Panasonic Small Digital Business System 308/616 Installation Instructions

							S-BBS Installation Instructions Section 300 
v1.0 Issue 1 August 1990 
DOOR BOX 
The door box associated with a customer-provided electrical door opener is usually 
mounted outside the building beside the front door. By pressing a button on the door 
box a visitor alerts the erson inside the building who controls the door opener by 
dialing an access code rom a programmed telephone.  P 
1. Connecting the Door Box 
CI 
-.-JZa.chdoor..box.connects two wires to a 25-pair extension cable. (See TABLE 2, 
page 15) Choose the appropriate wire gauge from the table below: 
- 
- 
TABLE 4. Wire Gauges 
4;1 
Wire Gauge 
26 AWG, 
24 AWG 
22 AWG MaximumRange 
230 
Feet 
370 Feet 
590 
Feet Resistance 
20 a’ (Ohms) 
20 a (Ohins) 
20 s2 (Ohms) 
Figure 14 
24 
EXTENSION 
CONNECTOR  
						

							s 
S-DBS Installation Instructions 
v1.0  Section 300 
Issue 1 August 1990 
POWER FAILURE UNIT 
The Power Failure Unit (PFU) supports up to four CO PBXlines in case of power failure. 
The lines are switched directly to dedicated SLTs (type 500/2500 telephone) for 
incoming and outgoing calls. 
When power is restored the system will automatically.retum to normal service. 
e 
1. Wall-Mounting Procedure (See Figure 15 on page 27) 
a) 
b) 
d 
4 
e) Remove the two screws from the PFU module and 
lift off the upper case. - 
Use the provided wood screw to mount the PFU 
onto the wall. The wood scr&v should stick 
out from the wall about 5/16th of an inch. 
Hook the PFU onto the wood screw and tighten 
the screw. 
Screw the wood screws into the holes at the 
bottom of the lower case. 
Cut the knockout parts from the bottom of the 
lower case with pliers and remove the clamp 
plate. 
25  
						

							S-DBS Installation Instructions 
v1.0 Section 300 
Issue 1 August 1990 
.f-=. 
! 
POWER FAILURE UNIT (continued) 
2. Connecting the Power Failure Unit (PFU) (See Figure 15 on page 27) 
1) Use the modular plugs to connect each trunk 
line from the CO/PBX to the ‘FROM COL (COLA to D)” 
jacks on the PFU. Up to four trunk lines can 
be Connected to the PFU. B 
2) Connect the trunk lines 
from the TO COL (KSU)” 
jacks on the PFU to the “COL” port on the main 
unit by uslng - __-_- --.--- __- -----. 
th e modular plugs. 
- 
3) Connect the EXT lines from the main unit to the 
‘FROM SLT-LC (KSU)” jacks. 
8 
4) Connect each SLT line to the 7YO SLT” jacks on 
the PFU. 
5) Connect two wires from the.power supply terminals 
on the PFU parallel to any EXT port. 
6) Gather the wires back into the PFU and bring out 
through the underside of the PFU and attach the wires 
by clamp plate. (See (e) on Figure 15) 
Gf 
-- 
c .! 
. 
26  
						

							section 300 
Issue 1 August 1990 
POWER FAILURE UNIT (continued) 
I/ co1 4 
1 Connect to SLT lines %a 
S-DBS Installation Instructions 
v1.0 
Connect to COL port jack 
Figure 15 
27  
						

							?? 
- w e 
- 
S-DBS Installation Instructions Section 300 
v1.0 Issue 1 August 1990 ~, 
., i 
MUSIC-ON-HOLD (MOH) 
1. Connecting Music Source to the MOH Connector 
The MOH RCA connector is the input terminal for music-on-hold (MOH). Connect 
the music source to the MOH connector on the main unit with an RCA jack. 
NOTE: If a tape recorder is connected to the MOH e 
connector, place the recorder five meters or 
more away tiom the main unit to prevent 
interference. 
a 
TABLE 5. MOH Xnput Impedance 
Y 
MOH terminal input impedance: 1.5k ohms maximuxn 
input level: 150mV maximum 
RCA 
Tape Recorder 
for music-on-hold 
28 Figure 16 
i :  
						

							Section 300 
-.-. Issue.*xtigti3t-..lggo. 
EXTERNAL PAGING 
.-- _ 
%a 
S-DBS InstaUation Instructions 
v1.0 
1. Connecting the Paging Speaker to the Amplifier 
The External Paging Amplifier (EPA) connector is the output terminal for external 
paging. 
a) Connect the EPA terminal to the amplifier 
input terminal. Q 
b) Connect the paging speaker to the amplifier 
output terminal. 
1 
EPA terminal output impedance: 600 ohms 
output level: -20dB 
EPA 
CONNECTOI; 
RCA / 
PIN PLUG 
I 
AMPLIFIER PACING SPEAKER 
F 
Figure 17  
						

							S-DBS Installation instructions Section 300 
Vl .o Issue I August 1990 ._. .., 
ME.MO 
30  
						

							clclclclcl 
Section 400 
Issue 1 
. 
’ July 1990 
S-DBS 3081616 (VI -0) 
Programming Small Digital Business System 
-mhlnstructi.ons _.__.__ Y6Y 
Panasonic DBS Small 
- For Models: 
UB-42010 0 42020 
See other Section 400 for other Models 
Panasonk 
-.  
						

							/ ’ 
The information in this document is subject to change *thout notice and should not 
be construed as a commitment by the Panasonic Communications & Systems 
Company (PCSC). Furthermore, PCSC reserves the right, without notice, to make 
changes to equipment design as advance in engineering and manufacturing methods 
warrant. . 
. 
:. . 
;: 
) 
_ : .:’ 
:. . - . . , 
. .  
						

							Section 400 
Issue 1 July 1990 S-DBS Programming instructions 
Vl .o 
FCC RULES AND REGULATIONS (Part 68) 
In compliance with the requirements of Part 68 of the FCC Rules and Regulations for 
connection of terminal equipment to the telephone network, and for your convenience, 
the following information is presented. 
Notifying the Telephone Company 
When connecting or disconnecting the terminal equipment to the telephone network, 
inform the telephone company of the particular line. (s) for connection. the FCC 
registration number and ringer equivalence number of the registered terminal 
equipment. 
____-_. __ .---__ 
--_.-. .- _- _... 
d 
FCC Registration Numbers 
. Model Numbers Key System Hybrid System 
-- 
! VB-42010 (DBS308) 
ACKUSA-61853~KF-E ACKUSA-61855~MF-E 
‘....’ 
VB-42020 (DBS616) ACEUSA-6185~8X-E ACKUSA-6185~MF-E 
When enabling Pooled Trunk Access, inform the telephone company or a Panasonic 
service center of the MIT-E. FCC Registration number. According to FCC rules, Pooled 
Trunk Access is regarded as one of the distinguishing features of a PBX as opposed 
to a key telephone system. 
RINGER EQUWILENCE NUMBER (REN) 0.5 B 
The REN determin 
es the number of devices you may connect to your telephone line 
ancl SIU nave a~ tnose ~~~~he~-~~~-te~~p~e~b~~i~~c~ed. In most, 
but not all areas, the sum of the REWs of all devices connected to one line should not 
exceed five (5.0). You should contact your local telephone company to determine the 
maximum REN for your calling area. 
Service order code 9.OF 
Network address signaling code E 
Facility interface code 02LS2 (2 wire/Loop start) 
Required network interface code RJ25C 
Connection to a Party Line or Coin Operated Telephone Line . 
i 
‘- Direct Connection to a Party Line or Coin Operated Telephone Line Is Prohibited. 
If you are on a party line, check with your local telephone company for further 
information. 
i 
*.. 
111