compaq contura 400 family User Manual
Have a look at the manual compaq contura 400 family User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 65 Compaq manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
14. Lay the CSTN (10.4 inch) panel face down on a clean surface. 15. Slide the display shield off the CSTN panel (Figure 3-146).
16. Only Sharp panels require the XOVER Board. Remove the ground wire connecting the XOVER Board with the CSTN (10.4 inch) Panel (Figure 3-147).
17. Disconnect the display cable from the connector on the back of the CSTN (10.4 inch) panel (Figure 3-148).
17. Lift the display ground cable out of the display enclosure (Figure 3-149).
Replacing the Display Ground Cable, Display Cable, Shield, and the CSTN (10.4 inch) Panel To replace the display ground cable, display cable, shield, and the CSTN (10.4 inch) panel, follow these steps:
1. Position the display ground cable in the display enclosure, aligning the cable with the bosses in the display enclosure (Figure 3-151). 2. If the CSTN panel is manufactured by Sharp complete this step. If not, continue to step 4. Connect the display cable to the XOVER Board. Then connect the XOVER Board to the connector on the back of the CSTN (10.4 in) panel. Attach the ground wire of the XOVER Board to the display panel as indicated in (Figure 3-151).
3. If the CSTN panel is manufactured by Sharp complete this step. If not, continue to the next step. Peel off the adhesive from the back of the rubber pad found in the spare kit. Place this pad on the display enclosure indicated by the embossed area (Figure 3-152).
4. Slightly lift the tabs on the left side of the display shield and slide the shield onto the CSTN (10.4 inch) panel. Ensure that the LIF connector end of the display cable is exposed on the right side of the CSTN (10.4 inch) panel (Figure 3-153).
5. Place the display shield tabs in the indentations on the sides of the CSTN (10.4 in) panel (Figure 3-154).
6. Align the CSTN (10.4 inch) panel, display cable, and shield in the display enclosure and replace the screws. Ensure that the ZIF connector end of the display cable and the end of the display ground cable are exposed at the bottom of the display enclosure (Figure 3-155).