HP Officejet Pro 8500 User Manual

							• Reduced-Size MultiMediaCard (RS-MMC), MMC Mobile, MMCmicro (requires adapter, soldseparately)
• xD-Picture Card
Memory card specifications267
 
						

							Appendix C
268Device specifications
 
						

							DRegulatory information
The device meets product requirements from regulatory agencies in your country/region.
This section contains the following topics:
•
FCC statement
•
VCCI (Class B) compliance statement for users in Japan
•
Notice to users in Japan about the power cord
•
Notice to users in Korea
•
Toxic and hazardous substance table
•
Notice to users of the U.S. telephone network: FCC requirements
•
Notice to users of the Canadian telephone network
•
Notice to users in the European Economic Area
•
Australia wired fax statement
•
Regulatory information for wireless products
•
Regulatory model number
•
Declaration of conformity
•
Environmental product stewardship program
•
Third-party licenses
Regulatory information269
 
						

							FCC statement
FCC statement
The United States Federal Communications Commission (in 47 CFR 15.105) has specified 
that the following notice be brought to the attention of users of this product. 
This equipment has been tested and found to comply with the limits for a Class B digital 
device, pursuant to Part 15 of the FCC Rules.  These limits are designed to provide reason-
able protection against harmful interference in a residential installation.  This equipment 
generates, uses and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio communications.  
However, there is no guarantee that interference will not occur in a particular installation.  
If this equipment does cause harmful interference to radio or television reception, which can 
be determined by turning the equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures:
 Reorient the receiving antenna.
  Increase the separation between the equipment and the receiver.
  Connect the equipment into an outlet on a circuit different from that to which the  receiver is connected.
  Consult the dealer or an experienced radio/TV technician for help.
For further information, contact: Manager of Corporate Product Regulations
Hewlett-Packard Company
3000 Hanover Street
Palo Alto, Ca 94304
(650) 857-1501
Modifications (part 15.21)
The FCC requires the user to be notified that any changes or modifications made to this 
device that are not expressly approved by HP may void the users authority to operate the 
equipment.
This device complies with Part 15 of the FCC Rules.  Operation is subject to the following 
two conditions:  (1) this device may not cause harmful interference, and (2) this device must 
accept any interference received, including interference that may cause undesired 
operation.
VCCI (Class B) compliance statement for users in Japan
Appendix D
270 Regulatory information
 
						

							Notice to users in Japan about the power cord
Notice to users in Korea
Toxic and hazardous substance table
Toxic and hazardous substance table 271
 
						

							Notice to users of the U.S. telephone network: FCC requirements
Notice to users of the U.S. telephone network: FCC requirements
This equipment complies with FCC rules, Part 68. On this equipment is a label that 
contains, among other information, the FCC Registration Number and Ringer Equivalent 
Number (REN) for this equipment. If requested, provide this information to your telephone 
company.
An FCC compliant telephone cord and modular plug is provided with this equipment. This 
equipment is designed to be connected to the telephone network or premises wiring using 
a compatible modular jack which is Part 68 compliant. This equipment connects to the 
telephone network through the following  standard network interface jack: USOC 
RJ-11C.
The REN is useful to determine the quantity of devices you may connect to your telephone 
line and still have all of those devices ring when your number is called. Too many devices 
on one line might result in failure to ring in response to an incoming call. In most, but not 
all, areas the sum of the RENs of all devices should not exceed five (5). To be certain of the 
number of devices you may connect to your line, as determined by the REN, you should call 
your local telephone company to determine the maximum REN for your calling area.
If this equipment causes harm to the telephone  network, your telephone company might 
discontinue your service temporarily. If possible, they will notify you in advance. If advance 
notice is not practical, you will be notified as soon as possible. You will also be advised of 
your right to file a complaint with the FCC. Your telephone company might make changes 
in its facilities, equipment, operations, or  procedures that could affect the proper operation 
of your equipment. If they do, you will be given advance notice so you will have the 
opportunity to maintain uninterrupted service. If you experience trouble with this equipment, 
please contact the manufacturer, or look elsewhere in this manual, for warranty or repair 
information. Your telephone company might ask you to disconnect this equipment from the 
network until the problem has been corrected  or until you are sure that the equipment is not 
malfunctioning.
This equipment may not be used on coin service provided by the telephone company.
Connection to party lines is subject to state tariffs. Contact your state public utility commis-
sion, public service commission, or corporation commission for more information.
This equipment includes automatic dialing capability. When programming and/or making 
test calls to emergency numbers:
 Remain on the line and explain to the dispatcher the reason for the call.
 Perform such activities in the off-peak hours, such as early morning or late evening .
  Note   The FCC hearing aid compatibility rules for telephones are not applicable 
to this equipment.
The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a 
computer or other electronic device, including fax machines, to send any message unless 
such message clearly contains in a margin at the top or bottom of each transmitted page 
or on the first page of transmission, the date and time it is sent and an identification of the 
business, other entity, or other individ ual sending the message and the telephone number 
of the sending machine or such business, other en tity, or individual. (The telephone number 
provided might not be a 900 number or any other number for which charges exceed local 
or long-distance transmission charges.) In order to program this information into your fax 
machine, you should complete the steps described in the software.
Appendix D
272 Regulatory information
 
						

							Notice to users of the Canadian telephone network
Note à l’attention des utilisateurs du réseau téléphonique 
canadien/Notice to users of the Canadian telephone network
Cet appareil est conforme aux spécifications techniques des équipements terminaux 
d’Industrie Canada. Le numéro d’enregistrement atteste de la conformité de l’appareil. 
L’abréviation IC qui précède le numéro d’enregistrement indique que l’enregistrement a été 
effectué dans le cadre d’une Déclaration de conformité stipulant que les spécifications 
techniques d’Industrie Canada ont été respectées. Néanmoins, cette abréviation ne signifie 
en aucun cas que l’appareil a été validé par Industrie Canada.
Pour leur propre sécurité, les utilisateurs doivent s’assurer que les prises électriques reliées 
à la terre de la source d’alimentation, des lignes téléphoniques et du circuit métallique 
d’alimentation en eau sont, le cas échéant, branchées les unes aux autres. Cette précaution 
est particulièrement importante dans les zones rurales.Remarque     Le numéro REN (Ringer Equivalence Number) attribué à chaque 
appareil terminal fournit une indication sur le nombre maximal de terminaux qui 
peuvent être connectés à une interface téléphonique. La terminaison d’une 
interface peut se composer de n’importe quelle combinaison d’appareils, à 
condition que le total des numéros REN ne dépasse pas 5.
Basé sur les résultats de tests FCC Partie 68, le numéro REN de ce produit est 0.0B.
This equipment meets the applicable Industry Canada Terminal Equipment Technical 
Specifications. This is confirmed by the registration number. The abbreviation IC before the 
registration number signifies that registration was performed based on a Declaration of 
Conformity indicating that Industry Canada technical specifications were met. It does not 
imply that Industry Canada approved the equipment.
Users should ensure for their own protection that the electrical ground connections of the 
power utility, telephone lines and internal metallic water pipe system, if present, are 
connected together. This precaution might be particularly important in rural areas. Note    The REN (Ringer Equivalence Number) assigned to each terminal device 
provides an indication of the maximum number of terminals allowed to be 
connected to a telephone interface. The termination on an interface might consist 
of any combination of devices subject only to the requirement that the sum of the 
Ringer Equivalence Numbers of all the devices does not exceed 5. 
The REN for this product is 0.0B, based on FCC Part 68 test results.
Notice to users of the Canadian telephone network 273
 
						

							Notice to users in the European Economic Area
Notice to users in the European Economic Area
This product is designed to be connected to the analog Switched Telecommunication 
Networks (PSTN) of the European Economic Area (EEA) countries/regions.
Network compatibility depends on customer selected settings, which must be reset to use 
the equipment on a telephone network in a country/region other than where the product 
was purchased. Contact the vendor or Hewlett-Packard Company if additional product 
support is necessary.
This equipment has been certified by the manufacturer in accordance with Directive 
1999/5/EC (annex II) for Pan-European single-terminal connection to the public switched 
telephone network (PSTN). However, due to differences between the individual PSTNs 
provided in different countries, the approval does not, of itself, give an unconditional 
assurance of successful operation on every PSTN network termination point.
In the event of problems, you should contact your equipment supplier in the first instance.
This equipment is designed for DTMF tone dialing and loop disconnect dialing. In the 
unlikely event of problems with loop disconnect dialing, it is recommended to use this 
equipment only with the DTMF tone dial setting.
Australia wired fax statement
In Australia, the HP device must be connected to Telecommunication Network through a line 
cord which meets the requirements of the Technical Standard AS/ACIF S008.
Regulatory information for wireless products
This section contains the following regulatory information pertaining to wireless products:
•
Exposure to radio frequency radiation
•
Notice to users in Brazil
•
Notice to users in Canada
•
Notice to users in Taiwan
•
European Union regulatory notice
Appendix D
274
Regulatory information
 
						

							Exposure to radio frequency radiation
Exposure to radio frequency radiation
Caution  The radiated output power of this device is far below the FCC radio 
frequency exposure limits. Nevertheless, the device shall be used in such a manner 
that the potential for human contact during normal operation is minimized. This 
product and any attached external antenna, if supported, shall be placed in such 
a manner to minimize the potential for human contact during normal operation. In 
order to avoid the possibility of exceeding the FCC radio frequency exposure 
limits, human proximity to the antenna shall not be less than 20 cm (8 inches) 
during normal operation.
Notice to users in Brazil
Aviso aos usuários no Brasil
Este equipamento opera em caráter secundário, isto é, não tem direito à proteção 
contra interferência prejudicial, mesmo de estações do mesmo tipo, e não pode causar 
interferência a sistemas operando em caráter primário. (Res.ANATEL 282/2001).
Notice to users in Canada
Notice to users in Canada/Note à lattention des utilisateurs canadiens
For Indoor Use. This digital apparatus does not exceed the Class B limits for radio noise 
emissions from the digital apparatus set out in the Radio Interference Regulations of the 
Canadian Department of Communications. The internal wireless radio complies with RSS 
210 and RSS GEN of Industry Canada.
Utiliser à lintérieur. Le présent appareil numérique német pas de bruit radioélectrique 
dépassant les limites applicables aux appareils numériques de la classe B prescrites dans 
le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications 
du Canada. Le composant RF interne est conforme a la norme RSS-210 and RSS GEN 
dIndustrie Canada.
Regulatory information for wireless products 275
 
						

							Notice to users in Taiwan
Appendix D
276Regulatory information