compaq contura 400 family User Manual
Have a look at the manual compaq contura 400 family User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 65 Compaq manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
![Page 117
2. Install the PC Card door, making sure the spring is placed between the
notch [1] and the rib [2] (Figure 3-67).](http://img.usermanuals.tech/thumb/1258/38919/w64_compaq-contura-400-family-116.png "Page 117
2. Install the PC Card door, making sure the spring is placed between the
notch [1] and the rib [2] (Figure 3-67).")
![Page 120
2. Install the PC Card door, making sure the spring is placed between the
notch [1] and the rib [2] (Figure 3-70).](http://img.usermanuals.tech/thumb/1258/38919/w64_compaq-contura-400-family-119.png "Page 120
2. Install the PC Card door, making sure the spring is placed between the
notch [1] and the rib [2] (Figure 3-70).")
Chapter 3.19 System Chassis (All Models) To remove the system chassis, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2). 2. Remove the handle bracket on either side of the computer (Section 3.3). 3. Remove the tilt feet on either side of the computer (Section 3.4). >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>
7. Remove the four clutch screws from the rear of the system unit module (Figure 3-71). 8. Remove the display assembly from the system unit module (Figure 3-72).
9. Slide the trough at the rear of the CPU base to the right, then lift up to remove (Figure 3-73).
10. Remove the system chassis by gently separating it from the CPU base and lifting out the system chassis (Figure 3-74).
11. To replace the system chassis, reverse the previous steps. Chapter 3.20 CPU Base (All Models) This section provides removal and replacement procedures for the following CPU base components: o Battery shield clip o Lock provision plate o Anti-skid pads Removing and Replacing the Battery Shield Clip To remove the battery shield clip, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2).
1. Peel off the top layer of one of the anti-skid pads to expose the adhesive. 2. With the adhesive-side down, place the anti-skid pad into the raised oval outline on the CPU base and the battery tray (Figure 3-77). Chapter 3.21 Display Assembly Components (Models 400 and 410) This section contains removal and replacement procedures for the following display assembly components: o Bezel o Latches o Inverter board Removing and Replacing the Display Bezel >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> WARNING
serious injury or damage to the equipment. >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
5. To replace the bezel, reverse the previous steps. Removing the Display Enclosure Latches and Springs To remove the display enclosure latches and springs from either side of the display enclosure, follow these steps: 1. Disconnect all power from the computer and remove the AC Adapter and battery pack (Section 3.2). 2. Open the computer. 3. Remove the display bezel. Refer to Removing and Replacing the Display Bezel in this section. 4. Hold the bottom of the latch near the spring. Flex the hook end of the display latch away from the display enclosure [1] (Figure 3-80). 5. Pull the display latch from the top, then out of the display enclosure [2] (Figure 3-80).