compaq contura 400 family User Manual
Have a look at the manual compaq contura 400 family User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 65 Compaq manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
![Page 150
7. Connect the display cable and the backlight cable to the inverter board
(Section 3.21).
8. Replace the inverter board (Section 3.21).
9. Replace the bezel (Section 3.21).
10. Connect the display ground cable [1] to the LIF clip above the serial
port connector (Figure 3-99).
11. Carefully insert the end of the display ground cable into the ZIF
connector slide on the system board (Figure 3-99).
IMPORTANT: Ensure that the ZIF connector slide is in its fully upward
position and that it remains so while...](http://img.usermanuals.tech/thumb/1258/38919/w64_compaq-contura-400-family-149.png "Page 150
7. Connect the display cable and the backlight cable to the inverter board
(Section 3.21).
8. Replace the inverter board (Section 3.21).
9. Replace the bezel (Section 3.21).
10. Connect the display ground cable [1] to the LIF clip above the serial
port connector (Figure 3-99).
11. Carefully insert the end of the display ground cable into the ZIF
connector slide on the system board (Figure 3-99).
IMPORTANT: Ensure that the ZIF connector slide is in its fully upward
position and that it remains so while...")
![Page 154
6. Disconnect the display ground cable [1] from the LIF clip above the
serial port connector (Figure 3-102).](http://img.usermanuals.tech/thumb/1258/38919/w64_compaq-contura-400-family-153.png "Page 154
6. Disconnect the display ground cable [1] from the LIF clip above the
serial port connector (Figure 3-102).")
12. While holding the end of the display cable inside the ZIF connector slide, press down both ends of the slide simultaneously to secure the cable in the ZIF connector (Figure 3-100).
13. Ensure that the cable has been seated evenly and that the white line on the cable is level. 14. Replace the keyboard assembly (Section 3.7). Chapter 3.23 Color STN (9.5 inch) Display (Models 400 and 410) IMPORTANT: The Monochrome, CSTN and the CTFT displays have different removal and replacement procedures. Be sure to follow the procedures for the specific display. This sections contains removal and replacement procedures for the following CSTN (9.5 inch) display components: o Display panel o Shield o Display cable o Display ground cable
Removing the CSTN (9.5 inch) Panel, Shield, Display Cable, and the Display Ground Cable To remove the liquid crystal display CSTN (9.5 inch) panel, the shield, the display cable and the display ground cable, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2). 2. Open the computer. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>>
6. Disconnect the display ground cable [1] from the LIF clip above the serial port connector (Figure 3-102).
135-degrees (Figure 3-103). >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
12. Carefully remove the CSTN (9.5 inch) panel, display cable, and shield from the display enclosure (Figure 3-105).
14. Lay the CSTN (9.5 inch) panel face down on a clean surface. 15. Slide the display shield off the CSTN (9.5 inch) panel (Figure 3-107).
16. Disconnect the display cable from the connector on the back of the CSTN (9.5 inch) panel (Figure 3-108).