compaq contura 400 family User Manual
Have a look at the manual compaq contura 400 family User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 65 Compaq manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
12. Carefully remove the Monochrome LCD panel, display cable, and shield from the display enclosure (Figure 3-90).
13. Lay the Monochrome LCD panel face down on a clean surface. 14. Grasp the sides of the shield near the backlight cable. Flex the shield away from the Monochrome LCD panel. Ensure that the shield tabs and finger grips clear the LCD panel (Figure 3-91).
17. Lift the display ground cable out of the display enclosure (Figure 3-93).
Replacing the Display Ground Cable, the Display Cable, the Shield, and the Monochrome Panel To replace the display ground cable, the display cable, the shield, and the Monochrome LCD panel, follow these steps: >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
2. Replace the display cable on the monochrome LCD panel by carefully inserting the end of the display cable into the ZIF connector slide on the LCD panel (Figure 3-95). IMPORTANT: Ensure that the ZIF connector slide is in its fully upward position and that it remains so while you are inserting the cable into it. Before closing the slide, ensure that the cable is fully seated in the ZIF connector. 3. While holding the end of the display cable inside the ZIF connector slide, press down both ends of the slide simultaneously to secure the cable in the ZIF connector (Figure 3-95).
5. Place the shield tabs in the indentations on the right side of the Monochrome LCD panel (Figure 3-97).
6. Align the Monochrome LCD panel, shield, and cable in the display enclosure and replace the screws. Ensure that the ZIF connector end of the display cable and the end of the display ground cable are exposed at the bottom of the display enclosure (Figure 3-98).
7. Connect the display cable and the backlight cable to the inverter board (Section 3.21). 8. Replace the inverter board (Section 3.21). 9. Replace the bezel (Section 3.21). 10. Connect the display ground cable [1] to the LIF clip above the serial port connector (Figure 3-99). 11. Carefully insert the end of the display ground cable into the ZIF connector slide on the system board (Figure 3-99). IMPORTANT: Ensure that the ZIF connector slide is in its fully upward position and that it remains so while you are inserting the cable into it. Before closing the slide, ensure that the cable is fully seated (to the white insertion line) in the ZIF connector.