compaq contura 400 family User Manual
Have a look at the manual compaq contura 400 family User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 65 Compaq manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
![Page 167
6. Connect the display cable and the backlight cable to the inverter board
(Section 3.23).
7. Replace the inverter board (Section 3.23).
8. Replace the bezel (Section 3.23).
9. Connect the display ground cable [1] from the LIF clip above the serial
port connector (Figure 3-115).](http://img.usermanuals.tech/thumb/1258/38919/w64_compaq-contura-400-family-166.png "Page 167
6. Connect the display cable and the backlight cable to the inverter board
(Section 3.23).
7. Replace the inverter board (Section 3.23).
8. Replace the bezel (Section 3.23).
9. Connect the display ground cable [1] from the LIF clip above the serial
port connector (Figure 3-115).")
5. Remove the inverter board (Section 3.21). 6. Remove the display cable and backlight cable from the inverter board (Section 3.21). >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
8. Carefully rotate the CTFT (8.4 inch) panel down and out of the display enclosure, laying the CTFT (8.4 inch) panel gently on the keyboard assembly (Figure 3-119).
9. Remove the display cable from the connector on the back of the panel by pulling the tabs at the back of the connector (Figure 3-120).
Replacing the CTFT (8.4 inch) Display Panel To replace the CTFT (8.4 inch) panel, follow these steps: 1. Connect the display cable to the connector on the back of the CTFT (8.4 inch) panel (Figure 3-121).
2. Position the CTFT (8.4 inch) panel into the display enclosure, ensuring that the ZIF connector end of the display cable is exposed on the right side of the CTFT (8.4 inch) panel (Figure 3-122).
3. Secure the CTFT (8.4 inch) panel with four screws to the display enclosure. Removing the CTFT (8.4 inch) Display Cable To remove the CTFT (8.4 inch) display cable, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2). 2. Open the computer. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
The ZIF connector and its attached cable can be damaged easily. Handle only the connector slide when disconnecting the ZIF connector. Never pull or twist the cable itself while it is seated in the ZIF connector. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
The ZIF connector and its attached cable can be damaged easily. Handle only the connector slide when disconnecting the ZIF connector. Never pull or twist the cable itself while it is seated in the ZIF connector. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
7. Ensure that the cable has been seated evenly and that the white line on the cable is level. 8. Replace the keyboard assembly (Section 3.7). Removing and Replacing the CTFT (8.4 inch) Display Shield To remove the CTFT (8.4 inch) display shield, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2). 2. Open the computer. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
4. Remove the inverter board (Section 3.21). 5. Remove the display cable and backlight cable from the inverter board (Section 3.21). >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>