NEC Neax 2400 Imx Hotel Office Data Specification

							NDA-24288 CHAPTER 4
Page 159
Revision 1.0
AGSPL
SERVICE INDEX A (SIDA) 1-255PNO 1-15A/G
56
PNO
This parameter specifies the Admin./Guest
Numbering Parameter Classification.
After assigning the PNO, go to the AOSP
command to skip this ACC.
After skipping the access code, the system
refers to the numbering data designated in
the next parameter A/G.A/G
Numbering table designation for redevelopment
A: Admin.
G: Guest
When SRV=SSCA (Service code appendix), SIDA56 (Guest/Admin. Service) is assigned 
						

							CHAPTER 4 NDA-24288
Page 160
Revision 1.0
AGSPL
Assign the number of advanced trunk routes.LOGICAL ROUTE NUMBER
(LGRT)
Count
Assign a dummy route number.LGRT
Second dial tone sending (which is sent when a station has
dialed the digits specified in NND of the AGNPL command)
0=Second DT is not sent
1=Second DT is sent2nd DTAuthorization code after dialing
ACC (LCR)+Destination number
0=Out of Service
1=In ServiceAH
ISDN-Sub Address Dialing
0=Out of Service
1=In ServiceSUB
LOGICAL ROUTE NUMBER
(LGRT)SECOND DIAL TONE
(2nd DT) 0/1AUTHORIZATION CODE
(AH) 0/1SUB ADDRESS DIALING
(SUB) 0/1 Index Counter (Count)
INDEX
LOGICAL ROUTE NUMBER (LGRT)
When SRV=OGC (Outgoing call) is assigned
When SRV=OGCA (Outgoing call with route advance) is assigned
When SRV=LCR (Least cost routing) is assigned
When SRV=LCRS (Register sender LCR) is assigned
INDEX
INDEX is the route advance order.
1
2
3 
						

							NDA-24288 CHAPTER 4
Page 161
Revision 1.0
AGSPL
Note:
This Telephone Number is available to make a call and receive a call within the self node only.
If the Telephone Number is to be used within the Fusion Network, assign it at Network Control Node (NCN)
using the ASPAN command.
Assign the skip digits to terminate the call.
Assign the announce equipment number.
EQP3 and 5-14 can be used for SRV=ANNC (Single announcement).SKIP DIGITS
(SKIP) 0-5 When SRV=UNIF (Office termination) is assigned
When SRV=ANNC (Announcement service-Single announcement) is assigned
SKIP
ANNOUNCEMENT EQUIPMENT NUMBER
(EQP) 0-127
EQP
Note:This data is available for ACIS only. For CCIS, use  the AUNE command.
Assign the tenant number of
the announcement trunk. When SRV=ANNCM (Announcement service-Multiple announcement) is assigned
TN TENANT NUMBER
(TN) 1-255 ANNOUNCEMENT EQUIPMENT NUMBER
(EQP) 122-125 Assign the announcement equipment number 
range from 122 to 125 (Multi announcement).EQP
When SRV=TELN (Telephone Number)
NECESSARY DIGIT
(NND) 1-16 
						

							CHAPTER 4 NDA-24288
Page 162
Revision 1.0
AGSPL
4. Data Sheet
(a) Service Code (SRV = SSC)
TENANT 
NUMBER
 (TN)ACCESS 
CODE
(ACC)
MAXIMUM
6 DIGITSCONNECTION 
STATUS 
INDEX
(CI) N/H/BKIND OF
SERVICE 
(SRV)SERVICE
INDEX
(SID)
1 – 63NUMBER OF 
NECESSARY
DIGITS 
(NND)NUMBER OF 
NECESSARY
DIGIT FOR 
SPEED 
CALLING
(NND1)
1 – 24FUSION 
POINT
CODE 
(FPC)
1-253SERVICE CONTENTS
H Hooking SSC 1Not used
NNormal
SSC 2
Dial Access to Attendant
(Operator Call) H Hooking
3Not used
4
NNormal
SSC 5
Call Waiting-Originating
BBusy
6
13
Not used
N Normal SSC 14
Speed Calling-Station;
Entry
N Normal SSC 15
Speed Calling-System;
Access
16Not used
N Normal SSC 17
Individual Trunk Access
18Not used
B Busy SSC 19
OG Trunk Queueing; 
Entry
N Normal SSC 20
OG Trunk Queueing; 
Cancel
N Normal SSC 21
Speed Calling-Station,
Group; Access
22
35
Not used
N Normal SSC 36
Hotel Service
Note:Use the sheets
on the next page
for the actual
data entry.
~
~ 
						

							NDA-24288 CHAPTER 4
Page 163
Revision 1.0
AGSPL
(a) Service Code (SRV = SSC) (Continued)
SID = 36 (Hotel Service)
TENANT 
NUMBER 
(TN)ACCESS CODE
(ACC)
MAXIMUM
6 DIGITSCONNECTION 
STATUS INDEX 
(CI) 
N/H/BKIND OF 
SERVICE 
(SRV)SERVICE 
INDEX
(SID)MAID
STATUS 
(STATE)
1 – 63SERVICE CONTENTS
N Normal SSC 361 To be cleaned without ID Code
2 Cleaned without ID Code
3Ready for Occupancy without ID 
Code
4 Use Not Allowed without ID Code
5
8Not used
9Maid Dial Answer Back without ID 
Code 1
10Maid Dial Answer Back without ID 
Code 2
11Maid Dial Answer Back without ID 
Code 3
12Maid Dial Answer Back without ID 
Code 4
13Maid Dial Answer Back without ID 
Code 5
14Maid Dial Answer Back without ID 
Code 6
15Maid Dial Answer Back without ID 
Code 7
16 Not used
17 To be cleaned with ID code
18 Cleaned with ID Code
19 Ready for Occupancy with ID Code
20 Use Not Allowed with ID Code
~ 
						

							CHAPTER 4 NDA-24288
Page 164
Revision 1.0
AGSPL
(a) Service Code (SRV = SSC) (Continued)
SID = 36 (Hotel Service)
TENANT 
NUMBER 
(TN)ACCESS CODE
(ACC)
MAXIMUM
6 DIGITSCONNECTION 
STATUS INDEX
(CI) N/H/BKIND OF 
SERVICE
(SRV)SERVICE 
INDEX
(SID)MAID
STATUS 
(STATE)
1 – 63SERVICE CONTENTS
N Normal SSC 3621
24Not used
25Maid Dial Answer Back with ID 
Code 1
26Maid Dial Answer Back with ID 
Code 2
27Maid Dial Answer Back with ID 
Code 3
28Maid Dial Answer Back with ID 
Code 4
29Maid Dial Answer Back with ID 
Code 5
30Maid Dial Answer Back with ID 
Code 6
31Maid Dial Answer Back with ID 
Code 7
32 Not used
33Automatic Wake-Up Setting, 
Cancel; Same Special Code
34For Guest Station Secretary 
Telephone; Boss/Secretary
35
43Not used
44 Direct Data Entry – STA
45
50Not used
51Same Special Code Time Zone 
Connection Change
~
~
~ 
						

							NDA-24288 CHAPTER 4
Page 165
Revision 1.0
AGSPL
(a) Service Code (SRV = SSC) (Continued)
SID = 36 (Hotel Service)
TENANT 
NUMBER 
(TN)ACCESS CODE
(ACC)
MAXIMUM
6 DIGITSCONNECTION 
STATUS INDEX
(CI) 
N/H/BKIND OF 
SERVICE
(SRV)SERVICE 
INDEX
(SID)MAID
STATUS 
(STATE)
1 – 63SERVICE CONTENTS
N Normal SSC 3652Same Special Code Time Zone 
Connection Change
53Same Special Code Time Zone 
Connection Change
54Same Special Code Time Zone 
Connection Change
55Same Special Code Time Zone 
Connection Change
56
62Not used
63 Dummy Number
~ 
						

							CHAPTER 4 NDA-24288
Page 166
Revision 1.0
AGSPL
(a) Service Code (SRV = SSC) (Continued)
Note:When programming Floor Service data, ASYD SYS1 INDEX 165, bit 7 = 1 must have been assigned.
TENANT 
NUMBER 
(TN)ACCESS 
CODE
(ACC)
MAXIMUM
6 DIGITSCONNECTION STA-
TUS INDEX
(CI) N/H/BKIND OF 
SERVICE 
(SRV)SERVICE
INDEX
(SID)
1 – 63NUMBER OF 
NECESSARY
DIGITS
(NND) FUSION 
POINT
CODE
(FPC)
1-253SERVICE CONTENTS
N Normal SSC 37Priority Call 1
N Normal SSC 38
Priority Call 2
N Normal SSC 39
Priority Call 3
40Not used
41Not used
42Not used
H Hooking SSC 43
Flash Signal Sending (CAS – 
Main)
44
47
Not used
N Normal SSC 48
Automatic Wake Up; Entry
N Normal SSC 49
Automatic Wake Up; Cancel
50Not used
51Not used
N Normal SSC 52
Do not Disturb; Entry
N Normal SSC 53
Do not Disturb; Cancel
54Not used55
N Normal SSC 56
Floor Service
Note:Use the sheet on 
the next page for 
the actual data 
entry.
~ 
						

							NDA-24288 CHAPTER 4
Page 167
Revision 1.0
AGSPL
(a) Service Code (SRV = SSC) (Continued)
SID = 56 (Floor Service)
TENANT 
NUMBER 
(TN)ACCESS CODE
(ACC)
MAXIMUM
6 DIGITSCONNECTION 
STATUS INDEX 
(CI) 
N/H/BKIND OF 
SERVICE 
(SRV)SERVICE 
INDEX
(SID)SERVICE
INDEX
NUMBER 
(No.1)
0 – 15SERVICE CONTENTS
N Normal SSC 56 0
N Normal SSC 56 1
N Normal SSC 56 2
N Normal SSC 56 3
N Normal SSC 56 4
N Normal SSC 56 5
N Normal SSC 56 6
N Normal SSC 56 7
N Normal SSC 56 8
N Normal SSC 56 9
N Normal SSC 56 10
N Normal SSC 56 11
N Normal SSC 56 12
N Normal SSC 56 13
N Normal SSC 56 14
N Normal SSC 56 15 
						

							CHAPTER 4 NDA-24288
Page 168
Revision 1.0
AGSPL
(a) Service Code (SRV = SSC) (Continued)
TENANT 
NUMBER 
(TN)ACCESS CODE
(ACC)
MAXIMUM
6 DIGITSCONNECTION 
STATUS INDEX
(CI)
N/H/BKIND OF 
SERVICE 
(SRV)SERVICE 
INDEX
(SID
1 – 63NUMBER OF 
NECESSARY 
DIGITS
(NND)SERVICE CONTENTS
N Normal SSC 57
Split Access (Same Number 
Access)
Note:Use the sheet on the 
next page for the 
actual data entry.
58
59
Not used
N Normal SSC 60 Attendant Manual Override
H Hooking SSC 61 Call Park Access Code
N Normal SSC 62 Call Park Local Retrieval Code
N Normal SSC 63 Call Park Remote Retrieval Code~