Land Rover Range Rover 2002my On Workshop Procedures Lm 6th Edition Nas Rover Manual

FRONT DIFFERENTIAL
54-6 REPAIRS
21.Connect vacuum hoses to T piece and fit 
hoses to clips.
22.Ensure pinion timing marks are aligned and 
connect column to PAS rack. Fit and tighten 
clamp screw to 24 Nm (18 lbf.ft).
23.Fit differential oil seal.
 
 +  FRONT DIFFERENTIAL, REPAIRS, 
Oil seal - differential housing.
24.Fit RH drive shaft seal.
 
 +  DRIVESHAFTS, REPAIRS, Seal - 
drive shaft - front - RH.
25.Fit front propeller shaft.
 
 +  DRIVESHAFTS, REPAIRS, Propeller 
shaft - front.
26.Fill...

FRONT DIFFERENTIAL
REPAIRS 54-7
9.Drain oil from differential.
 
 +  FRONT DIFFERENTIAL, 
ADJUSTMENTS, Front differential - drain 
and refill.
10.Remove front propeller shaft.
 
 +  DRIVESHAFTS, REPAIRS, Propeller 
shaft - front.
11.Remove RH drive shaft seal.
 
 +  DRIVESHAFTS, REPAIRS, Seal - 
drive shaft - front - RH.
12.Remove differential oil seal.
 
 +  FRONT DIFFERENTIAL, REPAIRS, 
Oil seal - differential housing.
13.Remove Torx bolt from steering column lower 
clamp.
14.Rotate steering wheel to...

FRONT DIFFERENTIAL
54-8 REPAIRS
19.Remove 2 speed nuts securing each anti-roll 
bar heatshield to body and 2 bolts securing 
each heatshield to sub-frame. Remove 
heatshields.
20.Use a transmission jack to support the sub 
frame.
21.Remove 6 bolts securing sub-frame. Remove 2 
bolts securing sub-frame to cross member 
(bolts arrowed).22.With assistance, lower and remove sub-frame 
assembly.
23.Remove differential breather hose. Remove 4 
differential securing bolts and with assistance, 
remove...

FRONT DIFFERENTIAL
REPAIRS 54-9
19.Check alignment and connect column to PAS 
rack. Fit and tighten new clamp bolt to 24 Nm 
(18 lbf.ft).
20.Fit differential oil seal.
 
 +  FRONT DIFFERENTIAL, REPAIRS, 
Oil seal - differential housing.
21.Fit RH drive shaft seal.
 
 +  DRIVESHAFTS, REPAIRS, Seal - 
drive shaft - front - RH.
22.Fit front propeller shaft.
 
 +  DRIVESHAFTS, REPAIRS, Propeller 
shaft - front.
23.Fill differential to correct level with oil.
 
 +  FRONT DIFFERENTIAL, 
ADJUSTMENTS, Front...

FRONT DIFFERENTIAL
54-10 REPAIRS
7.Remove nut securing height sensor link to 
lower arm and release link.
CAUTION: Use an open ended spanner on 
flats provided to prevent ball joint rotating.
8.Loosen bolt securing lower arm to subframe 
one quarter of a turn.
9.Remove nut securing lower arm ball joint to 
hub.
10.Using LRT-54-027 release lower arm ball joint 
and disconnect lower arm from hub.
CAUTION: Ensure ball joint seal is not 
damaged. A damaged seal will lead to 
premature failure of the...

FRONT DIFFERENTIAL
REPAIRS 54-11
15.Fit an M14 nut to ball pin, flush with end of pin.
16.Using LRT-57-036 separate ball pin from 
steering arm. Remove M14 nut and release ball 
pin from steering arm.
CAUTION: Ensure ball joint seal is not 
damaged. A damaged seal will lead to 
premature failure of the joint.
17.Position container to collect oil spillage.
18.Fit LRT-54-026 to drive shaft inboard joint.
19.Using  levers, release drive shaft from 
differential.
20.Remove 2 nuts and bolts securing hub to...

FRONT DIFFERENTIAL
54-12 REPAIRS
18.Fit road wheel and tighten nuts to 140 Nm (103 
lbf.ft).
19.Remove stands and lower vehicle.
20.Tighten bolt securing lower arm to subframe to 
165 Nm (121 lbf.ft), plus a further 90°.
21.Top-up differential with oil.
 
 +  FRONT DIFFERENTIAL, 
ADJUSTMENTS, Front differential - drain 
and refill.
22.Connect battery earth lead. 

STEERING
ADJUSTMENTS 57-1
STEERING ADJUST ME NTS
Power assisted steering (PAS) system - 
bleed 
$% 57.15.02
Check
1.Clean PAS fluid reservoir around filler cap and 
fluid level indicators.
2.Check power steering fluid, if aerated, wait until 
fluid is free from bubbles then top-up reservoir 
to UPPER level mark with recommended fluid.
3.Fit reservoir filler cap.
Bleed
1.Remove filler cap from reservoir and fill to 
UPPER level mark with recommended fluid. 
Fluid must always be present in reservoir...

STEERING
57-2 ADJUSTMENTS
Front wheel alignment - check & adjust 
$% 57.65.01 
Before disconnecting the battery, ensure all text and 
cautions in the battery disconnection section are 
observed. 
 
 +  GENERAL INFORMATION, Electrical 
Precautions.
Check
1.Ensure tyre pressures are correct and vehicle 
is at correct ride height.
2.Roll vehicle backwards and forwards to relieve 
stresses in steering and suspension.
3.Ensure that wheel alignment equipment is 
properly calibrated.
NOTE: Only use four wheel...

STEERING
ADJUSTMENTS 57-3
8.Repeat procedure for other side.
9.Adjusting toe:
10.Loosen nut securing tie rod approximately 3/4 
of a turn.
11.Turn eccentric and adjust toe to specified 
value.
12.Tighten nut securing tie rod  to sub frame to 165 
Nm (121 lbf.ft).
13.Repeat procedure for other side.
14.Front wheel alignment adjust:
15.Adjusting camber:
16.Remove cap from top mounting.
17.Break off locating pin.
18.Loosen nut securing damper upper mounting.19.Fit LRT-57-045 to damper upper mounting....