Panasonic Kx-tvs90 Voice Processing System Installation Manual

SYSTEM ADMINISTRATORS GUIDE
Installation Manual 281
Table 67 
Parameter Value Range
(Default)Description/Function
Intercom 
Paging 
SequenceUp to 12 digits con-
sisting of 0-9, , #
and special codes
(FXW)Specifies the intercom paging sequence required by 
the PBX. This can be programmed using up to 12 of 
the following 8 letters and 12 dial codes.
D: Disconnecting
F: Hook Flash
R: Ringback Tone Detection
S: Silence Detection
T: Dial Tone Detection
W: Wait for 1 s
X: Pager Dialing
A: Answer
1-9, 0, , #:...

SYSTEM ADMINISTRATORS GUIDE
282 Installation Manual
Other Parameters-Fax Management
You can program the VPS to automatically forward incoming fax calls to a fax extension. You 
can specify a maximum of 2 fax extensions as the destination for the Automatic Fax Transfer. 
If the main fax extension is not available to receive a fax, the VPS will forward the fax 
transmission to the alternate fax extension.Paging Code 
for Group 1-16Up to 12 digits 
consisting of
0-9, ,# for each 
group
(Group 1-8:...

SYSTEM ADMINISTRATORS GUIDE
Installation Manual 283
Fax No Answer 
Time5-60 s
(10)Specifies the length of time (in seconds) the VPS must 
wait before taking other action when there is no answer at 
either fax extension.
Note: This timer applies to the fax call that has been 
transferred to the main or alternate fax extension. 
Fax Manager 
Mailbox No.2-5 digits
(None)Specifies the Fax Manager Mailbox Number. The VPS 
will notify the fax manager of the status of fax calls 
depending upon the settings of...

SYSTEM ADMINISTRATORS GUIDE
284 Installation Manual
Other Parameters-Disconnect Parameter
To access the proper menu for Disconnect Parameter, follow the menu path as 
shown:
System Administration Top Menu-1-5-7-9
Table 69 
Parameter Value Range
(Default)Description/Function
Maximum
Silence Time5-60 s
(10)Specifies the length of time (in seconds) that the VPS 
must wait until it disconnects the call when silence is 
detected. 

SYSTEM ADMINISTRATORS GUIDE
Installation Manual 285
B7 SYSTEM ADMINISTRATION—HARDWARE 
SETTINGS
For System Administration (system setup, mailbox setup, and system diagnosis), an RS-232C 
terminal must be connected to the serial interface of the VPS.
B7.1 RS-232C Parameters
To access the proper menu for Hardware Setting, follow the menu path as shown:
System Administration Top Menu-1-6
To access the proper menu for RS-232C Parameter, follow the menu path as shown:
System Administration Top Menu-1-6-1...

SYSTEM ADMINISTRATORS GUIDE
286 Installation Manual
B7.2 Port Setting
Port Setting Menu
To access the proper menu for Port Setting, follow the menu path as shown:
System Administration Top Menu-1-6-2 
To access the proper menu Port Setting Menu for the selected port, follow the menu 
path as shown:
System Administration Top Menu-1-6-2-Port No.(1-2)
Table 71 
Parameter Value Range
(Default)Description/Function
Flash Time 1. 100 ms
2. 300 ms
3. 600 ms
4. 900 ms
(600)Specifies the length of time the hook...

SYSTEM ADMINISTRATORS GUIDE
Installation Manual 287
B7.3 PBX Interface Parameters
Three separate parameters are used to program the VPS for optimal signaling and performance 
with the PBX.
Dialing Parameters
These parameters specify how the VPS will initiate and control call transfers, setup outgoing 
calls, and control message waiting lamps on extensions. The procedure for verifying the 
correct code sequences for non-Panasonic KX-T series telephone systems is to manually 
execute the sequences from a...

SYSTEM ADMINISTRATORS GUIDE
288 Installation Manual
Table 73 
PBX Type Other
Manufac-
turersKX-T series
T308/
T616T1232 T96 T336TD816/
TD1232/
TA1232/
TD308TA series TD500
Integration 
ModeNone
NoneNone None None None
*
1DPTNone
*2APTNone
*1DPT
Inband Inband Inband Inband Inband Inband Inband
Operator 
Transfer 
SequenceFX FTX FTX FTX FTX FTX FX FTX FX FTX FX
Extension 
Transfer 
SequenceFX FTX FTX FTX FTX FTX FX FTX FX FTX FX
Alternate 
Extension 
Transfer 
SequenceFX FTX FTX FTX FTX FTX FX FTX FX FTX...

SYSTEM ADMINISTRATORS GUIDE
Installation Manual 289
Call 
Waiting 
SequenceNoneN/A1N/AN/A111111
Release 
Sequence 
for Call 
WaitingNoneN/AFN/AN/AFFFFFF
*
1When your KX-T series telephone system is in DPT Integration mode.
*
2When your KX-TA624 telephone system is in APT Integration mode.
N/A Not available
—Not neededTable 73 
PBX Type Other
Manufac-
turersKX-T series
T308/
T616T1232 T96 T336TD816/
TD1232/
TA1232/
TD308TA series TD500 

SYSTEM ADMINISTRATORS GUIDE
290 Installation Manual
Table 74 
Parameter Value Range
(Default)Description/Function
Integration 
Mode1. None
2. Inband
3. APT
4. DPT
(DPT)Specifies the method of integrating the VPS with the 
PBX.
1. None—Both PBX and VPS work independently, 
without accessing information concerning the status 
of the other.
2. Inband—The PBX sends touchtone codes to the VPS 
to indicate the state of the call (busy, answered, 
disconnect, etc.). Inband Integration improves the 
VPS...