compaq contura 400 family User Manual
Have a look at the manual compaq contura 400 family User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 65 Compaq manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
![Page 108
2. Install screws [1] and [2] on the system board before replacing the
remaining system board and battery contact screws for Models 400 and
410 (Figure 3-58) and for Models 420 and 430 (Figure 3-59).](http://img.usermanuals.tech/thumb/1258/38919/w64_compaq-contura-400-family-107.png "Page 108
2. Install screws [1] and [2] on the system board before replacing the
remaining system board and battery contact screws for Models 400 and
410 (Figure 3-58) and for Models 420 and 430 (Figure 3-59).")
rails are assembled properly into the PC Card Header. The rail goes under the edge of the header. Tighten the header screws from the bottom of the system board. Removing the PC Card (PCMCIA) Rails NOTE: The rails for the 400 and 410 models are not interchangeable with the rails for the 420 and 430 models. To remove the PC Card rails, follow these steps. 1. Remove the PC Card clips. Refer to Removing the PC Card Clip in this section. 2. Slide the rails out of the header (Figure 3-61). 3. To replace the PC Card rails, reverse the previous steps. The PC Card rails go under the edge of the Header. Chapter 3.17 PC Card (PCMCIA) Ejection Levers and Pin
This section contains removal and replacement procedures for the PC Card ejection levers and pin. To remove the PC Card ejection levers and pin, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2). 2. Remove the PC Card ejection lever pin from the system chassis (Figure 3-62). 3. Remove the top PC Card (PCMCIA) ejection lever (Figure 3-63).
4. Remove the bottom PC Card ejection lever from the boss on the CPU base (Figure 3-64)
5. To replace the PC Card ejection levers and pin, reverse the previous steps. Chapter 3.18 PC Card (PCMCIA) Doors and Springs This section contains removal and replacement procedures for the PC Card doors and springs. The top PC Card door and spring are located on the keyboard assembly and the bottom PC Card door and spring are located on the CPU base. Top PC Card Door and Spring To remove the top PC Card door and spring, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2). >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION
2. Install the PC Card door, making sure the spring is placed between the notch [1] and the rib [2] (Figure 3-67).
Bottom PC Card (PCMCIA) Door and Spring The bottom PC Card door and spring are located on the CPU base. To remove the bottom PC Card door and spring, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2). >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
To replace the bottom PC Card (PCMCIA) spring and door, follow these steps: 1. Install the PC Card spring on the door post, making sure the bent arm of the spring is placed against the rib on the PC Card door (Figure 3-69).
2. Install the PC Card door, making sure the spring is placed between the notch [1] and the rib [2] (Figure 3-70).