NEC Neax2000 Ivs Command Manual

CHAPTER 3 ND-45669 (E)
Pag e 1 16
Revision 2.0
CM17
COMMAND CODE
TITLE:
UCD GROUP
17
MAT
4. DATA TABLE:
Note 1:Station numbers should be individually assigned to an ACD / UCD Group, as shown below.
STATION No. (A)STATION No. (B)
1st operation STN 1 STN 2
2nd operation STN 2 STN 3
Last operation STN n STN 1
(STN 1–STN n: Station Numbers included in an ACD / UCD Group)
Note 2:After data setting, lift the handset once, to activate the ACD / UCD function, at each ACD / UCD station.
1. FUNCTION:
This command...

ND-45669 (E) CHAPTER 3
Pag e 1 17
Revision 2.0
CM17
COMMAND CODE
TITLE:
UCD GROUP
17
MAT
: Initial Data
Y STATION NUMBER (A) SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING DATA MEANING
1
(Pilot 
STA 
No.)Assignment of the Pi-
lot Station in the 
ACD/UCD GroupX
XXXXStation Number to be 
assigned as Pilot0
 
1Member Station
Pilot Station
Assignment of Pilot 
Station Number and 
Member Station for 
SCF of OAIX
XXXXStation Numbers to 
be assigned to queu-
ing for SCF2
3Member Station
Pilot StationCM41...

CHAPTER 3 ND-45669 (E)
Pag e 1 18
Revision 2.0
CM18
COMMAND CODE
TITLE:
STATION HUNTING GROUP
18
MAT
1. FUNCTION:
This command is used to assign stations to a Station Hunting Group. There are three hunt types: Pilot
System, Circular System and Switch Back System.
2. PRECAUTION:
(1) When a Station Hunting Group requires a secretary station, it is necessary to assign Y=2.
(2) The maximum number of stations which can be assigned to a Station Hunting Group is 60.
(3) There is no limit to the number of...

ND-45669 (E) CHAPTER 3
Pag e 1 19
Revision 2.0
CM18
COMMAND CODE
TITLE:
STATION HUNTING GROUP
18
MAT
4. DATA TABLE:
(1) Pilot System
: Initial Data
Y STATION NUMBER (A) SETTING DATA
No. MEANING DATA MEANING DATA MEANING
0 Setting of Station num-
bers included in a Station 
Hunting GroupX
XXXXStation Number (A)/
Data Station Number (A)X
XXXXStation Number (B)/
Data Station Number (B)
When assigning station numbers to a Station Hunting Group, only two station 
numbers can be assigned per operation.  By...

CHAPTER 3 ND-45669 (E)
Pag e 1 20
Revision 2.0
CM18
COMMAND CODE
TITLE:
STATION HUNTING GROUP
18
MAT
: Initial Data
Y STATION NUMBER (A) SETTING DATA
No. MEANING DATA MEANING DATA MEANING
2 Secretary Station:
If an incoming call ter-
minated to a Station 
Hunting Group has en-
countered all lines busy, 
the call is routed to a des-
ignated station. This sta-
tion is called “Secretary 
Station.”X
XXXXSecretary Station Number 00
30
31 Secretary Station Serial
Numbers:
Serial Numbers to be as-
signed to...

ND-45669 (E) CHAPTER 3
Addendum-001 Page 121
AUGUST, 1998 Revision 2.1
CM18
COMMAND CODE
TITLE:
STATION HUNTING GROUP
18
MAT
(2) Circular System
: Initial Data
Y STATION NUMBER (A) SETTING DATA
No. MEANING DATA MEANING DATA MEANING
0 Setting of Station
Numbers included in a 
Station Hunting GroupX
XXXXStation Number (A)/
Data Station Number (A)X
XXXXStation Number (B)/
Data Station Number (B)
Example:A station Hunting Group that employs the Circular System hunt type 
and consists of Station Numbers 310,...

CHAPTER 3 ND-45669 (E)
Pag e 1 22
Revision 2.0
CM18
COMMAND CODE
TITLE:
STATION HUNTING GROUP
18
MAT
(3) Switch Back System
: Initial Data
Y STATION NUMBER (A) SETTING DATA
No. MEANING DATA MEANING DATA MEANING
0 Setting of Station Num-
bers included in a Station 
Hunting GroupX
XXXXStation Number (A) /
Data Station Number (A) X
XXXXStation Number (B) /
Data Station Number (B) 
Example:A Station Hunting Group, which employs the Switch Back System 
hunt type and consists of Station Numbers 320, 321, 322...

ND-45669 (E) CHAPTER 3
Pag e 1 23
Revision 2.0
CM18
COMMAND CODE
TITLE:
STATION HUNTING GROUP
18
MAT
: Initial Data
Y STATION NUMBER (A) SETTING DATA
No. MEANING DATA MEANING DATA MEANING
2 Secretary Station:
Same as Pilot System
Example:X
XXXXSecretary Station Number 00
30
31 Secretary Station Serial 
Number:
(Same as Pilot System) 
Data can be set to all stations 
belonging to the Switch Back 
System. Also, each station 
belonging to the same Hunt-
ing Group can be assigned its 
own Secretary Station....

CHAPTER 3 ND-45669 (E)
Pag e 1 24
Revision 2.0
CM19
COMMAND CODE
TITLE:
SECRETARY/GROUP DIVERSION STATION NUMBER
19
MAT
4. DATA TABLE:
Note:The Secretary Station Serial Number should be assigned individually in the order of the desired secretary
hunting, as shown below.
SECRETARY STATION SECRETARY STATION
SERIAL No. (A)
SERIAL No. (B)
1st operation Secretary 0 Secretary 1
2nd operation Secretary 1 Secretary 2
1. FUNCTION:
Station numbers corresponding to Secretary Station Serial Numbers are to be...

ND-45669 (E) CHAPTER 3
Pag e 1 25
Revision 2.0
CM1A
COMMAND CODE
TITLE:
DATA STATION NUMBER
1A
INITIALMAT
4. DATA TABLE:
(1) Primary Extension Numbers are given by CM10 (FX–FXXXX).
(2) Data Station Number should be different from station number,
Primary Extension Number and Multiline Station Number assigned by CM10 and CM11.
1. FUNCTION:
This command is used to assign the Data Station Numbers for accommodating the data terminals via the
Multiline Terminal.
2. PRECAUTION:
(1) This command requires a...