Xerox DocuPrint 4590 EPS User Manual

							Xerox 4590 EPS/4110 EPS User Guide
6-45
6. Problem Solving
3.Return lever 4b to the original position. 
4.Close the finisher right cover.
NOTE:A message will be displayed and the machine will not 
operate if the finisher right cover is even slightly open.
Paper jams at Z folding unit
The following explains how to remove jammed paper from inside 
the Z folding unit when this optional unit is installed in a finisher D 
(optional) or a booklet maker finisher (optional).
This section describes how to remedy paper jams that occur at the 
following locations: 
• Paper jams at lever 2a and knob 3a
• Paper jams at lever 2b and knob 2c
• Paper jams at knob 2c, levers 2e/2f and tri-fold output tray 2d
• Paper jams at tri-fold output tray 2d and lever 2g
• Paper jams at unit 4 and knob 4a
NOTE:Remedies differ according to the paper jam location. 
Follow the instructions displayed and remove the jammed paper.
Downloaded From ManualsPrinter.com Manuals 
						

							Xerox 4590 EPS/4110 EPS User Guide
6-46
6. Problem Solving
Paper jams at lever 2a and knob 3a
1.Make sure that the machine has stopped and then open the 
right cover on the light finisher. 
2.Move lever 2a up and turn knob 3a to the left. Remove the 
jammed paper. 
NOTE:If paper is torn, check for any torn pieces of paper inside 
the machine.
3.Return lever 2a to the original position. 
4.Close the finisher right cover.
NOTE:A message will be displayed and the machine will not 
operate if the staple finishers right cover is even slightly open.
Downloaded From ManualsPrinter.com Manuals 
						

							Xerox 4590 EPS/4110 EPS User Guide
6-47
6. Problem Solving
Paper jams at lever 2b and knob 2c
1.Make sure that the machine has stopped and then open the 
right cover on the light finisher. 
2.Move lever 2b, turn knob 2c to the right, and remove the 
jammed paper. 
NOTE:If paper is torn, check for any torn pieces of paper inside 
the machine.
3.Return lever 2b to the original position. 
4.Close the finisher right cover.
NOTE:A message will be displayed and the machine will not 
operate if the finisher right cover is even slightly open.
Downloaded From ManualsPrinter.com Manuals 
						

							Xerox 4590 EPS/4110 EPS User Guide
6-48
6. Problem Solving
Paper jams at knob 2c, levers 2e/2f and tri-fold output tray 2d
1.Make sure that the machine has stopped and then open the 
right cover on the light finisher. 
2.Pull out the tri-fold output tray 2d, swing lever 2e to the right, 
and remove the jammed paper.
NOTE:If paper is torn, check for any torn pieces of paper inside 
the machine.
Downloaded From ManualsPrinter.com Manuals 
						

							Xerox 4590 EPS/4110 EPS User Guide
6-49
6. Problem Solving
3.If you cannot remove the paper in Step 2, turn knob 2c to the 
right, then remove the jammed paper. 
NOTE:If paper is torn, check for any torn pieces of paper inside 
the machine.
4.Swing back the opened lever (2f or 2e), and push back the tri-
fold output tray 2d.
5.Close the finisher right cover.
NOTE:A message will be displayed and the machine will not 
operate if the finisher right cover is even slightly open.
Downloaded From ManualsPrinter.com Manuals 
						

							Xerox 4590 EPS/4110 EPS User Guide
6-50
6. Problem Solving
Paper jams at tri-fold output tray 2d and lever 2g
1.Make sure that the machine has stopped and then open the 
right cover on the light finisher. 
2.Pull out the tri-fold output tray 2d, swing lever 2g to the right, 
and remove the jammed paper. 
NOTE:If paper is torn, check for any torn pieces of paper inside 
the machine.
3.Return lever 2g to the original position and push back the 
tri-fold output tray 2d. 
4.Close the finisher right cover.
NOTE:A message will be displayed and the machine will not 
operate if the staple finishers right cover is even slightly open.
Downloaded From ManualsPrinter.com Manuals 
						

							Xerox 4590 EPS/4110 EPS User Guide
6-51
6. Problem Solving
Paper jams at unit 4 and knob 4a
1.Make sure that the machine has stopped and then open the 
right cover on the light finisher. 
2.Pull out unit 4. 
3.Turn knob 4a to the left to remove all the jammed paper from 
the left side of the unit 4.
NOTE:If paper is torn, check for any torn pieces of paper inside 
the machine.
Downloaded From ManualsPrinter.com Manuals 
						

							Xerox 4590 EPS/4110 EPS User Guide
6-52
6. Problem Solving
4.If the paper cannot be removed, pull up on the green lever on 
the right top cover unit 4 and remove all the jammed paper.
5.Return unit 4 to the original position.
6.Close the finisher right cover.
NOTE:A message will be displayed and the machine will not 
operate if the finisher right cover is even slightly open.
Downloaded From ManualsPrinter.com Manuals 
						

							Xerox 4590 EPS/4110 EPS User Guide
6-53
6. Problem Solving
Paper jams at output area of finisher
This section describes how to remedy paper jams that occur at the 
following locations: 
• Paper jams at output tray
• Paper jams at finisher tray
• Paper jams at booklet output tray
NOTE:Remedies differ according to the paper jam location. 
Follow the instructions displayed and remove the jammed paper.
Paper jams at output tray
1.Remove jammed paper from the output tray. 
NOTE:If paper is torn, check for any torn pieces of paper inside 
the machine.
2.Open and close the right cover of the finisher.
NOTE:A message will be displayed and the machine will not 
operate if the Finisher right cover is even slightly open.
Paper jams at finisher tray
1.Remove jammed paper from the finisher tray. 
NOTE:If paper is torn, check for any torn pieces of paper inside 
the machine.
2.Open and close the right cover of the finisher.
NOTE:A message will be displayed and the machine will not 
operate if the finisher right cover is even slightly open.
Downloaded From ManualsPrinter.com Manuals 
						

							Xerox 4590 EPS/4110 EPS User Guide
6-54
6. Problem Solving
Paper jams at booklet output tray
1.Make sure that the machine has stopped and then open the 
right cover on the light finisher. 
2.Turn knob 4a to the right to remove the jammed paper at the 
booklet output tray. 
NOTE:If paper is torn, check for any torn pieces of paper inside 
the machine.
3.Close the Finisher right cover.
NOTE:A message will be displayed and the machine will not 
operate if the Finisher right cover is even slightly open.
Downloaded From ManualsPrinter.com Manuals