Land Rover Range Rover 2002my On Workshop Procedures Lm 6th Edition Nas Rover Manual

FINAL DRIVE
51-10 REPAIRS
Oil seal - pinion 
$% 51.20.01
Remove
1.Raise vehicle on lift.
2.Remove exhaust system.
 
 +  MANIFOLD AND EXHAUST SYSTEM 
- Td6, REPAIR, Exhaust system and 
mountings.
3.Remove 8 nuts securing centre heat shield and 
remove shield.
4.Remove 8 hexagonal headed screws securing 
fuel tank heat shield and remove shield.5.Reference mark propeller shaft and differential 
to aid reassembly.
6.Remove 6 nuts securing propeller shaft to 
differential flange.
7.Remove 2 nuts securing...

FINAL DRIVE
REPAIRS 51-11
9.Reference mark pinion nut and pinion shaft to 
aid reassembly.
10.Using LRT-51-003 restrain pinion flange and 
remove nut.
11.Position container to collect oil spillage.
12.Using a two legged puller remove pinion flange.
13.Carefully remove and discard oil seal, take care 
not to damage oil seal recess.
Refit
1.Clean oil seal recess.2.Using LRT-12-179 with adapter LRT-51-019, fit 
new oil seal.
3.Clean pinion flange.
4.Fit pinion flange, fit nut, restrain flange using...

FINAL DRIVE
51-12 REPAIRS
Oil seal - differential housing 
$% 51.20.36
Remove
1.Raise rear of vehicle and support under body.
WARNING: Do not work on or under a 
vehicle supported only by a jack. Always 
support the vehicle on safety stands.
2.Remove road wheel.
3.Remove 6 bolts securing drive shaft to 
differential drive flange and collect 3 bolt plates. 
Discard bolts.
4.Position jack to support the lower arm.
5.Remove nut and bolt securing lower arm to 
hub.
6.Lower support jack.
7.Release drive shaft...

FINAL DRIVE
REPAIRS 51-13
10.Clean bolt plates, position plates, fit new bolts 
securing drive shaft to differential drive flange 
and tighten to 40 Nm (30 lbf.ft) plus a further 
60°.
11.Fit road wheel and tighten nuts to 140 Nm (103 
lbf.ft).
12.Remove stands and lower vehicle.
13.Tighten bolt securing lower arm to hub to 250 
Nm (184 lbf.ft).
14.Top-up differential with oil.
 
 +  FINAL DRIVE, ADJUSTMENTS, Rear 
differential - drain and refill. 

FINAL DRIVE
51-14 REPAIRS 

FRONT DIFFERENTIAL
ADJUSTMENTS 54-1
FRONT DIF FERENTIAL ADJUST ME NTS
Front differential - drain and refill 
$% 54.15.02
Drain
1.Position vehicle on lift.
2.Position container to catch spillage.
3.Clean area surrounding drain and level plugs.
4.Remove drain plug and collect fluid.
Refill
1.Apply sealant, Part No. STC 50552 to drain 
plug, fit and tighten to 65 Nm (48 lbf.ft).
2.Remove filler/level plug.
3.Fill differential using recommended lubricant, 
until a thread of oil runs from filler/level plug....

FRONT DIFFERENTIAL
54-2 ADJUSTMENTS 

FRONT DIFFERENTIAL
REPAIRS 54-3
REPAIRS
Differential assembly - Td6 
$% 54.10.01
Remove
1.Position vehicle on lift.
2.Disconnect battery earth lead.
3.Remove cooling fan.
 
 +  COOLING SYSTEM - Td6, REPAIR, 
Coupling unit - viscous fan.
4.Remove air intake plenum.
 
 +  HEATING AND VENTILATION, 
REPAIRS, Filter - fresh air intake.
5.Remove 2 nuts securing engine brackets to 
mountings.
6.Fit LRT-12-216 to engine lifting eyes.
7.Connect chain to lifting bracket and take weight 
of engine.
8.Drain oil from...

FRONT DIFFERENTIAL
54-4 REPAIRS
16.Disconnect mounting vacuum supply hose from 
T piece.
CAUTION: Always fit plugs to open 
connections to prevent contamination.
17.Note fitted position for refit then remove cable 
ties securing height sensor harness to sub 
frame and sensors.
18.Disconnect height sensor multiplugs.
19.Disconnect multiplug from PAS rack pinion 
sensor.
20.Position container to collect PAS fluid spillage.21.Loosen union nut, disconnect PAS outlet hose 
from pump and discard O ring....

FRONT DIFFERENTIAL
REPAIRS 54-5
24.Remove 2 speed nuts securing each anti-roll 
bar heat shield to body and 2 bolts securing 
each heat shield to sub-frame. Remove heat 
shields.
25.Use a transmission jack to support the sub 
frame.
26.Remove 6 bolts securing sub-frame.
27.Remove 2 bolts securing sub-frame to cross 
member.28.With assistance, lower and remove sub-frame 
assembly.
29.Disconnect breather hose from differential.
30.Remove 4 bolts securing differential and with 
assistance, remove...