Mitel Fax Memo Manual

							Software Release 6.OB Release Notes 
10  
						

							Tl/El 
SoftwareRelease6.OB ReleaseNotes 
SS7 ISUP IAM Messages Configuration Menu 
(A) IAM Nature of Connection Ind Satellite Indicator ? = [O 
(B) IAM Nature of Connection Ind Continuity Check Indicator 
LOI 1 
? = 
(Cl 
(D) 
(El 
(F) 
(G) 
(HI 
(1) 
(J) 
(K) 
(L) 
(Ml 
(N) 
(0) 
(PI 
(Q) 
(R) 
(Xl 
IAM Nature of Connection Ind Echo Control Indicator ? = [O] 
IAM Forward Call Ind Nat/Inter Call Ind ? = [O] 
IAM Forward call Ind End-to-End Method Ind ? = 101 
IAM Forward Call Ind Internetworking Ind ? = [O] 
IAM Forward Call Ind End-to-End Information Ind ? = [O] 
IAM Forward Call Ind ISDN User Part Ind ? = 
[ll 
IAM Forward Call Ind ISDN User Part Pref Ind ? = [O] 
IAM Forward Call Ind ISDN Access Ind ? = [l] 
IAM Forward Call Ind SCCP Method Ind ? = [O] 
IAM TX Med Requirements ? = [3] 
IAM CLD Party Num Nature of Address Ind ? = [ll 
IAM CLD Party Num Number Plan Ind ? = 11). 
IAM CLG Party Num Number Plan Ind ? = [l] 
IAM CLG Party Num Address Presentation Ind ? = 111 
IAM CLG Party Num Screen Ind ? = 131 
IAM CLG Party Num Nature of Address Ind ? = 
131 
Exit 
Release 6.OA supported only Common Channel Signaling (CCS) integrations over El and Channel Associated Signaling 
(CAS) integrations over Tl previous to this revision. Release 6.OB provides the flexibility to specify what type of 
signaling is being provided on each of the Tl/Bl trunks in the system. This permits SS7 support over Tl now and will 
support future channel associated signaling (for example, Mercury Subscriber Line) over Centigram El trunks. 
A new menu choice S-configure Signaling type-has been added to the Tl/El trunk configuration menu. This menu 
includes the following three choices: 
A CAS Signaling 
B CCS Signaling 
C none 
Feature Use 
By default, the system will configure Tl boards added by an administrator to contain two trunks each carrying CAS 
signaling. The administrator is only to specify which specific signaling protocol is being used on each of the lines. By 
the default the system will configure El boards added by an administrator to contain two trunks each carrying CCS 
signaling (SS7). This default behavior is the same as previous loads. 
The new menu is utilized only if a Tl board is to be used by an SS7 integration or, in the future, when an El board is 
used for integrations such as R2. The selections apply to the following conditions 
l A-the lines on the trunk are using channel associated signaling (for example, loop 
start, E&M, R2). 
l B-the lines on the trunk are controlled by a common channel signaliug integration 
(SS7) and the trunk carries an SS7 link in one of the timeslots (timeslot 24 for Tl, 
timeslot 16 for El). 
l C-the lines on the trunk are controlled by a common channel signaling integration 
(SS7) and the trunk does not carry an SS7 link in one of the timeslots (all 24 timeslots 
11  
						

							Software Release 6.OB Release Notes 
on the Tl trunks are being used as VoiceMemo lines controlled by one or more SS7 
links present on other trunks). 
UI/ESMDI Integration 
For UIESMDI integration, configure message waiting delay in the UI menu. From the UI menu, enter (P) Define PBX 
Groups, (P) PBX Features, (L) Message Waiting Request Interval. 
Valid interval range for message waiting delay is 0 - 1000 ms (0 - 1 set). 
UIMAP Utility 
A new UIMAP utility for merging multiple systems to a single 6.00 system and changing mapping information has been 
added. 
Note: For 5.0X to 6.0 conversions in which two or more 5.0X systems are being 
merged into one 6.0 system, the Conversion utility mentioned in the following 
section must be run after each Phase II conversion from a 5.0X system. This 
builds the new UI database incrementally. e 
UI Mailbox Mappings 
A conversion utility has been added to Unified Integration mailbox mapping. 
Conversion Utility 
(S) Save Mappings 
(R) Restore Mappings 
(X) Exit 
COMMAND (S/R/X): 
When the userenters S,thefollowingmessageappears: 
WARNING: To execute this action may keep the 
System 
OUT OF SERVICE for several minutes! 
Enter a file name to save mappings or RETURN to quit: 
If the user enters a file name, the utility saves all the mappings in the oaa records to that file. The file will be stored in 
/usr/vm/map directory. This file is needed later to restore mappings to oaa records. 
When user enter R, the following message appears: 
- WARNING: To execute this action may keep the system 
OUT OF SERVICE for several minutes! 
Enter a file name to restore mappings or RETURN to quit: 
If the user enters a file name, the utility will prompt the user with the following message: 
Enter a PBX number to modify or RETURN to no change: 
The utility will read the file and restore mappings in oaa records and memory. 
Note: 
l 
While running, this utility will not be interrupted by control C. 
12  
						

							Software Release 6.OB Release Notes 
l The utility first checks if uimap is running on the system. It starts uimap if it is 
not running and terminates uimap when exiting this utility. 
0 If there is any errors while saving or restoring mappings, this utility will print 
error messages and terminate. 
Unified TCP/IP Installation 
The installation for the Unified TCP/IP product requires that the user insert the setup floppy twice, once at the normal 
time and once after removing Disk 1 of this optional feature. The user is prompted to follow this procedure by the 
installation software. If this step is ignored, reinstallation of the software will be needed. Note also that Unified TCPLIP 
requires a reboot of the system after installation and activation. 
13  
						

							Software Release 6.OB Release Notes 
From the SYSTEM MAINTE 
NANCE - Additional Options Menu, enter a to add optional features. Follow the 
instrnctions that appear on the screen. The text that follows shows the messages that appear (bold lettering added): 
Now installing Unified TCP/IP... 
The software package will be installed from drive: /dev/fdO 
vol: When drive light goes out insert disk 1 and press return 
vol: 
volume 1 created 27/Jan/96-14:25 by root, 687296 bytes 
used on /dev/fdO 
Restoration complete. 
When drive light goes out, 
insert SETUP diskette again and 
press return 9 
Installing TCP/IP protocol stack... 
WARNING: the Unified TCP/IP records are going to be 
initialized! ! 
Type CONTINUE to continue this process. Or, if.you already 
have the Unified 
TCP/IP installed, please press ENTER to keep your current 
configuration. 
CONTINUE 
Initializing Unified TCP/IP records........done! 
cp: 
Can’t open source file. (/usr/vm/config/tcp.init) 
cp: 
Cant open source file. (/usr/vm/config/tcp.init.O) 
cp: 
Cant open source file. (/usr/vm/config/tcp.host) 
14 cp: 
Cant open source file. (/Usr/vm/config/tcp.host.O) 
[Note: The error messages shown above do not affect the successful installation of 
the Unified TCP/lP software.]  
						

							Software Release 6.OB Release Notes 
/usr/vm/config/tcp.host: No such file or directory 
Unified TCP/IP Optional Feature is now installed.... 
Do 
you want to install another Optional Feature [Y/N] ? N 
OFFLINE MENU: configuration 1. 
Currently active configuration is: 1. 
Reading configuration records... 
Checking consistency between hardware configuration and OAA... 
Writing new configuration report to 
/usr/vm/config/vm.report.l... 9 
Writing new configuration commands to 
/usr/vm/config/vm.cmd.l... 
TCPIP: writing /usr/vm/config/tcp.init.l . . . . . 
TCPIP: writing /usr/vm/config/tcp.host.l . . . . . 
WARNING : ACTIVATE CONFIGURATION to enable changes ! 
15  
						

							Software Release 6.OB Release Notes 
Known Problem 
This section describes a known problem in Release 6.OB. 
Originate/Answer Link Conventions In Mesa-Net 
In certain configurations, after an activation of configuration or reboot, MESA-Net link assignments changed to earlier or 
incorrect originate/answer assignments. Link and Port assignment may now be set to configurations other than 
Centigram conventions for originate links as odd numbers and answer links as even numbers. For ease of service and 
support, Centigram recommends that the orig=odd, ans=even assignments remain as the convention for link/port 
assignment. 
16  
						

							Issue 1 Release 2.0 January 1996 
1 Voice Processing Solutions 1 
TU, @ - Trademark of Mite1 Corporation 
0 Copyright 1996, Mite1 Corporation 
All rights reserved. 
Printed in Canada. 
System 
Description ‘.  
						

							0 1996 Centigram Communications Corporation. All rights reserved. 
This publication is protected by federal copyright law. No part of this 
publication may be copied or distributed, stored in a retrieval system, or 
translated into any human or computer language in any form or by any means 
electronic, mechanical, magnetic, manual or otherwise, or disclosed to third 
parties without the express written permission of Centigram Communications 
Corporation, 91 East Tasman Drive, San Jose, CA 95134. 
REPRODUCTION 
Licensed users and authorized distributors of Centigram products may cozy 
this document for use with Centigram products provided that the copyright 
notice above is included in all reproductions. 
PROPRIETARY TERMS 
The following are trademarks of Centigram Communications Corporation: 
AIP, CallText, Centigram, PROSE, Speaklt, SpeechPlus, SPEECH+, 
TruVoice, VGS, VoiceMemo 
PROSE 2000 Version 1 01992 Centigram Communications Corporation. _ 
All other brand and product names are claimed or registered marks of their 
respective companies. I 
NOTICE 
The information contained in this document is believed to be accurate in all 
respects but is not warranted by Mite1 Corporation (MITEL@).The information 
is subject to change without notice and should not be construed in any way 
as a commitment by Mite1 or any of its affiliates or subsidiaries. Mite1 and its 
affiliates and subsidiaries assume no responsibility for any errors or omissions 
in this document. Revisions of this document or new editions of it may be 
issued to incorporate such changes. 
--