Vodavi Starplus Hybrid Key Telephone System Installation Manual

STAFIPLUS~ Digital Systems TF NO: 43 
VOICE MAIL GROUPS (Cont’d) 
A Uave” Mall Index Entry 
Desaiptbm 
The “Leave” mail index specifies the outpulsing Table where the ‘in-band” digits required to connect a caller, 
forwarded into Voice Mall, to the called stations mail box are stored. Refer to Sec. 645.2 for programming entries 
into an outpulsing table. 
.._ 
To delete a ‘Leave” mail index entry, enter one pound [#] in the desired location on the keypad and press the 
HOLD button.(i.e.: Tables-l ,2,3...

TECHNICAL FACT NOTICE 
Starplus Dlgltal Systems 
-TF NO: 33 
2/l/93 
2x4 SLT Expander Module 
Description: 
The 2x4 SLT Expander Module is a two CO by four single line telephone Interface module that plugs onto the main 
key service board of the Basic KSU or the main key service board of the Expansion KSU through the use of two 
ribbon cables. This module is a combination board that contains the necessary circuitry to connect two 
CO/Centrex/PBX loop start lines and four single line telephones to the...

STARPLUS TECHNICAL FACT NOTICE STARPLUS DIGITAL SYSTEMS 
2 X 4 SLT EXPANDER MODULES (cont’d) 
CO Lines Connections: 
CO Lines are connected to the system via modular RJ-11 connectors mounted on the 
2x4 SLT Expander Module and accessed on the bottom of the Basic KSU. The 2x4 SLT Expander Module connects 
CO Line ports 5 and 6 (when installed on the Basic KSU) or ports 13 and 74 (when installed in the Expansion KSU) 
to the system through modular connectors J21 and J22 respectively. The pinouts of the...

STARPLUS TECHNICAL FACT NOTICE STARPLUS DIGITAL SYSTEMS 
Table 1 - 2 x 4 SLT Expander Module Jll BKSU Connections 
PAIR 
17 
18 
19 
20 
21 
22 
23 
.24 
25 PIN COLOR 
42 YUOR 
17 
OFvfL 
43 YIJGN 
18 GNNL 
44 YUBN 
19 BNNL 
45 YUSL 
20 SINL 
46 VI/BL 
21 BWI 
47 VI/OR 
22 OFVVI 
48 VI/GN 
23 GNNI 
49 VI/BN 
24 BNNI 
50 VIISL 
25 SWI DESIG 
Port 009 SLT Tip 
SLT Ring 
Port 010 SLT Tip 
SLT Ring 
Port 011 SLT Tip 
SLT Ring 
Port 012 SLT Tip 
SLT Ring 
External Page Tip 
External Page Ring 
Page3of 11 TF...

STARPLUS TECHNICAL FACT NOTICE 
STARPLUS DIGITAL SYSTEMS 
2 x 4 SLT EXPANDER MODULE (cont’d) 
The pinouts for the stations on the 2x4 SLT Expander Module activate ports 025 through 028 on connector Jl 1 
are shown in Table 2 2x4 SLT Expander Module Jl 1 EKSU Connections when installed on the main key service 
board in the Expansion KSU. Also refer to Table 2 Expansion KSU Jll Station Connections. Only the Xmit Tip (SLT 
Tip) and Xmit Ring (SLT Ring) leads are used when connecting SLT stations to the 2x4...

STARPLUS TECHNICAL FACT NOTICE 
STARPLUS DIGITAL SYSTEMS 
Installation: 
1. 
2. Remove power from both the Basic KSU and Expansion KSU, if installed. 
Locate the Meaage Waiting Module and remove the two screws holding it to the 2x4 SLT Expander 
Module. Remove the Message Wafting Module to expose the hold down screw underneath. 
3. Locate the J9 connector on the main service board of the Basic KSU or main key service board of the 
Expansion KSU and the Pl connector on the 2x4 SLT Expander Module. Refer...

J 
’ 
STARPLUS TECHNICAL FACT NOTICE STARPLUS DIGITAL SYSTEMS 
DSI 0 
DS2 0 
0 
1 
Pl 
_ _ _ _ _ _ - - - _ - 
Figure 2 - 2 x 4 SLT Expander Module 
Page6of 11 TF NO. 33 
Vodavi Communications Systems 8300 E. Raintree Drive Scottsdale, AZ 85260 (602) 443-6000  

STARPLUS TECHNICAL FACT NOTICE 
STARPLUS DIGITAL SYSTEMS 
4x8 SLT Interface Board (CSB) 
Description: 
The 4x8 SLT Interface Board (CSB) is a four CO Line by eight single line telephone interface board. The card is 
a combination card that contains the necessary circuitry to connect four CO/Centrex/PBX loop start lines and eight 
standard on-premise single line telephones (2500 type) to the system. This card also contains one additional voice 
(transmit) path for external paging and a connector for...

STARPLUS TECHNICAL FACT NOTICE 
STARPLUS DIGITAL SYSTEMS a 
4 x 8 SLT EXPANDER MODULES (cont’d) 
. 
CO Lines Connections: CO Lines are connected to the system via modular RJ-14 connectors mounted to the 
front edge of the 4x8 SLT Interface Board and accessed through the bottom of the Basic KSU cabinet. Each 4x8 
SLT Interface Board connects four CO Line ports to the system through modular connectors J2 and J3 found on 
each card. The pinouts of the modular connector are as follows: 
4x8 SLT Interlace...

STARPLUS TECHNICAL FACT NOTICE STARPLUS DIGITAL SYSTEMS 
0 
$ 
Station 
0 Connects 
Message 
Wait 
Circuitry 
(FUTURE) 
Optional- 
Dual DTMF/ 
Talk-Back Page 
Module 
_------- Jqg# ----------- 
Optional 
Single DTMF 
Receiver 
Module 
514 
I I 
CJJ Pin #1 (blue) - N/C 
1 Pin #2 (black) +f?i~@- 
1 
I 1 Pin #3 (red) - Ring I 
I 
I 
I 
C-5 1 Pin #4 (green) - Tip 1 
Pin #5 (yellow) Gp-% 
I 
Pin #6 (brown) - N/C 
4x8 SLT Interface Board RJ-14 Modular Jack Pinouts 
Figure 5 - 4 x 8 SLT Interface Board (CSB)...