CHAPTER 4 Page 143 Revision 1.0 PA-4DATA (4DAT) Switch Setting Sheet MODULE SLOT NO.SWITCH NAMESWITCH SHAPE REMARKS PIM SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8 SW9 SW10ON 12 3 4 ON 12 3 4 ON 12 3 4 ON 12 3 4 ON 12 3 4 ON 12 3 456 7 8 ON 12 3 4 ON 3 2 1 0 ON
CHAPTER 4 NDA-24282 (E) Pag e 1 44 Revision 1.0 PA-4DATA (4DAT) SW12 MB DOWN Circuit card make idle. Switch Setting Sheet (Continued) MODULE SLOT NO.SWITCH NAMESWITCH SHAPE REMARKS ON
NDA-24282 (E) CHAPTER 4 Page 145 Revision 1.0 PA-4DATB (DAT) PA-4DATB (DAT) 1. General Function The PA-4DATB (DAT) circuit card is used as a Digital Announcement Trunk supporting service features related to announcement functions such as Automated Attendant, Delay Announcement Attendant, Announcement Service (for Hotel System). Depending on the switch setting, this circuit card works in one of the following three modes. 64-second mode (maximum 4 CHs/card) 128-second mode (maximum 2 CHs/card) 240-second mode (maximum 1 CH/card) A message can be recorded from either a tape recorder or a telephone set. In addition, this circuit card can be used as an external music source. Figure 4-14 Location of PA-4DATB (DAT) card within the system DLKC CPUGT COT SW PUBLIC NETWORK INCOMING CALL LOCAL I/O BUS ATTCON DAT COT INT INT CALLING PARTY CALLING PARTY INCOMING CALLATI This diagram shows an example when this card is used for Delay Announcement Attendant. We are sorry, the line is busy now. Please stay on the line. (PRERECORDED MESSAGE)
CHAPTER 4 NDA-24282 (E) Pag e 1 46 Revision 1.0 PA-4DATB (DAT) 2. Mounting Location/Condition The PA-4DATB (DAT) card can be mounted in any universal slot as shown below. Mounting Module PIMU-A 00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23 Note: Indicates universal slots for line/trunk circuit cards. Mounting Module PIME 00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23 Note: Indicates universal slots for line/trunk circuit cards.
NDA-24282 (E) CHAPTER 4 Page 147 Revision 1.0 PA-4DATB (DAT) 3. Face Layout of Lamps, Switches, and Connectors The face layout of lamps, switches, and connectors on this circuit card is shown below. 4. Lamp Indications The contents of lamp indications of this circuit card are shown in the table below. LAMP COLOR STATE OPE Green Remains lit while this circuit card is operating. N-OPE Red Remains lit while this circuit card is in make-busy state. BL4 BL7GreenLights when the corresponding circuit (No 0 through No. 3 circuits) is connected to a recording source. FlashFlashes while message recording is in progress on the corresponding circuit (No. 0 through No. 3 circuit). BL0 BL3Red Lights when the corresponding circuit (No. 0 through No. 3 circuits) is busy. FlashFlashes when the corresponding circuit (No. 0 through No. 3 circuits) is in make-busy state or has not been assigned in the system. OPE N-OPE MB ML7 ML0 START 3 2 1 0 SW1SW5 SW6 SW4 JP0MB RQ MRCS JACK WR SW3 SW7SW2 ~~
CHAPTER 4 NDA-24282 (E) Pag e 1 48 Revision 1.0 PA-4DATB (DAT) 5. Switch Settings Standard settings of switches on this circuit card are shown in the table below. SWITCHSWITCH NO.SETTINGSTANDARD SETTINGMEANING MB UP Circuit card make busy. DOWN×Circuit card make busy cancel. MB RQ 1-4ONMake busy request on a channel basis (Channel Designation for Recording/Playback) OFF×Make busy request cancel on a channel basis MRCS 0 1 2 3 4 5 6 7 SW1 SW4Each Switch corresponds to each chan- nel of DAT: channel SW1: channel 0 SW2: channel 1 SW3: channel 2 SW4: channel 3 SETTING OF RECORDING MODE SWITCH NO. MODE Channel 0 64-sec. mode0 11 22 33 4 128-sec. mode0, 1 52, 3 6 240-sec. mode 0, 1, 2, 3 ~ SETTING OF TIMER FOR EACH CIRCUIT 1224TIMER (MODE) ON ON OFF ON 64-sec. mode ON ON ON OFF 128-sec mode OFF OFF OFF OFF 240-sec. mode ON ON ON ON Not available
NDA-24282 (E) CHAPTER 4 Page 149 Revision 1.0 PA-4DATB (DAT) SWITCHSWITCH NO.SETTINGSTANDARD SETTINGMEANING SW5 1 2 3ON Compression Law: µ-law OFF Compression Law: A-law 4ON To be used as external hold tone source OFF To be used as announcement equipment SW6 1ON Single playback of No. 0 channel Note 2 OFF Multiple playback of No. 0 channel 2ON Single playback of No. 1 channel Note 2 OFF Multiple playback of No. 1 channel 3ON Single playback of No. 2 channel Note 2 OFF Multiple playback of No. 2 channel 4ON Single playback of No. 3 channel Note 2 OFF Multiple playback of No. 3 channel 5ON RAM Test data - clear OFF×RAM Test data - store 6OFF×Not used 7OFF×Not used 8OFF×Not used Note 3:When this card is used as announcement equipment, SW6-1~SW6-4 should be set OFF. Note 4:For Automated Attendant and Delay Announcement-Attendant, set single playback (ON). Note:Setting of Recording/Playback Timer should correspond to that of SW1-SW4. SETTING OF ANNOUNCEMENT RECORDING/PLAYBACK TIME SW5-1 SW5-2 RECORDING/PLAYBACK TIME OFF ON 64-sec. Recording/Playback ON OFF 128-sec. Recording/Playback OFF OFF 240-sec. Recording/Playback
CHAPTER 4 NDA-24282 (E) Pag e 1 50 Revision 1.0 PA-4DATB (DAT) SWITCHSWITCH NO.SETTINGSTANDARD SETTINGMEANING SW7 1ON Activation of RAM Test OFF×Normal setting 2ON Port Microprocessor is reset when MBR key is ON. OFF×Port Microprocessor is not reset when MBR key is ON. 3OFF×Not used 4OFF×Not used WR UP For recording from the phone jack DOWN×Normal setting START UPWhen starting recording from the phone jack or play- back. DOWN×Normal setting Jumper Setting SWITCHSWITCH SHAPESETTING DESCRIPTION JP0LEFT Compression Law: µ-law RIGHT Compression Law: A-law LEFTRIGHT
NDA-24282 (E) CHAPTER 4 Page 151 Revision 1.0 PA-4DATB (DAT) 6. External Interface When this card is used as an external music-on-hold source, the following cable connection is required. Figure 4-15 LT Connector Lead Accommodation (PIMU-A) EFM EFM26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23 LT0 PIMC LT Connector Name Slot No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 Group No. LT1LT2LT3LT4LT5LT6LT7LT8LT9LT10LT11 01 0003 0205 0407 0609 0811 1001 0003 0205 0407 0609 0811 1015 14 13 1219 18 17 1623 22 21 2015 14 13 1219 18 17 1623 22 21 20 Highway Block01267834591011 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 LT0, 2, 4, 6, 8, 10 Connector Accommodated in *2Accommodated in *1 LT1, 3, 5, 7, 9, 11 ConnectorAccommodated in *3 LT1, 3, 5, 7, 9, 11 Connector EFM Mounting ModulePIMC 1 231 231 23 1 231 231 23