Brother Hl 3260n User Manual
Have a look at the manual Brother Hl 3260n User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 331 Brother manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
CHAPTER 5 MAINTENANCE 5-13 C C l l e e a a n n i i n n g g Clean the printer exterior and interior periodically with a dry soft cloth. When you replace the toner bottle, be sure to clean the printer interior with a dry soft cloth. If the printed page gets stained with Toner, clean the printer interior with a dry soft cloth. War ni ng • Turn off the printer power and allow it to cool down before cleaning. ! Cleaning the Paper feed roller If the paper feed rollers are dirty with paper dust, the paper may not feed correctly or paper jam. In this case, clean the paper feed rollers. Follow these steps to clean the paper feed rollers in standard paper tray 1 and paper tray 2. ☛ ☛☛ ☛ 1.Turn off the printer power. ☛ ☛☛ ☛ 2.Slide Paper tray 1 and Paper tray 2 out until they stop. Raise the front end slightly and pull the paper trays forward to remove them from the printer. ZAEP060E Fig. 5-23
5-14 ☛ ☛☛ ☛ 3.Locate the position of the Paper feed rollers as shown in the illustration below. ZAEM400E Fig. 5-24 ☛ ☛☛ ☛ 4.Lift the green lever that is attached to the Paper feed rollers inside the printer on the lower right hand side and pull it towards you. ZAEM090E Fig. 5-25 ☛ ☛☛ ☛ 5.Pull the Paper feed roller towards you (), then push it in a diagonally downward direction away from you and remove it (). ZAEM100E 1 2 Fig. 5-26
CHAPTER 5 MAINTENANCE 5-15 ☛ ☛☛ ☛ 6.Wipe the rubber of the Paper feed roller with a dry cloth. ZAEM031E Fig. 5-27 ✒ ✒✒ ✒ Note • Do not wipe with a wet cloth, alcohol or cleanser. ☛ ☛☛ ☛ 7.Insert the projection of the Paper feed roller into the hole (). While pulling the roller towards you, insert the roller onto the rear shaft (). ZAEM110E 1 2 2 Fig. 5-28 ☛ ☛☛ ☛ 8.Check the motion of the Paper feed roller to confirm that it can rotate smoothly. ZAEM101E Fig. 5-29
5-16 ☛ ☛☛ ☛ 9.Return the green lever to its original position. ZAEM091E Fig. 5-30 ☛ ☛☛ ☛ 10.Clean the paper feed rollers of Paper tray 2 by following steps 2 to 8. ☛ ☛☛ ☛ 11.Hold Paper tray 2 (which has a lever on the paper size dial) with both hands, and slide it slowly into the second slot from the top until it stops. ZAEM141E Fig. 5-31 ☛ ☛☛ ☛ 12.Hold Paper tray 1 with both hands, and slide it slowly into the slot until it stops. ☛ ☛☛ ☛ 13.If the optional Lower tray (LT-5100 or LT-5200) is installed, clean the Paper feed rollers of Paper tray 3 or Paper tray 4 following the steps for Paper tray 1 and Paper tray 2.
CHAPTER 5 MAINTENANCE 5-17 ! Cleaning the Friction pad If the Friction pads are dirty, the printer may feed multiple pages or paper jam. In this case, clean the Friction pads of each paper tray. Follow these steps to clean the Friction pads in standard Paper tray 2. ☛ ☛☛ ☛ 1.Turn off the printer power. ☛ ☛☛ ☛ 2.Slide Paper tray 2 out until it stops. ZAEY012E Fig. 5-32 ☛ ☛☛ ☛ 3.Wipe the top of the Friction pad with a dry cloth. ZAEY017E Fig. 5-33 ✒ ✒✒ ✒ Note • Do not wipe with a wet cloth, alcohol or cleanser. ☛ ☛☛ ☛ 4.Slide Paper tray 2 into the slot slowly until it stops. ☛ ☛☛ ☛ 5.If 2000 Sheets paper tray (LT-5200) is installed, clean the Friction pads of Paper tray 3 or Paper tray 4 following the steps for Paper tray 1 and Paper tray 2.
5-18 ! Cleaning the Pad inside the Paper tray If the Pad inside the paper tray is dirty multiple pages may print when a small amount of paper is stacked. In this case, clean the Pad inside the paper tray. Follow these steps to clean the Pad inside standard Paper tray 2. ☛ ☛☛ ☛ 1.Turn off the printer power. ☛ ☛☛ ☛ 2.Slide Paper tray 2 out until it stops. ZAEY012E Fig. 5-34 ☛ ☛☛ ☛ 3.If there is paper in the Paper tray, remove the paper. ☛ ☛☛ ☛ 4.Wipe the pad inside the Paper tray with a dry cloth. ZAEY035E Fig. 5-35 ✒ Note Do not wipe with a wet cloth, alcohol or cleanser.
CHAPTER 5 MAINTENANCE 5-19 ☛ ☛☛ ☛ 5.Load paper and slide Paper tray 2 into the printer slowly until it stops. ☛ ☛☛ ☛ 6.If the 2000 Sheets paper tray (LT-5200) is installed, clean the Friction pads of Paper tray 3 or Paper tray 4 following the steps for Paper tray 1 and Paper tray 2.
5-20 A A d d d d i i n n g g S S t t a a p p l l e e s s When the message “Add Staples” appears on the Control panel, the staples have run out. Follows these steps to add a new staple refill. ✒ Note After adding the Staple refill, Staples might not be ejected for the first few times. ☛ ☛☛ ☛ 1.Open the Rear cover of the Finisher. Fig. 5-36 ☛ ☛☛ ☛ 2.Remove the empty cartridge. Fig. 5-37
CHAPTER 5 MAINTENANCE 5-21 ☛ ☛☛ ☛ 3.Remove the empty refill case as shown in the illustration. ZAEH190E Fig. 5-38 ☛ ☛☛ ☛ 4.Align the arrows on the new refill case and the cartridge, and push the new refill case in until it clicks. ZAEH191E Fig. 5-39 ✒ Note Do not remove the ribbon securing the staples before installing the cartridge.
5-22 ☛ ☛☛ ☛ ZAEH200E Fig. 5-40 ☛ ☛☛ ☛ Fig. 5-41 ☛ ☛☛ ☛