NEC Neax2000 Ivs Isdn System Manual

							ND -4 5857 ( E)  CHAPTER 4
SYSTEM  DATA  P R O GRAMM ING
X
* a *b
S TA RT
CM 12
C M 35
S TA RT
CM 35 
						

							CHAPTER 4 ND-45857 (E)
Pag e 8 0
Revision 3.0
SYSTEM DATA PROGRAMMING
3.3.4 MEGACOM
® 800 Service Assignment
Refer to DID Addressing Assignment for programming instructions. 
						

							ND-45857 (E) CHAPTER 4
Page 81
Revision 3.0
SYSTEM DATA PROGRAMMING
3.3.5 CPN to Network – Presentation Assignment
For providing the calling party number (CPN) to
the network, the data programming is shown be-
low.
• When Dial-In service is provided:
DESCRIPTION DATA
Assign an ISDN Subscriber’s Number of ISDN 
Number and ISDN Local Office Code Table 
Number to required station.• YY = 12
(1) X-XXXX (Station No.)
(2) X-XXXX (ISDN subscriber’s No.)
• YY = 13
(1) X-XXXX (Station No.)
(2) 00: ISDN Local Office Code
Table No. 00 
14: ISDN Local Office Code 
Table No. 1
Specify the facility control of CPN (Calling 
Party Number).• YY = 25
(1) X-XXXX (Station No.)
(2) 0/1 : To be provided
Note 2
/Not to be provided
Assign Local Office Code of ISDN Number to 
the Table Number assigned by CM12 
YY = 13.• YY = 05
(1) 00: ISDN Local Office Code
Table No. 00 
14: ISDN Local Office Code
Table No. 14 
(2) X...X:Local Office Code 
(Max. 12 digits)
DIAL “516-555-4210#”
(214-555-5000)
(214-555-5001)
(214-555-5002)
CALLING PARTY No.DTI PBX
ISDN
516-555-4210
+214-555-5000
CALLING PARTY No.
4210
CM12
CM13
CM50
END
START
~
~
~~ 
						

							CHAPTER 4 ND-45857 (E)
Pag e 8 2
Revision 3.0
SYSTEM DATA PROGRAMMING
• When BRI Terminals are used:
Note 1:The ISDN Number consists of the following numbers:
ISDN Number: XXXXXXXXXXXX  YYYY
This number must be in the indial range assigned by Telecom for the ISDN line.
For example:
National Destination Code for Dallas: 214
Local Code for a station: 518 - 5000
In this case, the ISDN Number is National Destination Code + Local Code = 214518 - 5000
That is:
ISDN Subscribers No. assigned byCM12 YY = 12 is 5000.
ISDN Local Office Code assigned by CM50 YY = 05 is 214518.
Note 2:The following facility control services for CPN are available in accordance with the subscription category of dis-
tant ISDN exchange. In case of no subscription, CPN to Network  – Present is not available.
Station 5000 places an outgoing call to an ISDN subscriber. Because CM13–25 is set to 0, the ISDN network is in-
structed to not send 214-518-5000 (see Note 1 above) to the distant ISDN subscriber.
Station 5001 places an outgoing call to an ISDN subscriber, and 214-518-5001 is sent to the called party.DESCRIPTION DATA
The BRI Terminal can send the CPN to Net-
work without using PBX programming.(1) 434
(2) 0:  Use Calling Number Set in BRI 
Terminal.
1  : Use Programming in CM 12 
YY=12, 13
Example:
1st Data  2nd Data Meaning
CM13 YY = 255000 0 Restrict transfer
5001 1 Permit transfer
CM08
END
START
ISDN subscriber’s No. assigned by CM12 YY=12
(1-4digits)
ISDN Local Office Code assigned CM50 YY=05
(1-12digits) 
						

							ND-45857 (E) CHAPTER 4
Page 83
Revision 3.0
SYSTEM DATA PROGRAMMING
• When Dial-In service is not provided:
DESCRIPTION DATA
Specify the sending out of CPN (Calling Party 
Number).• YY = 25
(1) X-XXXX:  Station No. 
(2) 0/1  : To be sent out
Note 2
/Not to be sent out
Assign an ISDN subscriber’s Number of ISDN 
Number to each ISDN trunk. • YY = 19
(1) Trunk No. (000 – 255) assigned by CM07 
YY = 01
(2) XXXX: ISDN Subscriber’s No. 
Assign ISDN Local Office Code Table  Number 
to each ISDN trunk. • YY = 34 
(1) Trunk No. (000 – 255) assigned by CM07 
YY = 01 
(2) 00: Local Office Code Table No. 00
14: Local Office Code Table No. 14 
Assign Local Office Code of ISDN Number Ta-
ble Number assigned by CM30 YY = 34.• YY = 05 
(1) 00: ISDN Local Office Code 
Table No. 00 
14: ISDN Local Office Code 
Table No. 14 
(2) X...X: Local Office Code
(Max. 12 digits)
DIAL “516-555-4210#”
(214-555-5000)CALLING PARTY No.
DTI PBX
ISDN
516-555-4210
#214-555-5000
CALLING PARTY No.
555-4210
START
CM13
CM50
CM30
END
~~
~~ 
						

							CHAPTER 4 ND-45857 (E)
Pag e 8 4
Revision 3.0
SYSTEM DATA PROGRAMMING
Note 1:The ISDN Number consists of the following number.
ISDN Number: XXXXXXXXXXXX  YYYY
For example:
National Destination Code for Melbourne:  214
Local Code for the ISDN line: 518 - 5000
In this case, the ISDN Number is National Destination Code + Local Code = 214518 - 5000
That is:
ISDN Subscribers No. assigned by CM30 YY = 19 is 5000.
ISDN Local Office Code assigned by CM50 YY = 05 is 214518.
Note 2:The following facility control services for CPN are available in accordance with the subscription category of dis-
tant ISDN exchange. If no subscription, CPN to Network – Present is not available.
2nd Data of
CM13 YY = 25Subscription Category of
Distant ISDN exchange CPN to Remote Side
0: To be provided Permit Transfer
Restrict TransferNot Available
Available
1  : Not to be provided Permit Transfer
Restrict TransferAvailable
Not Available
ISDN subscriber’s No. assigned by CM30 YY=19
(4digits)
ISDN Local Office Code assigned CM50 YY=05
(1-12digits) 
						

							ND-45857 (E) CHAPTER 4
Page 85
Revision 3.0
SYSTEM DATA PROGRAMMING
3.3.6 CPN to Terminating User – Display Assignment
No programming is required.
3.3.7 Subaddress – Addressing Assignment
When the system has received a Called Party
Sub-address (Calling Station Number) from an
ISDN subscriber, the system makes the connec-
tion with the specified terminal.
DESCRIPTION DATA
Specify the terminating system for Called Party 
Subaddress.(1) 401  
(2) 0: Station Call
1  : Terminating System assigned by 
CM30 YY = 02/03
214-555-5000 + 4211
DIAL 214-555-5000 
+ 4211
SUBADDRESS ISDN DTI PBX
4210
4211
4212
START
END
CM08 
						

							CHAPTER 4 ND-45857 (E)
Pag e 8 6
Revision 3.0
SYSTEM DATA PROGRAMMING
3.3.8 Subaddress – Present Assignment
When a station has dialed an ISDN subscriber’s
number, the station number is automatically sent
as a calling Party Subaddress.
3.3.9 Trunk Provisioning Service Selection AssignmentDESCRIPTION DATA
Provide the system with Calling party Subad-
dress to an ISDN network.(1) 400
(2) 0: To be sent out
DESCRIPTION DATA
Assign the Trunk Route to the Trunk No. as-
signed by CM07.• YY = 00 (Trunk Route Allocation)
(1) Trunk No. (000 – 255) assigned by CM07 
YY = 01.
(2) Route No. (00 – 63)
555-5000 ISDN DTI
4211
CALLING PARTY
SUBADDRESS 4211 PBX
DIAL
214-555-
5000
START
END
CM08
START
END
CM30 
						

							ND-45857 (E) CHAPTER 4
Page 87
Revision 3.0
SYSTEM DATA PROGRAMMING
3.3.10 Automated Attendant Assignment
DESCRIPTION DATA
Assign the Trunk Route. • YY = 00
(1) Trunk No. (000 – 255)
(2) Trunk Route (00 – 63)
Assign the Trunk Tenant. • YY = 01
(1) Trunk No. (000 – 255)
(2) Trunk Tenant (00 – 63)
If no data is set, the default setting is 01.
Assign the data for Automated Attendant to re-
quired trunks.• YY = 02 (Terminating System in Day 
mode)
• YY = 03 (Terminating System in Night 
mode)
(1) Trunk No. (000 – 255)
(2) 18: ISDN Indial
• YY = 30 (Handling of busy/not available 
Automated Attendant destination in Day 
mode)
• YY = 31 (Handling of busy/not available 
Automated Attendant destination in Night 
mode)
(1) Trunk No. (000 – 255)
(2) 00: C.O. Line Release 
01: Forwarded to TAS 
03: Forwarded to ATTCON 
04: Forwarded to DIT Station 
06: DT Connection for redial 
08: 2nd Answering Message followed by 
DT Connection for redial  
15   : C.O. Line ReleaseCM30 START
A 
						

							CHAPTER 4 ND-45857 (E)
Pag e 8 8
Revision 3.0
SYSTEM DATA PROGRAMMING
DESCRIPTION DATA
• YY = 32 (Handling of timed-out
Automated Attendant in day mode)
• YY = 37 (Handling of time-out Automated 
Attendant in night mode)
(1) Trunk No. (000 – 255)
(2) 00: C.O. Line Release
01: Forwarded to TAS
03: Forwarded to ATTCON
04: Forwarded to DIT Station
06: DT Connection for redial
15   : C.O. Line Release
• YY = 33 (In case YY = 30, 31 is set to data 
08, if all DTMF Receivers are busy.)
(1) Trunk No. (000 – 255)
(2) 00: Disconnection
01: Forwarded to TAS Indicator
03: Forwarded to SN610 ATTCON
15 : Disconnection
Assign the data for DID to the Trunk Routes. • YY = 00 (Kind of Trunk)
(1) Trunk Route No. (00 – 63)
(2) 00: ISDN Trunk
• YY = 12 (Number of digits to be received)
(1) Trunk Route No. (00 – 63)
(2) 0: 1 digit
1: 2 digits
2: 3 digits
3   : 4 digits
• YY = 18 (Received Digit Conversion)
(1) Trunk Route No. (00 – 63)
(2) 0/1  : To be provided/Not to be provided
CM30
B
A
CM35