Konica Minolta magicolor 5670EN User Manual

							Duplexing 147
Duplexing
Select paper with high opacity for duplex (double-sided) printing. Opacity 
refers to how effectively paper blocks out what is written on the opposite side 
of the page. If the paper has low opacity (high translucency), then the printed 
data from one side of the page will show through to the other side. Check 
your application for margin information. For best results, print a small quantity 
to make sure the opacity is acceptable.
Duplex (double-sided) printing can be done manually or can be done auto-
matically with the duplex option installed and selected.
Note
Only plain paper, 60–90 g/m2 (16–24 lb bond) can be autoduplexed. See 
“Media Specifications” on page 108.
Duplexing envelopes, labels, letterhead, postcards, thick stock, glossy 
media or transparencies is not supported.
How do I autoduplex?
You should verify that the duplex option is physically installed on the printer to 
successfully duplex (double-sided) the job.
Check your application to determine how to set your margins for duplex 
(double-sided) printing.
The following Binding Position settings are available.
If “Short Edge” is selected, the pages will be laid out to flip 
at the top.
If “Long Edge” is selected, the pages will be laid out to flip 
at the side.
1
3
1
21
111
12
3
Downloaded From ManualsPrinter.com Manuals 
						

							Output Tray 148
In addition, if “N-up” has been set to “Booklet”, autoduplex printing is per-
formed.
The following Order settings are available when “Booklet” is selected.
1Load plain paper into the tray.
2From the printer driver, specify duplex (double-sided) printing (Layout tab 
in Windows).
3Click OK.
With autoduplexing, the back side is printed first, and then the front 
side is printed.
Output Tray
All printed media is output to the face-down output tray on top of the printer. 
This tray has a capacity of approximately 250 sheets (A4/Letter) of 80 g/m2 
(22 lb) paper. 
If the media is stacked too high in the output tray, your printer may 
experience media misfeeds, excessive media curl, or static buildup. 
Remove transparencies as soon as possible from the output tray to 
avoid static buildup.If “Left Binding” is selected, the pages can be folded as a 
left-bound booklet.
If “Right Binding” is selected, the pages can be folded as a 
right-bound booklet.
1
12
3
3
3
1 12
Downloaded From ManualsPrinter.com Manuals 
						

							Finishing 149
Finishing
When the optional staple finisher is installed, job separation, offset and staple 
printing can be performed. For the installation procedure, refer to “Staple Fin-
isher” on page 268. Settings can be specified for job separation, offset and 
staple printing by selecting 
JOB SEPARATION or FINISHING in PAPER 
MENU
.
Use the following paper with job separation, offset and staple printing.
Paper is fed to the main output tray with job separation, offset and sta-
ple printing.
Job Separation Printing
When paper is fed to the main output tray, the pages are fed out shifted as 
shown below.
When paper is fed to the sub output tray, the pages are fed out 
stacked on top of each other without begin shifted.
If staple printing is selected, the pages are stapled together before 
being fed out.Media TypesPlain paper, Recycled paper and Letterhead 
(changes according to the paper thickness)
Media SizeWidth: 182 to 216 mm
Length: 257 to 355.6 mm
214321
321
321
Downloaded From ManualsPrinter.com Manuals 
						

							Finishing 150
Offset Printing
If offset printing is selected, the paper is fed out shifted as shown below.
When PAPER MENU/COLLATE is set to ON, the pages are fed out 
in sets as shown below.
Staple printing
Pages are stapled and fed out by job or by copy set as shown below.
Page in the portrait orientation are stapled in the upper-left corner.
The copies can be stapled when they contain 2 to 30 pages (3 to 60 
pages when double-sided).
If staple printing is selected when COLLATE is set to ON, the pages 
are stapled before being fed out. If staple printing is selected when 
COLLATE is set to OFF, the pages are not stapled before being fed 
out (except when only one copy is being printed).
When copies are stapled, they are not fed out shifted as with offset 
printing or job separation printing. Instead, they are fed out at the 
same position. - When 
COLLATE is set to ON- When COLLATE is set to OFF
321321
321
333222
111
1
Downloaded From ManualsPrinter.com Manuals 
						

							Media Storage 151
Media Storage
How do I store media?
„Keep media on a flat, level surface in its original wrapper until it is time to
load it.
Media that has been stored for a long time out of its packaging may dry up 
too much and cause misfeeding.
„If media has been removed from its wrapper, place it in its original pack-
aging and store in a cool, dark place on a level surface.
„Avoid moisture, excessive humidity, direct sunlight, excessive heat (above 
35°C [95°F]), and dust.
„Avoid leaning media against other objects or placing it in an upright posi-
tion.
Before using stored media, do a trial print to check print quality. 
Downloaded From ManualsPrinter.com Manuals 
						

							Media Storage 152
Downloaded From ManualsPrinter.com Manuals 
						

							Replacing
Consumables
Downloaded From ManualsPrinter.com Manuals 
						

							Replacing Consumables 154
Replacing Consumables
Note
Failure to follow instructions as outlined in this manual could result in 
voiding your warranty.
Note
If an error message (TONER OUT, TRANS.BELT END OF LIFE, etc.) 
appears, print out the configuration page, and then check the status of the 
other consumables. For details on the error messages, refer to “Error 
Messages (Warning:)” on page 238. For details on printing the 
configuration page, refer to “Printing a Configuration Page” on page 198.
About Toner Cartridges
Your printer uses four toner cartridges: black, yellow, magenta, and cyan. 
Handle the toner cartridges carefully to avoid spilling toner inside the printer 
or on yourself.
Install only new toner cartridges in your printer. If a used toner car-
tridge is installed, the indicator message will not clear and the supplies 
status in the Status Monitor will not be updated.
The toner is nontoxic. If you get toner on your skin, wash it off with 
cool water and a mild soap. If you get toner on your clothes, lightly 
dust them off as best as you can. If some toner remains on your 
clothes, use cool, not hot water, to rinse the toner off.
CAUTION
If you get toner in your eyes, wash it out immediately with cool water 
and consult a doctor. 
Refer to the following URL for recycling information. 
US: printer.konicaminolta.net/products/recycle/index.asp 
Europe: http://cleanplanet-printer.konicaminoltaeurope.com/
cleanplanet/choose.php
Other regions: printer.konicaminolta.com
Downloaded From ManualsPrinter.com Manuals 
						

							Replacing Consumables 155
Note
Do not use refilled toner cartridges or unapproved toner cartridges. Any 
damage to the printer or quality problems caused by a refilled toner 
cartridge or an unapproved toner cartridge will void your warranty. No 
technical support is provided to recover from these problems.
When replacing a toner cartridge, refer to the following table. For optimum 
print quality and performance, use only approved KONICA MINOLTA toner 
cartridges for your specific printer type, as listed in the table below. You can 
find your printer type and the toner cartridge part numbers on the consum-
ables reorder label inside the front cover your printer.
Printer 
Ty p ePrinter Parts 
NumberToner Cartridge Type Toner Cartridge 
Parts Number
AMA0EA 011
A0EA 012 Standard-Capacity Toner Cartridge -Black (K) A06V 132
Standard-Capacity Toner Cartridge -Yellow (Y) A06V 232
Standard-Capacity Toner Cartridge -Magenta (M) A06V 332
Standard-Capacity Toner Cartridge -Cyan (C) A06V 432
High-Capacity Toner Cartridge -Black (K) A06V 133
High-Capacity Toner Cartridge -Yellow (Y) A06V 233
High-Capacity Toner Cartridge -Magenta (M) A06V 333
High-Capacity Toner Cartridge -Cyan (C) A06V 433
EUA0EA 021
A0EA 022Standard-Capacity Toner Cartridge -Black (K) A06V 152
Standard-Capacity Toner Cartridge -Yellow (Y) A06V 252
Standard-Capacity Toner Cartridge -Magenta (M) A06V 352
Standard-Capacity Toner Cartridge -Cyan (C) A06V 452
High-Capacity Toner Cartridge -Black (K) A06V 153
High-Capacity Toner Cartridge -Yellow (Y) A06V 253
High-Capacity Toner Cartridge -Magenta (M) A06V 353
High-Capacity Toner Cartridge -Cyan (C) A06V 453
APA0EA 041
A0EA 042Standard-Capacity Toner Cartridge -Black (K) A06V 192
Standard-Capacity Toner Cartridge -Yellow (Y) A06V 292
Standard-Capacity Toner Cartridge -Magenta (M) A06V 392
Standard-Capacity Toner Cartridge -Cyan (C) A06V 492
High-Capacity Toner Cartridge -Black (K) A06V 193
High-Capacity Toner Cartridge -Yellow (Y) A06V 293
High-Capacity Toner Cartridge -Magenta (M) A06V 393
High-Capacity Toner Cartridge -Cyan (C) A06V 493
GCA0EA 081
A0EA 082Standard-Capacity Toner Cartridge -Black (K) A06V 182
Standard-Capacity Toner Cartridge -Yellow (Y) A06V 282
Standard-Capacity Toner Cartridge -Magenta (M) A06V 382
Standard-Capacity Toner Cartridge -Cyan (C) A06V 482
High-Capacity Toner Cartridge -Black (K) A06V 183
High-Capacity Toner Cartridge -Yellow (Y) A06V 283
High-Capacity Toner Cartridge -Magenta (M) A06V 383
High-Capacity Toner Cartridge -Cyan (C) A06V 483
Downloaded From ManualsPrinter.com Manuals 
						

							Replacing Consumables 156
For optimum print quality and performance, use only the corre-
sponded TYPE genuine KONICA MINOLTA toner cartridges.
Keep toner cartridges: 
„In their packaging until you’re ready to install them.
„In a cool, dry location away from sunlight (due to heat). 
The maximum storage temperature is 35°C (95°F) and the maximum 
storage humidity is 85% (noncondensing). If the toner cartridge is moved 
from a cold place to a warm, humid place, condensation may occur, 
degrading print quality. Allow the toner to adapt to the environment for 
about one hour before use.
„Level during handling and storage. 
Do not hold, stand or store cartridges on their ends or turn them upside 
down; the toner inside the cartridges may become caked or unequally 
distributed.
„Away from salty air and corrosive gases such as aerosols.
Y
Downloaded From ManualsPrinter.com Manuals