NEC Neax2000 Ivs Command Manual

CHAPTER 3 ND-45669 (E)
Page 78 Addendum-002
Revision 2.2 JANUARY, 1999
CM08
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
: Initial Data
BASIC SERVICE FEATURE SETTING DATA
176 1000-Slot Memory Block Number “2” for Station Speed Di-
aling is used as the Memory Block for System Speed Dialing.0
1
 
Available
Not available
177 Last Number Redial feature for DP/DTMF telephone. 0
1
 
Available (See CM20 - 069)
Not available
178 Last Number Redial/Stack Dial for internal calls 
(effective only when data 177 is...

ND-45669 (E) CHAPTER 3
Addendum-001 Page 79
AUGUST, 1998 Revision 2.1
CM08
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
: Initial Data
BASIC SERVICE FEATURE SETTING DATA
204 Diversion display by ATTCON. 0
1
 
Available
Not available
205 LDN Diversion by ATTCON.
(See CM58)0
1
 
Available
Not available
206 Trunk to Trunk Transfer by an Attendant before answer (on 
the OG trunk).0
1
 
Available
Not available
208 Dialing of a Single Digit Feature Access Code, while the call-
ing station hears busy tone.0
1...

CHAPTER 3 ND-45669 (E)
Pag e 8 0
Revision 2.0
CM08
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
232 Trunk access from a station in Room Cut-Off Status. 0
1
 
Restricted to C.O. only
Restricted to all Trunk Routes.
233 Message Waiting lamp of calling station is extinguished when 
an attendant answers (See CM13-13)0
1
 
Assigned
Not assigned
234 Whether Message Waiting/Message Reminder is reset (turn-
ing the MW Lamp off) irrespective of answering of calling 
station when the called station calls to...

ND-45669  (E)   CHAPTER 3
CM 08
250  Destina ti o n o f Pr iori ty  Call  0.   0
FN C 

CHAPTER 3  ND-45669  (E)
C M 08
268  Call  ter min ation t o M y L in e whi le  the  ext en sio n m ake s a  ca ll  

ND-45669 (E) CHAPTER 3
Addendum-001 Page 83
AUGUST, 1998 Revision 2.1
CM08
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
: Initial Data
BASIC SERVICE FEATURE SETTING DATA
311 Display last calling station number.
Note:This is only applicable for an ETJ-16DC-1, an ETJ-
16DD-1 or an ETJ-24DS-1.0
1
 
6 seconds
Until next call
319 On a Tie Line outgoing call with answer signal, transferring/
holding the call before distant called station answers. (Effec-
tive only when CM35 YY = 00 is 03 or 04 and CM35 YY =...

CHAPTER 3 ND-45669 (E)
Page 84 Addendum-001
Revision 2.1 AUGUST, 1998
CM08
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
362 Confirmation tone after dialing the access code for Account 
Code/Authorization Code/Forced Account Code.0
1No tone
Service Set Tone (SST)
363 For the Automated Attendant call, caller dials while sending 
message or music.0
1Not allowed (Allowed after sending 
the message or music)
Allowed
365 Sending Dial Tone when holding a trunk by HOLD key 
(CM90 YY=00-F0058).0
1To send
Not...

ND-45669  (E)   CHAPTER 3
CM 08
378  Centr aliz ed  Billin g-CCIS fe atu re for lo ca l o ffi ce   0
IN IT IA L
IN IT IA L
FNC
IN IT IA L 

CHAPTER 3 ND-45669 (E)
Pag e 8 6
Revision 2.0
CM08
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
405 Consecutive Speed Dialing when making an ISDN call. 0
1
 
Available
Not available
424 Method of charging a transferred call (for use with CP03 
(MP) only)0
1Charging to the transferring station or 
the transfer destination station.
Split charging to both the transferring 
station and transfer destination station.
425 Charging to the transfer destination station or the transferring 
station (for use with...

ND-45669 (E) CHAPTER 3
Pag e 87
Revision 2.0
CM08
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
432 Forced release when a called ISDN Terminal is no answer 
during 3 minutes0
1Not available
Available
434 Assignment of the calling party number which is sent to an 
ISDN network when making a call from ISDN Terminal0
1Calling Party No. entered in ISDN 
Terminal
Calling Party No. assigned by CM12 
YY= 12/13
441 Recall display on the SN610 ATTCON. 0
1Available
Not available
442 UCD Busy Out from Sub-line 0...