Panasonic Dbs 824 Instructions Manual

FFlDoor Phone ExtensionsDoor Phones
Door Phone Extensions
Software VersionCPC-S and CPC-M, Version 1 0 and higherAddress 
FFl 8# 3# (DoorPhone)# l# (ExtPort)#
DescriptionThis program assigns the extension port that is connected to the door phone
boxCPC-S and CPC-M can handle up to 4 door phones, so up to 4
extensions can be assigned (one extension per door phone box)
However
the extension cannot be an attendant phone (ports 1 and 2)
After entering door phone ports, assign them to ring to internal...

Door Phone Ring AssignmentsFFlDoor Phone Ring Assignments
Software VersionCPC-S and CPC-M, Version 1 0 and higher
AddressFFl 8## 3# (DoorPhone)# 2# (ExtPort)# (0 or l)#
DescriptionUse this program to determine which extension(s) will ring when a door
phone caller initiates a callIt is possible to assign several or all extensions to
ring for a door phone call
Programming
FFl 6## 3# (114)# 2# (l-16 or l-24)# (0
f+
r l)#
Door Phone Number
(l-4)
Extension Port NumberCPC-S (l-16)
CPC-M (l-24)O;Do not ring...

FFlDoor Opener Access Code
Door Opener Access Code
Software VersionCPC-S and CPC-M, Version 1 0 and higherAddress 
FFl 8## 3# (DoorPhone)# 3# (OOOO-9999)#
DescriptionThis program establishes a 4-digit door opener access code which is entered
on the keypad of the extension where the door phone 
call was answered
Entering this code will ‘buzz’ (and unlock) the door
To determine the number of seconds the door will remain open use the “DoorOpener Relay Timer” address 
FFl 8# 3# 7# (0-W
Programming
FFl 8## 3#...

Door Phone Tone TypeFFl
Door Phone Tone Type
Software VersionCPC-S and CPC-M, Version 1 0 and higherAddress 
FFl 8## 3# (DoorPhone)# 4## (0 or l)#
DescriptionThis program specifies the type of tone that will be heard through the speaker
of the designated extension s phone when a door phone caller rings to get in
Programming
FFl 8# 3# (114)# 4# (0 or l)#Door Phone Number
(l-4)Tone Type (heard by extension)O=Door Chime 1 (slow)
l=Door Chime 2 (fast)
Related ProgrammingDoor Phone Ring Assignments
FFl 8# 3#...

FFlDoor Phone Ring Timer
Door Phone Ring Timer
Software VersionCPC-S and CPC-M, Version 1 0 and higherAddress 
FFl 8# 3# (DoorPhone)# 5## (O-lS)#
DescriptionThis program sets the amount of time (in seconds) that a door phone call will
ring at its designated extension before it stops ringing
If the door phonecaller re-initiates the call before this timer is up the timer will reset and will
begin ringing again
Programming
FFl 8## 3# (j4)# 5#f (Oil,,,Door Phone Number
Ring Timer (Default=3
(l-4)see the...

Door Phone Ring PatternFFl
Door Phone Ring Pattern
Software VersionCPC-S and CPC-M, Version 1 0 and higherAddress 
FFl 8# 3## (DoorPhone)# 6# (O-5)##
DescriptionThis program specifies the ring pattern of the tone that will be heard through
the speaker of the designated extension’s phone when a door phone caller
rings to get in
In this programming address, you will specify the number of
seconds between rings 
(the ring itself has a fixed duration of approximately 3
seconds)
Programming
FFl 8#3#/-4)#...

FFlDoor Opener Relay Timer
Door Opener Relay Timer
Software VersionCPC-S and CPC-M, Version 1 0 and higherAddress 
FFl 8## 3# (DoorPhone)# 7# (O-5)#
DescriptionUse this address to determine the number of seconds a “buzzing” (unlocked)
door will remain unlocked for the door phone user to enter the building
Default is 4 secondsThis timer begins immediately after the inside
extension (called party) enters the Door Opener Access Code to unlock the
door
Programming
FFl8#3#/ -4)#75)ltDoor Phone Number...

2. Trunk Programming (FF2)
Use the FF2 programming addresses in this chapter to set parameters for the
CO trunks of the DBS 824 system
Most of these 
FF2 addresses require a trunk number and/or extension port
entryThe acceptable range of trunks/extension ports varies according to the
configuration of your DBS 824 system
The basic 824 unit (no 208
Expansion Cards installed) supports 4 trunks and 8 extension portsWith one
208 EXP Card, the system will support 6 trunks and 16 extensionsWith two
208 EXP...

DBS 824-l O-400
Issued 3/l/95 

FF2I funk Port UperatlonTrunk Port Operation
Software VersionCPC-S and CPC-M, Version 1 0 and higherAddress FF2 
(Trunk)# 1# (0 or l)#
DescriptionUse this feature to put a CO trunk in service or remove it from service
Programming
1FF2 (I-6 or 
I-8)# 1# (0 or l)#Trunk Number
CPC-S l-6
CPC-M l-8
OS0 trunk is in servicel=CO trunk is out of service
NotesPrecaution on Putting Lines Out of ServiceIf a trunk is removed from
service, a new incoming caller on that trunk will hear ringing, even though
the trunk is...