compaq contura 400 family User Manual
Have a look at the manual compaq contura 400 family User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 65 Compaq manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
7. Replace the battery pack and reconnect the AC power. Chapter 3.14 Diskette Drive (All Models) This section contains removal and replacement procedures for the following diskette drive components: o Diskette Drive o Diskette Drive Bracket o Diskette Drive Insulator Strip Removing the Diskette Drive To remove the diskette drive, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2). >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
Removing the Diskette Drive from the Diskette Drive Bracket 1. Remove the diskette drive from the system chassis. Refer to Removing the Diskette Drive in this section. 2. Remove the diskette drive from the bracket by removing the four screws from both sides of the bracket (Figure 3-44).
3. Separate the diskette drive from the bracket (Figure 3-45).
4. To replace the diskette drive into the bracket, reverse the previous steps. Applying the Diskette Drive Hook and Loop Fastener If installing a new diskette drive bracket, the hook and loop fastener must be attached to the bracket. To attach the hook and loop fastener, follow these steps: 1. Separate the new hook and loop fastener. 2. Remove the backing from the adhesive on the hook and loop fastener that is the opposite color of the hook and loop fastener attached to the keyboard assembly (for example, white to black or black to white). 3. Attach the new hook and loop fastener of the opposite color of the hook and loop fastener on the keyboard assembly to the tab on the diskette drive bracket (Figure 3-46).
Replacing the Diskette Drive To replace the diskette drive into the system chassis, follow these steps: >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
4. Reconnect the Diskette Drive Cable and reinstall the three screws. Chapter 3.15 The System Board (All Models) To remove the system board, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2). 2. Remove the hard drive (Section 3.5). 3. Remove the memory expansion board, if installed (Section 3.6). 4. On the rear of the computer, use a hex socket driver to remove the six screw locks (Figure 3-48). 5. Using a Torx-T8 driver, remove the two alignment screws from the docking base connector (Figure 3-48).
10. Disconnect the display cable from the system board by pulling up both ends of the ZIF connector slide simultaneously [1], carefully opening the slide [2] (Figure 3-49). 11. Lift the display cable out of the connector slide [3], being careful not to pull or twist the cable (Figure 3-49). 12. Disconnect the display ground cable [1] from the LIF clip above the serial port connector (Figure 3-50).