Vodavi Starplus 2448ex Hybrid Key Telephone System Installation Manual

							Hybrid Key Telephone System %ARPLUSw 2446EX 
Data Base Printout Description 
ANNOUNCEMENTTABLE 
TYPE INDEX TIME 
i PPI 
### t:: 
SMDR TYPE PRNT BAUD ACCT 
N LD 80 4800 N 
DIAL PULSE 
RATIO SPEED 
6040 1OPPS 
vM ALT LEv Rr sTNc 690 # 
691 
P P 
692 P # 
693 
t # 
694 # P 
695 # # 
696 t # 
697 # # 
VOICE MAIL OUT TABLE 
IDX PREFIX SUFFIX 
0 
VOICE MAIL CO DISCONNECT SIGNAL 
exiting admin... 
WI- Voice Mail Group 
ALT= Alternate Voice Mail Groups 
LEV= tiave” Outpulsing Table Index 
RET= yletrieve” Outpulsing Table Index 
STN#= VM Station numbers 
Figure 67&l DB Printout of System Parameters (Con’t) 
670-4 Issue 3, August 1991  
						

							System Data Ease Printouts (Cont’d) 
670.3 CO LINE AlTRIBUTES 
Programming Steps Description 
If the system is in the programming mode, continue 
using program codes. If starting to program here 
enter the programming mode first (referto paragraph 
600.3). 
If a printout of the CO Line Attributes is desired: 
1. Press FLASH and dial [82]. The following mes- 
sage wilt be shown on the display of a display 
phone: With a printer connected to the RS232C port, of the 
CCU, the currently stored customer data base can 
be printed or “uploaded” into a file. This command 
allows either a range of CO Lines or the entire CO . 
Line data base to be “dumped” as a permanent 
record which can serve as a hard copy of the CO 
Line attribute data base. 
The system Baud rate must match that of the printer 
or receiving device. Refer to section 610.20 for 
instructions on viewing or changing the baud rate in 
the 2448EX system. 
When printing the CO Line attributes the following 
data is printed: 
2. Enter a four (4) digit number for the range of 
lines a printout is desired. To print a single CO 
Line enterthat line numbertwice (i.e. 0101). To 
print out data for all CO Lines enter [0124]. the 
following display will be shown on the display 
phone; 
When the system has finished sending the re- 
quested information to the printer, confirmation tone 
will be heard. 
l All CO Line parameters 
l CO Line ringing assignments 
Refer to the following Figure for an example of the 
CO Line attribute data base print out. 
Issue 3, August 1991 670-5  
						

							Hybrid Key Telephone System STARPLUS@ 2448EX 
Data Base Printout Description 
7A MONITOR Eng. Ver. l.lf 
DATE: 07/24/91 TIME: 14:13:38 
ENTER PASSWORD: 
adm>, 
ENTER PROGRAM NO 
adrc-82 
PRINT CO LINES 
ENTER RANGE PRESS HOLD 
adm 
adroOl 
CO LINE ATTRIBUTES 
co 1 
-- 
SIGNAL TYPE UNA SUPV 
DTMF CO Y 
N 
DISA FLTM GRP COS UCD 
N 10 1 1 ### 
co 2 
-- 
SIGNAL TYPE UNA SUPV 
DTMF CO Y 
N 
DISA FLIM GRP COS UCD 
N 
10 1 1 ### 
co 3 
-- 
SIGNAL TYPE UNA SUPV 
DTMF CO Y 
N 
DISA FLlM GRP COS UCD 
N 10 1 1 ### 
. . . . . . 
. . . . . . 
..,... 
CO 24 
-- 
SIGNAL TYPE UNA SUPV 
DTMF CO Y N 
DISA FLIM GRP COS UCD 
N 10 1 1 ##ii 
admm 
exiting admin... 
SIGNAL- DTtvlF/Dial Pulse 
TYPE= CO/PBX 
UNA= Universal Night Answer 
SUPV= Loop Supervision 
DISA= Direct Inward System Access 
FLTM= Flash Timer 
GRP= CO Line Group 
COS= CO Line Class of Service 
irCD=UCD Ringing to UCD Group 
Figure 670-2 DB Printout of CO Line Attributes 
6704 Issue 3e Auaust 1991  
						

							sTARPLUS@ 2448EX Hybrid Key Telephone System 
System Data Base Printouts (Cont’d) 
670.4 STATION ATTRIBUTES 
Proqramming Steps 
If the system is in the programming mode, continue 
using program codes. If starting to program here 
enter the programming mode first (refer to paragraph 
600.3). 
If a printout of the Station Attributes is desired: 
1. Press FLASH and dial 163). The following mes- 
sage will be shown on the display of a display 
phone: 
2. Enter a four (4) digit number for the range of 
stations a printout is desired. To print a single 
stations data enter that station extension num- 
ber twice (i.e. 1010). To print out data for all 
stations enter [I 057. the following display will 
be shown on the display phone: 
When the system has finished sending the re- 
quested information to the printer, confirmation tone 
will be heard. Description 
With a printer connected to the RS232C port, of the 
CCU, the currently stored customer data base can 
be printed or “uploaded” into a file. This command 
allows either a range of station data or all stations 
data information to be “dumped” as a permanent 
record which can serve as a hard copy of the station 
attribute data base. 
The system Baud rate must match that of the printer 
or receiving device. Refer to section 610.20 for 
instructions on viewing or changing the baud rate in 
the 2446EX system. 
When printing the Station attributes the following 
data is printed; 
l AJI current station parameters 
l Current Flex Button assignments 
Refer to the following Figure for an example of a 
Station attribute data base print out. 
Issue 3, August 1991 670-7  
						

							Hybrid Key Telephone System sTARPLUS@ 2448EX 
Data Base Printout Description 
7A MONITOR Eng. Ver. l.lf 
DATE: 07/24/91 TIME: 14:14:53 
ENTER PASSWORD: 
admz-, 
ENTER PROGRAM NO 
adm>83 
PRINT STATIONS 
ENTER RANGE PRESS HOLD 
admz-1057 
STATION ATTRIBUTES 
STA 10 
PAGE DND SPD QUE PLA CSLT 
YYYYN N 
LCOS LCR FWD SID AID COS SPK 
0 N Y 0 1 0 
PICKUP 1 
PAGE 1 
PREFWD CO ACCESS 1 
SLT RING 
BUTTONS 
OlDlO 02Dll 03D12 
04D13 05D14 06D15 
07D16 08D17 0901B 
1002B 1103B 1204B 
1305B 1406B 15PLl 
16LP 
. . . . . . 
. . . . . . 
. . . . . . 
STA 57 
- 
PAGE DND SPD QUE PLA CSLT 
YYYYN N 
LCOS LCR FWD SID AID COS SPK 
0 N Y 0 1 0 
PICKUP 1 PAGE 1 
PREFWD CO ACCESS 1 
SLT RING 
BUTTONS 
OOPL7 
adm>m 
exiting admin... 
PAGE= Paging Access 
DND= Do Not Disturb 
SPD= System Speed Dial Access 
QUE= Line Queue Access 
PLA= Preferred Line Answer 
CSLT=SLT Add-On Conference 
LCOS- LCR Class of Service 
LCR= Forced LCR 
MID= Station Call Forward Access 
SID= Station ID 
AID= Associated ID (DSS/DLS Console) 
COS=Class of Service 
SPK= Speakerphone Option 
PICKUP= Pickup Groups 
PAGE= Paging Groups 
PREFWD= Preset Forward Assignment 
CO ACCESS= CO Line Access 
BUTTONS= Refer to Table 630-I 
Figure 670-3 DB Printout of Station Attributes 
670-8 Issue 3. Auaust 1991  
						

							sTARPLUS@ 2448EX 
Hybrid Key Telephone System 
System Data Base Printouts (Cont’d) 
670.5 EXCEPTION TABLES 
Programming Steps 
If the system is in the programming mode, continue 
using program codes. If starting to program here 
enter the programming mode first (refer to paragraph 
600.3). 
If a printout of the Exception tables are desired: 
1. Press FLASH and dial [&I]. The following mes- 
sage will be shown on the display of a display 
phone: 
2. Press a flexible button to correspond to the 
exception table a print out is desired. Then 
press HOLD. 
When the system has finished sending the re- 
quested information to the printer, confirmation tone 
will be heard. Description 
With a printer connected to the RS232C port, of the 
CCU, the currently stored customer data base can 
be printed or “uploaded” into a file. This command 
allows each exception table to be printed individually 
to serve as a permanent record which can be saved 
as a hard copy of the exception table data base. 
The system Saud rate must match that of the printer 
or receiving device. Refer to section 610.20 for 
instructions on viewing or changing the baud rate in 
the 2446EX system. 
When printing information from the exception tables 
the flex buttons are mapped as follows: 
Refer to the following Figure for an example of the 
Exception Tables data base print out. 
Issue 3, August 1991 670-9  
						

							Hybrid Key Telephone System sTARPLUS@ 2448EX 
7A MONITOR Eng. Ver. l.lf 
DATE: 07/24/91 TIME: 14:17:09 
ENTER PASSWORD: 
a&, 
ENTER PROGRAM NO 
adm>84 
PRINT EX TABLES 
ENTERBUTIUNNUMBER 
a-q 
PRINT 
ALLOW TABLE A 
PRESS HOLD 
adm 
EXCEPTION TAELES adm>r 
PRINT DENY TABLE B 
PRESS HOLD 
adm 
EXCEPTION TABLES 
Deny Table B 
ii E- 
:34 08 
09 
05 10 
Allow Table A 
-- 
01 
11 
adm-w 
PRINT DENY TABLE A 
PRESS HOLD 
adm 
EXCEPTION TABLES 
Deny Table A 
it 
it- 
03 08 
04 
05 E 
adm>e 
PRINT ALLOW TABLE B 
PRESS HOLD 
adm 
EXCEPTION TABLES 
Allow Table B 
~- 
01 11 
07 
08 
Yo PRINT SPECIAL TABLE 1 
PRESS HOLD 
adm 
EXCEPTION TABLES 
SPECIAL TABLE 1 AREA CODE 
ALLOWED OFFICE CODES 
adrns 
PRINT SPECIAL TABLE 2 
PRESS HOLD 
adm 
EXCEPTION TABLES 
SPECIAL TABLE 2 AREA CODE 
ALLOWED OFFICE CODES 
admd 
PRINT SPECIAL TABLE 3 
PRESS HOLD 
adm 
EXCEPTION TABLES 
SPECIAL TABLE 3 AREA CODE 
ALLOWED OFFICE CODES 
admf 
PRINT SPECIAL TABLE 4 
PRESS HOLD 
adm 
EXCEPTION TABLES 
SPECIAL TABLE 4 HOME AREA CODE 
ALLOWED OFFICE CODES 
admxn 
exiting admin... 
Figure 670-4 DB Printout of Exception Tables 
670-l 0 
Issue 3, August 1991  
						

							Hybrid Key Telephone System sTARPLUS@ 2448EX 
7A MONITOR Eng. Ver. l.lf 
DATE: 07/24/91 TIME: 14:19:02 
ENTER PASSWORD: 
ab, 
ENTER PROGRAM NO 
adm>85 
PRINT SYS SPEED NO 
ENTER RANGE PRESS HOLD 
adn-02083 
SYSTEM SPEED NUMBERS 
20 
21 
22 
23 
24 
25 
26 
27 
28 
29 
30 
31 
32 
33 
34 
35 
36 
37 
38 
39 
40 
%21 
43 
44 
45 
46 
47 
48 
49 50 
51 
52 
53 
54 
55 
56 
57 
58 
59 
60 
61 
62 
63 
64 
65 
66 
67 
68 
69 
70 
71 
72 
73 
74 
75 
76 
77 
78 
79 
80 
81 
82 
83 
adm>m exiting admin... 
Figure 670-5 DB Printout of System Speed Numbers 
670-l 2 Issue 3, August 1991