Xerox DocuPrint 4590 EPS User Manual

							Xerox 4590 EPS/4110 EPS User Guide
6-35
6. Problem Solving
Paper jams inside the body
The following describes how to remedy paper jams that occur at 
the transfer module of the body.
1.Make sure that the machine has stopped before opening the 
front cover. 
2.Turn the green lever at the center of the transfer module to the 
right until it is in the horizontal position and then pull the 
transfer module out to the end.
3.Lift up the lever 2b to remove the jammed paper. Turn the 
knob 2b to remove the jammed paper as necessary. 
WARNING:Never touch a labeled area (found on the fuser unit or 
nearby) indicating “High Temperature” and “Caution.” Contact can 
lead to burns.
Downloaded From ManualsPrinter.com Manuals 
						

							Xerox 4590 EPS/4110 EPS User Guide
6-36
6. Problem Solving
4.If the jam occurs at the top of the transfer module or inside the 
fuser unit, remove the jammed paper by pulling it out towards 
the left.
If the jammed paper cannot be removed, lift up the lever 2c 
and then remove the jammed paper. 
CAUTION:Never touch the six protrusions which are visible 
when you lift up lever 2c.
WARNING:Never touch a labeled area (found on the fuser unit or 
nearby) indicating “High Temperature” and “Caution.” Contact can 
lead to burns.
5.Lift up the lever 2c as necessary, shift the lever 2d, and then 
remove the jammed paper. 
6.Turn the knob 2f as necessary and then remove the jammed 
paper. 
Downloaded From ManualsPrinter.com Manuals 
						

							Xerox 4590 EPS/4110 EPS User Guide
6-37
6. Problem Solving
7.Shift the lever 3b on the right of the fuser unit as necessary 
and then remove the jammed paper.
KEY POINT:If the jammed paper remains inside and it is difficult 
to remove, pull out the duplex module after returning the 
transfer module to the original position. Then try again.
8.Insert the transfer module completely and turn the green lever 
2 to the left. 
NOTE:If the lever cannot be turn, pull the transfer module to the 
middle and insert it again.
9.Close the front cover.
NOTE:A message will be displayed and the machine will not 
operate if the front cover is even slightly open.
Downloaded From ManualsPrinter.com Manuals 
						

							Xerox 4590 EPS/4110 EPS User Guide
6-38
6. Problem Solving
Paper jams inside finisher left cover
This section describes how to remedy paper jams that occur at the 
following locations: 
• Paper jams at lever 1a and knob 1c
• Paper jams at lever 1d
• Paper jams at lever 1b
NOTE:Remedies differ according to the paper jam location. 
Follow the instructions displayed to remove the jammed paper.
Paper jams at lever 1a and knob 1c
1.Make sure that the machine has stopped and then open the 
left cover on the finisher. 
2.Move lever 1a downwards and turn knob 1c 
left. Remove the jammed paper. 
NOTE:If paper is torn, check for any torn pieces of paper inside 
the machine.
3.Return lever 1a to the original position. 
Downloaded From ManualsPrinter.com Manuals 
						

							Xerox 4590 EPS/4110 EPS User Guide
6-39
6. Problem Solving
4.Close the finisher left cover. 
NOTE:A message will be displayed and the machine will not 
operate if the Staple Finishers left cover is even slightly open.
Paper jams at lever 1d
1.Make sure that the machine has stopped and then open the 
left cover on the finisher. 
2.Move lever 1d upwards and remove the jammed paper. 
NOTE:If paper is torn, check for any torn pieces of paper inside 
the machine.
3.Return lever 1d to the original position. 
4.Close the Finisher left cover. 
NOTE:A message will be displayed and the machine will not 
operate if the Staple Finishers left cover is even slightly 
open.
Downloaded From ManualsPrinter.com Manuals 
						

							Xerox 4590 EPS/4110 EPS User Guide
6-40
6. Problem Solving
Paper jams at lever 1b
1.Make sure that the machine has stopped and then open the 
left cover on the light finisher. 
2.Move lever 1b to the right and remove the jammed paper. 
NOTE:If paper is torn, check for any torn pieces of paper inside 
the machine.
3.Return lever 1b to the original position. 
4.Close the Finisher left cover. 
NOTE:A message will be displayed and the machine will not 
operate if the staple finishers left cover is even slightly open.
Downloaded From ManualsPrinter.com Manuals 
						

							Xerox 4590 EPS/4110 EPS User Guide
6-41
6. Problem Solving
Paper jams inside finisher right cover
This section describes how to remedy paper jams that occur at the 
following locations: 
• Paper jams at lever 3b and 3d
• Paper jams at lever 3e and knob 3c
• Paper jams at lever 3g and knob 3f
• Paper jams at lever 4b and knob 3a
NOTE:Remedies differ according to the paper jam location. 
Follow the instructions displayed and remove the jammed paper.
Paper jams at lever 3b and 3d
1.Make sure that the machine has stopped and then open the 
right cover on the light finisher. 
2.Move levers 3b and 3d to the left, and remove the jammed 
paper. 
NOTE:If paper is torn, check for any torn pieces of paper inside 
the machine.
Downloaded From ManualsPrinter.com Manuals 
						

							Xerox 4590 EPS/4110 EPS User Guide
6-42
6. Problem Solving
3.Return levers 3b and 3d the original position. 
4.Close the finisher right cover.
NOTE:A message will be displayed and the machine will not 
operate if the staple finishers right cover is even slightly open.
Paper jams at lever 3e and knob 3c
1.Make sure that the machine has stopped and then open the 
right cover on the light finisher. 
2.Move lever 3e, turn knob 3c to the right, and remove the 
jammed paper. 
NOTE:If paper is torn, check for any torn pieces of paper inside 
the machine.
Downloaded From ManualsPrinter.com Manuals 
						

							Xerox 4590 EPS/4110 EPS User Guide
6-43
6. Problem Solving
3.Return lever 3e to the original position. 
4.Close the finisher right cover.
NOTE:A message will be displayed and the machine will not 
operate if the right cover is even slightly open.
Paper jams at lever 3g and knob 3f
1.Make sure that the machine has stopped and then open the 
right cover on the light finisher. 
2.Move lever 3g upward and to the left, turn knob 3f to the left, 
and remove the jammed paper. 
NOTE:If paper is torn, check for any torn pieces of paper inside 
the machine.
Downloaded From ManualsPrinter.com Manuals 
						

							Xerox 4590 EPS/4110 EPS User Guide
6-44
6. Problem Solving
3.Return lever 3g to the original position. 
4.Close the right cover.
NOTE:A message will be displayed and the machine will not 
operate if the right cover is even slightly open.
Paper jams at lever 4b and knob 3a
1.Make sure that the machine has stopped and then open the 
right cover on the light finisher. 
2.Move lever 4b to the left, turn knob 3a to the right, and remove 
the jammed paper. 
NOTE:If paper is torn, check for any torn pieces of paper inside 
the machine.
Downloaded From ManualsPrinter.com Manuals