compaq contura 400 family User Manual
Have a look at the manual compaq contura 400 family User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 65 Compaq manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
![Page 229
8. Disconnect the display ground cable [1] from the LIF clip
(Figure 3-172).](http://img.usermanuals.tech/thumb/1258/38919/w64_compaq-contura-400-family-228.png "Page 229
8. Disconnect the display ground cable [1] from the LIF clip
(Figure 3-172).")
11. Lift the display assembly off the system unit module (Figure 3-174).
12. Position the display assembly top-side up. 13. Remove the display bezel (Section 3.25). 14. Remove the display latches and springs (Section 3.25). 15. Remove the inverter board (Section 3.21). >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
placement can cause severe damage to the unit. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
21. Replace the display ground cable, the LCD panel, the shield, and the display cable into the display enclosure as follows: - If replacing a Monochrome panel and shield, refer to Section 3.22. - If removing a CSTN (9.5 in) panel and shield, refer to Section 3.23. - If removing a CTFT (8.4 in) panel and shield, refer to Section 3.24. - If removing a CSTN (10.4 in) panel and shield, refer to Section 3.26. - If removing a CTFT (10.4 in) panel and shield, refer to Section 3.27. 22. Connect the display cable and backlight cable to the inverter board (Section 3.25). 23. Replace the inverter board (Section 3.25). 24. Replace the display latches and springs (Section 3.25). 25. Replace the bezel (Section 3.25). 26. Position the display clutches at a 90-degree angle (Figure 3-177).
27. Align the clutches with the system unit module, ensuring that the display ground cable and the display cable are positioned on top of the system unit module (Figure 3-178).
28. Replace the four rear clutch screws (Figure 3-179).
29. Open the display to a 90-degree angle (Figure 3-180).
30. Connect the display ground cable [1] to the LIF clip above the serial port connector between the system board and the system chassis (Figure 3-181).
31. Carefully insert the end of the cable into the ZIF connector slide on the system unit. IMPORTANT: Ensure that the ZIF connector slide is in its fully upward position and that it remains so while you are inserting the cable into it. Before closing the slide, ensure that the cable is fully seated (to the white insertion line) in the ZIF connector. 32. While holding the end of the display cable inside the ZIF connector slide, press down both ends of the slide simultaneously to secure the cable in the ZIF connector (Figure 3-182).
33. Ensure that the cable has been seated evenly and that the white line on the cable is level. 34. Replace the right clutch ground clip located between the clutch and the CPU base. The right clutch clip for Models 420 and 430 is different and is illustrated in the insert Figure 3-183).