compaq contura 400 family User Manual
Have a look at the manual compaq contura 400 family User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 65 Compaq manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
The ZIF connector and its attached cable can be damaged easily. Handle only the connector slide when disconnecting the ZIF connector. Never pull or twist the cable itself while it is seated in the ZIF connector. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
The ZIF connector and its attached cable can be damaged easily. Handle only the connector slide when disconnecting the ZIF connector. Never pull or twist the cable itself while it is seated in the ZIF connector. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
7. Ensure that the cable has been seated evenly and that the white line on the cable is level. 8. Replace the keyboard assembly (Section 3.7). Removing and Replacing the CTFT (10.4 inch) Display Shield To remove the CTFT (10.4 inch) display shield, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2). 2. Open the computer. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
4. Remove the inverter board (Section 3.25). 5. Remove the display cable and backlight cable from the inverter board (Section 3.25). >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
9. To replace the display shield, reverse the previous steps. Removing and Replacing the Display Ground Cable To remove the display ground cable, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2). 2. Open the computer. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
5. Remove the display cable and backlight cable from the inverter board(Section 3.25). >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
11. To replace the display ground cable, reverse the previous steps. Chapter 3.28 Display Enclosure This section provides replacement procedures for the display enclosure. Replacing the Display Enclosure To replace the display enclosure, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2). 2. Remove the handle brackets (Section 3.3). 3. Remove the tilt feet (Section 3.4). >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION
the display is opened. To prevent damage to the display and the computer, ensure that the display assembly is opened at a 90-degree angle. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
8. Disconnect the display ground cable [1] from the LIF clip (Figure 3-172).