compaq contura 400 family User Manual
Have a look at the manual compaq contura 400 family User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 65 Compaq manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
17. Lift the display ground cable out of the display enclosure (Figure 3-109).
Replacing the Display Ground Cable, Display Cable, Shield, and the CSTN (9.5 inch) Panel To replace the display ground cable, the display cable, the shield, and the CSTN (9.5 inch) panel, follow these steps: 1. Position the display ground cable in the display enclosure, aligning the cable with the bosses in the display enclosure (Figure 3-110).
2. Connect the display cable to the connector on the back of the CSTN (9.5 inch) panel (Figure 3-111).
3. Slightly lift the tabs on the left side of the display shield and slide the shield onto the CSTN (9.5 inch) panel. Ensure that the LIF connector end of the display cable is exposed on the right side of the CSTN (9.5 inch) panel (Figure 3-112).
4. Place the display shield tabs in the indentations on the sides of the CSTN (9.5 inch) panel (Figure 3-113).
5. Align the CSTN (9.5 inch) panel, display cable, and shield in the display enclosure and replace the screws. Ensure that the ZIF connector end of the display cable and the end of the display ground cable are exposed at the bottom of the display enclosure (Figure 3-114).
6. Connect the display cable and the backlight cable to the inverter board (Section 3.23). 7. Replace the inverter board (Section 3.23). 8. Replace the bezel (Section 3.23). 9. Connect the display ground cable [1] from the LIF clip above the serial port connector (Figure 3-115).
10. Carefully insert the end of the display cable into the ZIF connector slide on the system board. IMPORTANT: Ensure that the ZIF connector slide is in its fully upward position and that it remains so while you are inserting the cable into it. Before closing the slide, ensure that the cable is fully seated (to the white insertion line) in the ZIF connector. 11. While holding the end of the display cable inside the ZIF connector slide, press down both ends of the slide simultaneously to secure the cable in the ZIF connector (Figure 3-116).
12. Ensure that the cable has been seated evenly and that the white line on the cable is level. 13. Replace the keyboard assembly (Section 3.7). Chapter 3.24 Color TFT (8.4 inch) Display (Models 400 and 410) IMPORTANT: The Monochrome, CSTN and the CTFT displays have different removal and replacement procedures. Be sure to follow the procedures for the specific display. This sections contains removal and replacement procedures for the following color CTFT (8.4 inch) display components: o Display panel o Display cable o Shield o Display ground cable
Removing the CTFT (8.4 inch) Liquid Crystal Display Panel To remove the CTFT (8.4 inch) panel, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2). 2. Open the computer. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>>