Canon Imageclass Mf7470 User Guide
Have a look at the manual Canon Imageclass Mf7470 User Guide online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 1335 Canon manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Maintenance 10‑12 Replacing the Stamp Cartridge Originals can be stamped to indicate that they have been sent. Replace the stamp cartridge when this mark is faint or no longer visible. When replacing the stamp cartridge, take care not to allow ink to come in contact with your hands or clothing. If ink gets onto your hands or clothing, wash it off immediately with cold water. 1 Open the feeder cover, then open the inner cover (B) by holding its front tab for removing the old stamp cartridge (A). 2 Remove the old stamp cartridge using the tweezers. Widen the tweezers if necessary. 3 Insert a new stamp cartridge into the feeder using the tweezers until it clicks. Set the stamp cartridge so that the two projections on the cartridge are aligned with the hollows on the feeder. Be careful that the stamping surface of the stamp cartridge does not protrude. Insert the stamp cartridge properly, or it may cause paper jams. – – –
10‑13 Maintenance 4 Gently close the inner cover and the feeder cover until it clicks. Be careful not to get your fingers caught.
Maintenance 10‑14 Replacing the Cartridge When the machine runs out of toner, the following screen appears on the touch panel display. When this happens, remove the cartridge from the machine and slowly shake it sideways to redistribute toner. Reinstall the cartridge in the machine and print out a test page. If the error message still appears, follow the instructions shown on the screen and replace the cartridge. If you press [Recover Later], you can continue operations, such as setting modes and scanning originals, without replacing the cartridge immediately. Do not burn or throw used cartridges into open flames, as this may cause\ the toner remaining inside the cartridges to ignite, resulting in burns or a fire. Do not store cartridges in places exposed to open flames, as this may cause the toner to ignite, resulting in burns or a fire. When discarding used cartridges, put the cartridges in a bag to prevent the toner remaining inside the cartridges from scattering, and dispose of them in a location away from \ open flames. Do not touch the rollers and parts which have labels “CAUTION! Hot su\ rface avoid contact” on. They become very hot during use. Keep toner out of the reach of small children. If toner is ingested, con\ sult a physician immediately. Take care not to allow toner to come into contact with your hands or clo\ thing. If toner gets onto your hands or clothing, wash it off immediately with cold water. Washing it off with warm water will set the toner, and make it impossible to remove the toner stains. When you are replacing a cartridge, be sure to use a cartridge designed for this product. Do not replace cartridge until the message prompting you to do so appears. Do not attempt to replace the cartridge while the machine is printing. Complete instructions on how to replace the cartridge can be accessed by pressing [Previous] or [Next] on the touch panel display. If the toner runs out during a print job, the machine will start printin\ g the remaining pages automatically after you replace the cartridge. – – – – – – – – – – –
10‑15 Maintenance 1 Press the button on the left cover of the main unit, and open the left cover. 2 Open the front cover. 3 Rotate the unlock lever until it clicks. Make sure that the ▼ (down arrow) on the lever is aligned with the ▲ (up arrow) of the (Unlock) icon position before proceeding. 4 While grasping the handle of the cartridge holder, pull the cartridge holder out of the machine until it stops.
Maintenance 10‑16 5 While grasping the handle of the cartridge, remove the cartridge from the cartridge holder. Lift the cartridge straight up. 6 Remove the new cartridge from the protective bag. Save the protective bag. You may need it later when you remove the cartridge from the machine. 7 Remove the desiccant bag and the shipping tape. 8 Place the cartridge on a flat surface, and remove only the short shipping tape affixed on both other sides of the cartridge. 9 Remove the packing materials.
10‑17 Maintenance 10 Hold the cartridge, shake it gently five or six times from side to side, then back and forth to evenly distribute the toner inside. 11 Pull out the sealing tape completely in the direction of the arrow in the illustration below while supporting the cartridge. Pull the sealing tape straight out. If the sealing tape is pulled out forcefully or stopped at midpoint, toner may leak. If toner gets into your eyes or mouth, rinse it out immediately with cold water and consult a physician. If loose toner comes into contact with your skin or clothing, wash with cold water. Warm water will set the toner. – – Pull out the sealing tape completely from the cartridge. If the sealing tape remains in the cartridge, it may result in a deterioration in print quality. Dispose of the sealing tape according to local regulations. 12 Place the cartridge on a flat surface, and remove the long shipping tape affixed on both sides of the cartridge. 13 Remove the protective cover by pulling its tab. – –
Maintenance 10‑18 14 While grasping the handle of the new cartridge, insert the cartridge into the cartridge holder. Use only the cartridge recommended for use in this machine. 15 While grasping the handle of the cartridge holder, push the cartridge holder in the machine as far as it will go. 16 Rotate the lever to the locked position. Make sure that the ▼ (down arrow) on the lever is aligned with the ▶ (right arrow) of the (Lock) icon position. 17 Close the front cover. Be careful not to get your fingers caught.
10‑19 Maintenance 18 Gently close the left cover of the main unit until it clicks by placing your hand on the hand symbol located on the left cover. Be careful not to get your fingers caught.
Maintenance 10‑20 Recycling Used Cartridges Canon has instituted a worldwide recycling program for cartridges called “The Clean Earth Campaign”. This program preserves precious natural resources by utilizing a variety of materials found in the used cartridges that are of no further use, to remanufacture new cartridges which, at the same time, keeps the environment cleaner by reducing landfill waste. Complete details concerning this program are enclosed in each Cartridge box. The Clean Earth Campaign THE Canon CARTRIDGE RECYCLING PROGRAM The Canon Cartridge Recycling Program fulfills the first initiative of Canon’s Clean Earth Campaign, which supports four critical environmental areas: Recycling in the Workplace Conserving Environmental Resources Scientific Research and Education Encouraging Outdoors Appreciation The remaining “Clean Earth” initiatives are supported in the U.S. through sponsorships of the National Park Foundation, the National Wildlife Federation, and The Nature Conservancy and in Canada through donations to the World Wildlife Fund Canada and The Nature Conservancy of Canada. Ô Ô Ô Ô Ô
10‑21 Maintenance Since its inception, The Canon Cartridge Recycling Program has collected huge amount of cartridges that otherwise would have been discarded into landfills or similar facilities. Instead, this rapidly growing program returns used cartridges to the manufacturing process, thus conserving an array of resources. Becoming a part of this worthwhile program is easy. When your cartridge is of no further use, simply follow the instructions detailed for U.S. or Canadian residents. We appreciate your support of The Canon Cartridge Recycling Program. Working together we can make a significant contribution to a cleaner planet. Cartridges collected through this program are not refilled. You are not entitled to a tax deduction or rebate for the return of empty cartridges. This program may be modified or discontinued without notice. Ô Ô Ô