Mitel SX-200 DIGITAL Pabx General Description Manual

							Features Description
Dial-In Tie Recall Point on No Answer -A Dial-In Tie call reaching an extension which does not answer
will be routed here. This is based on the destination tenant.
Dial-In Tie Routing for All Calls into this Tenant 
-All Dial-In Tie calls normally routed to extensions will be routed
here to allow screening of Dial-In Tie calls. This is based on the
destination tenant.
Dial-In Tie Intercept for Galls into this Tenant 
-A Dial-In Tie 
cali to an illegal number will be routed here. This
is based on the Tie trunks tenant.
Dial-In Tie Vacant Number Routing for this Tenant 
-A Dial-In Tie call to a vacant number will be routed here. This is
based on the Tie trunk’s tenant.
Dial-In Tie Attendant Access Night Points 
-A Dial-In Tie call to the attendant while this system is in NIGHT
service will be routed here. This is based on the Tie trunk’s
tenant.
Do Not Disturb Intercept Routing for this Tenant 
-An extension with Do Not Disturb activated will have its incom-
ing calls routed here. This is based on the extension’s tenant.
Automatic Wake-up Routing for this Tenant 
-All extensions (not 
SUPERSET qTM sets) answering a wakeup call
will be routed here. Normally this will be a recording group.
This is based on the extension’s tenant.
UCD Recording Routing for this Tenant -Incoming calls destined for UCD Agents are routed here when
all of the Agents are busy. This would normally be a recording
group. See UNIFORM CALL DISTRIBUTION.
UCD on Hold Time-out Routing for this Tenant -Incoming calls to busy UCD hunt groups which are not an-
swered after a pre-determined time-out period are routed here.
See UNIFORM CALL DISTRIBUTION.
DISA Day Service Routing for this Tenant -Direct Inward System Access (DISA) calls are routed here. This
is based on the 
DISA trunk’s tenant.
Station Vacant Number Routing for this Tenant 
-Any station dialing a vacant number will be routed here. This is
based on the extension’s tenant.
Station Illegal Number Routing for this Tenant 
-Any station dialing an 
illegal number will be routed here. This is
based on the extension’s tenant.
Page C-2/2 
						

							MITEL STANDARD PRACTICESECTION MITL9108-093-150-NAIssue 2, September 1986
SX-200” DIGITAL
PRIVATE 
AUTQMATIC BRANCH EXCHANGE (PABX)
ORDERCNG INFORMATION
\Copyright of MITEL Corporation 4986
TM 
- Trademark of MITEL Corporation
@Registered Trademark of 
MITEL Corporation
i 
						

							Ordering information
CONTENTSPAGE1. INTRODUCTION . . . . . . . . . . 
e . . . . . . . . . . . . . 0 . . 0 . . . . . . . l-l
ReasonforReissue. . . . O.e . . . . . . . . . Sun . . . . . . . . . ~.. l-l
2. ORDERING INFORMATION . . m . . . . . . . . . 
0 0.. 0 m. e 0 0. s s . . 2-l
Warranty . . . 
..=...m.V...m.O....a...D s....O.m m O..m 2-1
Spares Level D . . . . . . . . . . . . . . . . . . . . . . m . . . 
=. . . . . . 0 . . 2-l
TABLE
TITLEPAGE2-lBasic System Equipment 
- 336-Port
2-2
2-3
2-4
2-5
2-6
2-7
2-8
2-9
2-102-l 1Configuration 
D D . . . . m
 D *. -. . . . . Q -. . . . . . . . . . ~ 2-2
Expansion Kits
- 336-Port Configuration . . , . . . , . s , 2-2
Digital Peripheral Cards . . 
~ . . a . . . . . . . . s . . . . . . ~ . 2-3
Spares
- 336-Port Configuration . . . D . . . . . . , . . . . 0 2-3
Basic System Equipment 
- 489-Port Configuration . a 2-4
Expansion Kits
- 480-Port Configuration . . . . . . . . 0
 m 2-5
Upgrade Kit0 . . . m
 
e D . -. . . 0
 s 0 m. . =. = . *. . . . . . . . . 2-6
Analog Peripheral Cards 
n 0 Q
 m u D . . a m . . . . 0 . . . . . . a . 2-6
Spares
- 480-Port Configuration . . a . . . . D . . D a . . . . 2-7
Peripheral Equipment . . ~ 
~ ~. . . -. . a r . . . . . . . . ~ ~ . . 2-8
Documentation . m 
~ D 0
 m ~ m
 0 D D 0 D = m e = D
 m
 m m
 D D. . ~ . . ~ ~ 2-9 LIST OF TABLES 
						

							0,rdgring Information
1. INTRODUCTION
1 .OlThis Section contains the ordering information for the SX-200@DIGITAL Private Automatic Branch Exchange (PABX).
Reason for Reissue
1.02 This document is reissued to provide hardware and software
orderable 
part numbers for the SX-200@ DIGlTAL PABXs, with
Generic 1000 and Generic 1001 software. Both the 336-port fully digi-
tal configuration and the 
480-port configuration are described.
Page 
l-l/l 
						

							Ordering Information
2. ORDERING INFQRMATIDN
2.01The ordering information is divided into the following tables:
Table 2-l lists the components of the 336-port configuration.
Table 2-2 lists expansion kits for the 336-port configuration.
Table 2-3 lists all digital cards and modules required to com-
plete the customer requirements.
Table 2-4 lists spares for the 336-port configuration.
Table 2-5 lists the components of the 
480-port configuration.
Table 2-6 lists expansion kits for the 
480-port configuration.
Table 2-7 lists the upgrade kit.
Table 2-8 lists all analog cards required to complete the 
cus-
L tomer requirements.
Table 2-9 lists spares for the 
480-port configuration.
Table 
2-10 lists all peripheral equipment.
Table 2-11 lists the system documentation
Warranty
2.02 The MITEL 
SX-ZOO@ DIGITAL communications system is war-
ranted against defective material and workmanship. Equipment
requiring service or repair during the warranty period must be pack-
aged in accordance with Section 
MITL9108-093-ZOO-NA, Shipping, Re-
ceiving, and Installation Information, and returned prepaid to the sup-
plier. Repaired or replacement equipment is returned to the customer,
post prepaid by MITEL.
Spares Level
2.03 MITEL recommends that a minimum spares level of 10% of
installed systems, including 10% sparing of the basic system,
be maintained. The sparing recommended for the Memory Module is
5%. This means that service personnel can carry a complete spare
system on field trips, and therefore, if required, replace a complete
system.
Page 2-4 
						

							Ordering Information
TABLE 2-1
BASIC SYSTEM EQUIPMENT - 336-PORT CONFIGURATION
BlankRearDoorwithfans
336-Port Software
TABLE 2-2
Page 2-2 
						

							Ordering Information
TABLE 2-3
DIGITAL PERIPHERAL CARDS
Marketing Name
ONS Line Card (12 Circuit)
COV Line Card
OPS Line Card
LS/GS Trunk Card
DID Trunk
Universal Card
Receiver/Relay Module
9109-016-OOO-NAMusic On Hold/Pager Module
Console Module
E&M Trunk ModulePart Number
9109-OlO-OOO-NA
9 109-020-OOO-NA
9 109-040-OOO-NA
9109-Oil-OOO-NA
9109-031-OOO-NA
9109-005-OuO-NA
9109-018-OOO-NA
9 109-025-OOO-NA
9109-013-OOO-NAComments
for Rotary and DTMF sets
6 COV Circuits per card
6 OPS Circuits per card
6 CO Trunk Interfaces
6 DID Circuits per card
supports:
- E&M Trunk Module
- Music On Hold/Pager Module
- Receiver/Reiay Module
- Console Module
4 DTMF Receivers
2 General Purpose Relays
Music Input
Paging Preamp Output
Relay to control external amplifier
Console Interface
E&M Trunk Circuit per Module
TABLE 2-4
SPARES 
- 33%PORT CONFIGURATION
Marketing Name
Control Shelf AssemblyPart Number
9108-014-OOO-NAComments
Spare PCM Cable
Peripheral Bay Shelf
Assembly
9 109-050-OOO-NA9109-O 
15-OOO-NAPeripheral Bay Backplane
Assembly
9109-044-OOO-tiA
Spare Fan9109-032-OOO-NAReplacement Filter
9 109-037-OOO-NAFloppyDisk Drive Assembly
9109-124-OOO-NASpare Diskettes 
Gene& 1001
336-Port9109-034-OOO-NA 3 Floppy Diskettes
I .
Main Control Card
Bav ControlCard
9109-003-OOO-NA
9 109-O 17-OOO-NAPower Fail Transfer Card
) 9109-023-OOO-NA 16 Power Fail Transfer CircuitsIPage 2-3 
						

							Ordering Information
TABLE 2-5
BASIC SYSTEM EQUIPMENT - 480-PORT CONFiGURATIONBasic System
(Bay 1 
br 2)
Blank Rear Door
Main Control Card with DX and Memory
SX-ZOO@ DIGITAL Cabinet
SX-ZOO@ DIGITAL Power Supply
Control Shelf 
Cardfile and Backplane
Bay 3 Shelf and Backplane
BayPower Supply
Main ControlCard
Digital Interface Card
Peripheral Control Card
Scanner Card
1000 
Software
100 1480-PortSoftware
Page 2-4 
						

							Ordering Information
TABLE 2-6
EXPANSION KITS - 480-PORT CONFIGURATION
Bay 4 Shelf 
and Backplane
Digital Interface Card
Peripheral Control Card
Scanner Card
Bay 2-4 PCM Cable
Bay 4 Hardware Kit
Interconnect Card with Cables
r Card (12 PFT Circuits) and PFT
ddress/Data Cables Set
cuits)PFT Cables
Page 2-5 
						

							Ordering Information
TABLE 2-7UPGRARE KIT
rKit, lessSoftware
SX-ZOO@DIGITAL Power Supply
Bay Power Supply
Floppy Disk Drive
interconnect Card and Cables
Cutover Card (12 PFT Circuits)
Main Control Card with DX and Memory
Digital Interface Card
Peripheral Control Card
Universal Card
Console Module
Receiver/Relay Module
MOH/Paging Module
LCD Console
TABLE 2-8
PERIPHERAL CARDS
DID/TIE Trunk Card
Scanner Card (1200 BAUD)
91 -lO-104-OOO-MALine Card 
(a-station)9110-l IO-OOO-NA
CO Trunk Card
SUPERSET@ Line Card91 lo-410-OOO-NASUPERSET sTM and SUPERSEP qT’Page 2-6