compaq contura 400 family User Manual
Have a look at the manual compaq contura 400 family User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 65 Compaq manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
9. To replace the display shield, reverse the previous steps. Removing and Replacing the Display Ground Cable To remove the display ground cable, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2). 2. Open the computer. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
5. Remove the display cable and backlight cable from the inverter board(Section 3.21). >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
11. To replace the display ground cable, reverse the previous steps. Chapter 3.25 Display Components (Models 420 and 430) This section contains removal and replacement procedures for the following display assembly components: o Bezel o Latches o Inverter board Removing and Replacing the Display Bezel To remove the display bezel, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2).
2. Open the computer. 3. Remove the four screws from the display bezel (Figure 3-129). 4. Separate the display bezel from the display assembly (Figure 3-130).
5. To replace the bezel, reverse the previous steps. Removing the Display Enclosure Latches and Springs To remove the display enclosure latches and springs from either side of the display enclosure, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2). 2. Open the computer. 3. Remove the display bezel. Refer to Removing and Replacing the Display Bezel in this section. 4. Hold the bottom of the latch near the spring. Flex the hook end of the display latch away from the display enclosure [1] (Figure 3-131). 5. Pull the display latch from the top, then out of the display enclosure [2] (Figure 3-131).
6. Remove the display latch spring from the latch (Figure 3-132).
Replacing the Display Enclosure Springs and Latches To replace the display springs and latches, follow these steps: 1. Hook the display latch spring on to the display latch [1] and place the display latch spring over the post in the display enclosure [2] (Figure 3-133).
2. Slide the display latch into place on either side of the display enclosure (Figure 3-134).
Removing the Display Inverter Board for the CSTN (10.4 inch) Display >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> WARNING >>>>>
location to avoid pinching during the reassembly process. Improper cable placement can cause severe damage to the unit. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>