DELL 2155cdn User Manual
Have a look at the manual DELL 2155cdn User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 327 Dell manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Understanding the Printer Menus489 IP Filter NOTE: IP Filter feature is available only for LPD or Port9100. Purpose: To block data received from certain IP addresses through the wired or wireless network. You can set up to five IP addresses. The change becomes effective after the printer is turned off and then on again. Va l u e s : IEEE 802.1x NOTE: IEEE 802.1x feature is available only when the printer is connected using LAN cable and it is available only when the IEEE 802.1 authentication is enabled. Purpose: To disable IEEE 802.1x authentication. The change becomes effective after the printer is turned off and then on again. Va l u e s : Reset LAN Purpose: To initialize wired network data stored in non-volatile memory (NVM). After executing this function and rebooting the printer, all wired network settings are reset to their default values. Va l u e s : HTTP-SSL/TLS DisableDisables HTTP-SSL/TLS. Enable *Enables HTTP-SSL/TLS. No. n / Address (n is 1–5.)Sets the IP address for Filter n. No. n / Mask (n is 1–5.)Sets the address mask for Filter n. No. n / Mode (n is 1–5.) Off *Disables the IP Filter feature for Filter n. AcceptAccepts an access from the specified IP address. RejectRejects an access from the specified IP address. DisableDisables IEEE 802.1x.
490Understanding the Printer Menus Fax Settings Use the Fax Settings menu to configure the basic fax settings. NOTE: Values marked by an asterisk (*) are the factory default menu settings. Receive Mode Purpose: To select the default fax receiving mode. Va l u e s : Auto Rec Fax Purpose: Ye sInitializes the wired network data stored in NVM. No *Does not initialize the wired network data stored in NVM. TelephoneAutomatic fax reception is turned off. You can receive a fax by picking up the handset of the external phone and then pressing the remote receive code, or by setting OnHook to On (you can hear voice or fax tones from the remote machine) and then pressing . Fax *Automatically receives faxes. Telephone/FaxWhen the printer receives an incoming fax, the external telephone rings for the time specified in Auto Rec Tel/Fax, and then the printer automatically receives a fax. If an incoming call is not a fax, the printer beeps from the internal speaker indicating that the call is a telephone call. Ans Machine/FaxThe printer can share a telephone line with an answering machine. In this mode, the printer will monitor the fax signal and pick up the line if there are fax tones. If the phone communication in your country is serial, this mode is not supported. DRPDBefore using the Distinctive Ring Pattern Detection (DRPD) option, a distinctive ring service must be installed on your telephone line by the telephone company. After the telephone company has provided a separate number for faxing with a distinctive ring pattern, configure the fax setup to monitor for that specific ring pattern.
Understanding the Printer Menus491 To set the interval at which the printer goes into the fax receive mode after receiving an incoming call. Va l u e s : Auto Rec Tel/Fax Purpose: To set the interval at which the printer goes into the fax receive mode after the external telephone receives an incoming call. Va l u e s : Auto Rec Ans/Fax Purpose: To set the interval at which the printer goes into the fax receive mode after the external answering machine receives an incoming call. Va l u e s : Line Monitor Purpose: To set the volume of the line monitor, which audibly monitors a transmission through the internal speaker until a connection is made. Va l u e s : 0*Sets the value in increments of 1 second. 0-255 6 *Sets the interval in increments of 1 second. 0-255 21 *Sets the interval in increments of 1 second. 0-255 OffTurns off the volume of the line monitor. LowSets the volume of the line monitor to Low.
492Understanding the Printer Menus Ring Tone Volume Purpose: To set the volume of the ring tone, which indicates that an incoming call is a telephone call through the internal speaker when Receive Mode is set to Telephone/Fax. Va l u e s : Line Type Purpose: To select the default line type. Va l u e s : Tone/Pulse Purpose: To select the dialing type. Va l u e s : Medium*Sets the volume of the line monitor to Medium. HighSets the volume of the line monitor to High. OffTurns off the volume of the ring tone. Low Sets the volume of the ring tone to Low. MediumSets the volume of the ring tone to Medium. High *Sets the volume of the ring tone to High. PSTN *Uses PSTN. PBXUses PBX. To n e *Uses tone dialing. Pulse (10PPS)Sets DP (10PPS) (Dial Pulse, 10 Pulse Per Second) as the dial type. Pulse (20PPS)Sets DP (20PPS) (Dial Pulse, 20 Pulse Per Second) as the dial type.
Understanding the Printer Menus493 Resend Delay Purpose: To specify the interval between re-send attempts. Va l u e s : Redial Attempts Purpose: To specify the number of redial attempts to make when the destination fax number is busy within the range of 0 to 13. If you enter 0, the printer will not redial. Va l u e s : Redial Delay Purpose: To specify the interval between redial attempts within the range of 1 to 15 minutes. Va l u e s : Junk Fax Setup Purpose: To reject unwanted faxes by accepting faxes only from the fax numbers registered in the Phone Book. Va l u e s : 8*Sets the interval in increments of 1 second. 3-255 3 *Sets the number of redial attempts in increments of 1. 0-13 1 *Sets the interval in increments of 1 minute. 1-15 Off *Does not reject faxes sent from unwanted numbers.
494Understanding the Printer Menus Remote Receive Purpose: To receive a fax by pressing a remote receive code on the external telephone after picking up the handset of the telephone. Va l u e s : Remote Rcv Tone Purpose: To specify the tone in two digits to start Remote Receive. Fax Header Purpose: To print the information of the sender on the header of the faxes. Va l u e s : NOTE: If United States is selected for the setting of Country, this option does not appear on the menu. The setting is fixed to On and cannot be changed. For information on the country setting, see Setting Your Country. Fax Header Name Purpose: To set the sender name to be printed on the header on faxes. Fax Number Purpose: OnRejects faxes sent from unwanted numbers. Off *Does not receive a fax by pressing a remote receive code on the external telephone. OnReceives a fax by pressing a remote receive code on the external telephone. OffDoes not print the sender s information on the header of faxes. On *Prints the senders information on the header of faxes.
Understanding the Printer Menus495 To set the fax number of the printer, which will be printed on the header of a fax message. NOTE: Ensure to specify Fax Number before using Junk Fax Setup. Fax Cover Page Purpose: To set whether to attach a cover page to faxes. Va l u e s : DRPD Pattern Purpose: To provide a separate number for faxing with a distinctive ring pattern. Va l u e s : Off*Does not attach a cover page to faxes. OnAttaches a cover page to faxes.
496Understanding the Printer Menus Pattern1–7DRPD is a service provided by some telephone companies. DRPD Patterns are specified by your telephone company. The patterns provided with your printer are shown below: Ask your telephone company which pattern you need to select to use this service. For example, Pattern 7 is the New Zealand FaxAbility distinctive ringing pattern: rings for 400 ms, stops for 800 ms, rings for 400 ms and stops for 1400 ms. This pattern is repeated over and over again. This printer only responds to Distinctive Alert cadence(s) DA4 in New Zealand. Pattern 1 Pattern 2 Pattern 3 Pattern 4 * Pattern 5 Pattern 6 Pattern 7
Understanding the Printer Menus497 Duplex Print NOTE: Duplex Print feature is available only for Dell 2155cdn Multifunction Color Printer. To set the duplex printing for fax. Va l u e s : Sent Fax Fwd Purpose: To set whether to forward incoming faxes to a specified destination. Va l u e s : Fax Fwd Number Purpose: To enter the fax number of the destination to which incoming faxes will be forwarded. Prefix Dial Purpose: To select whether to set a prefix dial number. Va l u e s : Off*Does not perform duplex printing. OnPerforms duplex printing. Off *Does not forward incoming faxes. ForwardForwards incoming faxes to a specified destination. Prints incoming faxes if an error occurs during the transfer. Print and ForwardPrints incoming faxes and also forwards them to a specified destination. Off *Does not set a prefix dial number. OnSets a prefix dial number.
498Understanding the Printer Menus Prefix Dial Num Purpose: To set a prefix dial number of up to five digits. This number dials before any auto dial number is started. It is useful for accessing the Private Automatic Branch Exchange (PABX). Discard Size Purpose: To set the printer to discard images or any text at the bottom of a fax page when the entire page does not fit the output paper. Va l u e s : ECM Purpose: To set whether to enable or disable the Error Correction Mode (ECM). To use the ECM, the remote machines must also support the ECM. Va l u e s : Modem Speed Purpose: To adjust the fax modem speed when a fax transmission or reception error occurs. Va l u e s : Off*Prints excess images or text at the bottom of a fax page without discarding it. OnDiscards any excess images or text. Auto ReductionAutomatically reduces a fax page to fit it onto the appropriate paper size. OffDisables the ECM. On *Enables the ECM. 2.4 Kbps