Konica Minolta magicolor 5670EN User Manual
Have a look at the manual Konica Minolta magicolor 5670EN User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 61 Konica manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Replacing Consumables 177 9Prepare a new transfer belt unit. Be careful not to touch the surface of the belt. Do not remove the blue lever. 10Insert the new remove all pack- ing tape from the transfer belt unit. 11Remove the protective cover from the transfer belt unit. 12Insert the new transfer belt unit along the rails. Downloaded From ManualsPrinter.com Manuals
Replacing Consumables 178 13From the right side cover side, tighten the screws to secure the transfer belt unit and then close the right side cover. 14Close the right side cover. 15Attach the left-side cover. Downloaded From ManualsPrinter.com Manuals
Replacing Consumables 179 16Tighten the four screws on the left side. 17Install the print unit and waste toner bottle. For details on installing the print unit or waste toner bottle, refer to “Replacing a Print Unit” on page 161 or “Replac- ing the Waste Toner Bot- tle” on page 167. 18Close the front cover. 19Reset the counter in the MAINTENANCE MENU/SUPPLIES/ REPLACE/TRANS. BELT menu. Downloaded From ManualsPrinter.com Manuals
Replacing Consumables 180 Replacing the Backup Battery When the backup battery is at its end of life, the printer’s date and time can- not be retained. Follow the procedure described below to replace the backup battery. Note Only use the coin-shaped 3V lithium battery CR2032. It’s very important to protect the printer controller board and any associated circuit boards from electrostatic damage. Before performing this procedure, review the antistatic caution on page 250. In addition, always handle circuit boards by the edges only. 1Turn off the printer and discon- nect the power cord and inter- face cables. 2Using a screwdriver, remove the screw. Then, slide the rear cover to the right and remove it. Downloaded From ManualsPrinter.com Manuals
Replacing Consumables 181 3Using a screwdriver, loosen the seven screws. (Do not remove them from the printer.) 4Slide the panel slightly to the right and lift it off the printer. 5Remove the hook, and then remove the backup battery. Downloaded From ManualsPrinter.com Manuals
Replacing Consumables 182 6Insert a new backup battery. When inserting the new backup battery, be sure that the + side faces toward the left. Note Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to your local regulations. Do not burn the backup battery. 7Reinstall the panel and tighten the seven screws. 8Attach the rear cover. 9Reconnect all interface cables. 10Reconnect the power cord, and turn on the printer. 11Use DATE on the SYS DEFAULT MENU/CLOCK menu to set the date, and use TIME on the SYS DEFAULT MENU/CLOCK menu to set the time. Downloaded From ManualsPrinter.com Manuals
Replacing Consumables 183 Replacing the Staple When there are no more staples, the message STAPLER EMPTY appears. Replace the staple cartridge. 1Open the stapler cover. 2Pull out the stapling unit. 3Pull out the stapler. Downloaded From ManualsPrinter.com Manuals
Replacing Consumables 184 4Remove the empty cartridge, and then insert the new one. 5Install the stapler. Downloaded From ManualsPrinter.com Manuals
Replacing Consumables 185 6Install the stapling unit. 7Close the stapler cover. Downloaded From ManualsPrinter.com Manuals
Replacing Consumables 186 Downloaded From ManualsPrinter.com Manuals