Lucent Technologies DEFINITY Enterprise Communications Server Release 8.2 Installation And Test For Single-Carrier Cabinets Manual

DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
Install and Wire Telephones and Other Equipment 
5-63 Install Multi-point Adapters 
5
367A Adapter
The 367A is an 8-c onduc tor ad ap ter used  at the work loc ation to b ridg e 3 to 7 
terminals. See Fig ure 5-25
.
Figure 5-25. Wiring Diagram of 367A Adapter Figure Notes
1. Jac k 1
2. Jac k 23. Jac k 8
4. 367A Adap ter
312 88 877 766 655 544 433 322 211 1
4 

DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
Install and Wire Telephones and Other Equipment 
5-64 Install Multi-point Adapters 
5
Basic Multi-point Installation Distances
Fi g u re  5 - 2 6 p rovid es c ab ling  information for fan-out of ISDN-BRI multi-p oint 
installations. In Fig ure 5-26
, the terminating resistor is loc ated  in the satellite 
c loset. All d istanc es assume 24 AWG (#5) (0.5 mm2) D-Insid e...

DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
Install and Wire Telephones and Other Equipment 
5-65 Connect Stratum 3 Clock 
5
Connect Stratum 3 Clock
Set Clock Options
1. There are four sets of op tion switc hes on the c loc k. Set the op tions on the 
Cloc k Inp ut (CI) c irc uit p ac k p er Tab le 5-15
.
2. Set the options on the Stratum 3 Clock (ST3) circuit pack per Tab le 5-16.
NOTE:
Only SW 1 and  SW2 are...

DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
Install and Wire Telephones and Other Equipment 
5-66 Connect Stratum 3 Clock 
5
NOTE:
Set switc hes 1 and  2 ac cording to the d istanc e from the Stratum 3 c loc k to the DEFINITY 
System. Set switch 3 to ON. Set switc h 4 to OFF.
Cabling the Stratum 3 Clock
Figure 5-27 shows typ ic al c onnec tions to a Stratum 3 Cloc k c ab inet. Connec tions 
are mad e throug h the...

DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
Install and Wire Telephones and Other Equipment 
5-67 Connect Stratum 3 Clock 
5
Figure 5-27. Typical Connections to Stratum 3 Clock Figure Notes:
1 . SC C  C a b in e t  ( PPN )
2.“A” Position
3. “ B”  Position
4. H600-307 Cab le
5. H600-247 G2 Cab le
6. 1300 Feet (396 m)
7. B25A (Male-to-Female) Cable
8. Channel Servic e Unit (Sec ond ary)9. Channel Servic e Unit...

DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
Install and Wire Telephones and Other Equipment 
5-68 Connect Stratum 3 Clock 
5
Stratum 3 Clock Wiring Installation Procedure
1. Connec t the B25A c ab les from the TN780 c onnec tor panel slot on the 
system c ab inet and  the Stratum 3 Cloc k to the c ross-c onnec t mod ule in 
the yellow field .
2. Connec t the CSU p lug end  of the H-600-274 (Y) c ab le to the p...

DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
Install and Wire Telephones and Other Equipment 
5-69 Connect Stratum 3 Clock 
5
Table 5-19. Cross-Connects for Standard Reliability
From: Stratum 3 Clock To: Y Cable Clock End (Primary)
Lead 
DesignationLead 
ColorConnecting 
Block 
Te r m i n a lLead 
DesignationLead 
ColorConnecting 
Block 
Te r m i n a l
RREF1 W- BL 1 V- O 4 3
TREF1 B L - W 2 O - V 4 4
To: Y Cable...

DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
Install and Wire Telephones and Other Equipment 
5-70 Connect Stratum 3 Clock 
5
7. The c ommon c ross-c onnec tion from the TN780 in A and  B c arriers to the 
Stratum 3 Cloc k should  b e d one b y brid ging  the jump er wires.
8. Dress the c ab les d own sid es of the c ab inet and  run throug h the Cable 
Slack Manager, if provided.
9. Ad minister p er 
DEFINITY...

DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
Install and Wire Telephones and Other Equipment 
5-71 DEFINITY Wireless Business System 
5
DEFINITY Wireless Business System
To install and  test the hard ware, refer to DEFINITY Wireless Business System 
Installation and  Tests Guid e
.
To interfac e the Wireless Business System to the system c ab inet, refer to 
DEFINITY Wireless Business System Interfac e.
To operate...

DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
Install and Wire Telephones and Other Equipment 
5-72 Connect Modem to Telephone Network 
5
Connect Modem to Telephone 
Network
1. Cross-c onnec t the network jac k on the mod em to the network interfac e 
(via a 103A or mod ular wall jac k). See Table 5-21
 for the p inout.  
Figure 5-28. Network Jack on U.S. Robotics Modem
Table 5-21. Pinout of Network Jack
Pin Number...