Panasonic Kx-tvs90 Voice Processing System Installation Manual

INTEGRATING THE VPS WITH THE PANASONIC KX-TA SERIES PBX AND KX-TD SERIES PBX
Installation Manual 71
Section 4
INTEGRATING THE VPS WITH THE
PANASONIC KX-TA SERIES PBX AND KX-
TD SERIES PBX 

INTEGRATING THE VPS WITH THE PANASONIC KX-TA SERIES PBX AND KX-TD SERIES PBX
72 Installation Manual
4.1 GUIDELINES FOR DIGITAL INTEGRATION
4.1.1 Why Digital Integration is Important
The VPS works well with most PBXs because its connections are made through a standard 
single line (tip/ring) telephone interface. However, the communication between the PBX and 
VPS is best when Digital Integration is used; the VPS is already set up to communicate through 
Digital Integration. 
Once Digital Integration is...

INTEGRATING THE VPS WITH THE PANASONIC KX-TA SERIES PBX AND KX-TD SERIES PBX
Installation Manual 73
Note
Depending on the model and/or the software version of the connected PBX (see 3.1.1 APT/
DPT or Inband Signaling?), you may not be able to utilize some of the features listed above. 
For more information, call National Parts Center at 1-800-833-9626.Intercom  Paging* Callers can page subscribers through built-in speakers 
and external paging equipment. For a Caller ID Caller, 
if his name has been...

INTEGRATING THE VPS WITH THE PANASONIC KX-TA SERIES PBX AND KX-TD SERIES PBX
74 Installation Manual
4.2 CONNECTING THE VPS WITH THE 
PANASONIC KX-TA624
4.2.1 KX-TA624 Software Verification and Programming for 
Digital Integration via the Manager’s Extension
It is important that the KX-TA624 has the proper software level to allow Digital Integration 
with the VPS. Follow the procedures below to confirm the software level, then complete the 
required programming before starting up the VPS.
All of the...

INTEGRATING THE VPS WITH THE PANASONIC KX-TA SERIES PBX AND KX-TD SERIES PBX
Installation Manual 75
From the SYS-PGM NO ?screen: 
a)Enter [130] (for VPS1) or [131] (for VPS2).
b)Press the NEXT button (SP-PHONE).
Screen output: Disable
c)Press the SELECT button (AUTO-ANSWER).
Screen output: Port 7 or Port 15
d)To assign 2 jacks, Press the SELECT button (AUTO-ANSWER) again.
Screen output: Port 7& 8 or Port 15& 16
To assign 1 jack, skip this step.
e)Press STORE.
f)Press END (HOLD).
5.Select the appropriate...

INTEGRATING THE VPS WITH THE PANASONIC KX-TA SERIES PBX AND KX-TD SERIES PBX
76 Installation Manual
Recommended Outside (CO) Line feature settings:
a)If the VPS is answering all incoming calls:
Outside (CO) Line Mode—Use System Programs [414] (Day Mode), [415] (Night 
Mode), [416] (Lunch Mode) to set this parameter. Program all lines DIL to the first 
extension of the Voice Mail hunt group. The KX-TA624 will allow incoming outside 
calls to hunt only if the outside (CO) lines are DIL to the first port of...

INTEGRATING THE VPS WITH THE PANASONIC KX-TA SERIES PBX AND KX-TD SERIES PBX
Installation Manual 77
CAUTION
Setting the DIP Switch to position 5 will default the Voice Processing System, resulting in a 
loss of all user programming, and voice messages (except User1 and User2 prompts).
9. Plug in and power up the VPS and wait approximately 2.5 min while the system 
initializes. 
Before starting the VPS, make sure all installation and line connections have been 
done as described in Section 2 INSTALLATION....

INTEGRATING THE VPS WITH THE PANASONIC KX-TA SERIES PBX AND KX-TD SERIES PBX
78 Installation Manual
Possible causes of the message: APT Interface Connection is not Established
10. Start up completed.
a)The Power Indicator light stops blinking when the start-up has been successful. (The 
delay varies according to the system’s condition.) 
b)**ON LINE MODE** is displayed.
c)System prompt [>] is displayed on the screen. To enter system administration, Press 
ENTER. All parameters can be set through the...

INTEGRATING THE VPS WITH THE PANASONIC KX-TA SERIES PBX AND KX-TD SERIES PBX
Installation Manual 79
(extension 106) has its mailbox in the VPS1, assign extension 107 or 108 as the 
destination, not extension 115 or 116 (see diagram below).
2.Change the extension numbers of both VPS port 1 and 2 for VPS2 from 107 and 
108 to 115 and 116 (see Extension Number of VPS Port 1 and Extension 
Number of VPS Port 2 in Table 74 in B7.3 PBX Interface Parameters).
Set the DIP Switch to position 0 after...

INTEGRATING THE VPS WITH THE PANASONIC KX-TA SERIES PBX AND KX-TD SERIES PBX
80 Installation Manual
4.3 KX-TD500 PROGRAMMING FOR DIGITAL 
INTEGRATION
Follow the procedure below to program the VPS card for DPT Integration.
1.Assignment of the VPS card to be connected to the VPS
Note:
If the VPS card to which the VPS will be assigned is already installed in the KX-
TD500, skip the steps a through d. If a new VPS card is installed in the KX-TD500, 
follow the steps below.
a)Go to the 1-1 Slot Assignment...