NEC Neax2000 Ivs Command Manual
Here you can view all the pages of manual NEC Neax2000 Ivs Command Manual. The NEC manuals for Communications System are available online for free. You can easily download all the documents as PDF.
Page 191
CHAPTER 3 ND-45669 (E) Pag e 1 62 Revision 2.0 CM35 COMMAND CODE TITLE: TRUNK ROUTE DATA 35 MAT 4. DATA TABLE: : Initial Data YY/YYY SETTING DATA RELATED COMMAND No. MEANING DATA MEANING 00 (TK)Kind of Trunk Route 00 01 02 03 04 05 06 15 DDD (C.O., DID) Trunk/ISDN Trunk FX Trunk WATS Trunk CCSA Trunk TIE (Tie Line) Trunk Paging Trunk/Interface with BGM Tone Source and Wake-Up Announce Not used 01 (PBDP)Dialing Signal Type 0 1 2 3 4 5 6 7 [Call Termination] [Call Origination] DP DP DTMF DTMF DP/DTMF...
Page 192
ND-45669 (E) CHAPTER 3 Pag e 1 63 Revision 2.0 CM35 COMMAND CODE TITLE: TRUNK ROUTE DATA 35 MAT 04 (ANS)Application of answer signal from the distant office for out- going connection.0 1 2 3 4 7 Battery Reversal (C.O. line) Answer Signal arrives (Tie line/ISDN) Answer Signal does not arrive (Polarity Reversal is ignored and Answer timing shall be set by CM41 Y=0 Function No. 03) Answer Signal does not arrive (Tie line/ C.O. Line, Answer timing shall be set by CM41 Y = 0 Function No. 03) 05...
Page 193
CHAPTER 3 ND-45669 (E) C M 35 MAT 11 Ra dio Pag ing TRK De termin ed by 2 dig it s + S T N ~~
Page 194
ND-45669 (E) CHAPTER 3 Pag e 1 65 Revision 2.0 CM35 COMMAND CODE TITLE: TRUNK ROUTE DATA 35 MAT 15 (ICI)Kind of Call Termination Indi- cator Key/Lamp on ATTCON. With respect to incoming calls of the same kind (C.O. Incom- ing Calls, Tie Line Incoming Calls), Call Termi- nation Indicator lamps on the ATTCON, the kinds of incom- ing calls are further catego- rized. Note 1:When standard lamp indications are uti- lized, assign data for standard assign- ment for each incom- ing call. Note...
Page 195
CHAPTER 3 ND-45669 (E) Pag e 1 66 Revision 2.0 CM35 COMMAND CODE TITLE: TRUNK ROUTE DATA 35 MAT 16 (SHF)Sending of Hook Flash to out- side0 1 Not sending SendingCM90 YY = 00 DATA = F1009 CM41 Y = 2 Function No. = 17 17 (SKP)Digit addition and deletion at the time of a Tie Line Incom- ing Call: On an incoming call from a Tie Line, if number of digits arriving from distant of- fice does not coincide with number of digits of a station number, the number of digits is to be adjusted by this data...
Page 196
ND-45669 (E) CHAPTER 3 Pag e 1 67 Revision 2.0 CM35 COMMAND CODE TITLE: TRUNK ROUTE DATA 35 MAT 21 (PPT)Sender Prepause Timing 00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 0 sec 0.5 sec 1.0 sec 1.5 sec 2.0 sec 2.5 sec 4.0 sec 5.0 sec 6.0 sec 7.0 sec 8.0 sec 9.0 sec 10.0 sec 11.0 sec 12.0 sec 3.0 secCM08-193, 194, 331 CM35 YY = 43 22 Automatic Live Recording Activation0 1 Start automatically Not available Note:When this command is activated, data assignments must also be made in CM08-141, CM35, YY =...
Page 198
ND-45669 (E) CHAPTER 3 Pag e 1 69 Revision 2.0 CM35 COMMAND CODE TITLE: TRUNK ROUTE DATA 35 MAT 44 (S2DC)Trunk Access Code sent to SMDR for outgoing call000 or 999When a trunk is seized by a Trunk Appearance key or LCR, one or two-digit code (00-99) is sent out to the SMDR. 45 (RDP)DP sender release timing 0 1 2 3 4 5 6 7 2 sec 4 sec 6 sec 8 sec 12 sec 14 sec 16 sec 10 sec 46 (RPB)DTMF sender release timing 0 1 2 3 4 5 6 7 2 sec 4 sec 6 sec 8 sec 12 sec 14 sec 16 sec 10 sec 48 Sending Busy/Idle...
Page 200
ND-45669 (E) CHAPTER 3 Pag e 1 71 Revision 2.0 CM35 COMMAND CODE TITLE: TRUNK ROUTE DATA 35 MAT 69 (AN0)Announcement Service Group 00 1 Restricted AllowedCM20, A03-A09 CM49 YY = 00 – 04XX CM15 YY = 34 – 39 70 (AN1)Announcement Service Group 10 1 Restricted Allowed 71 (AN2)Announcement Service Group 20 1 Restricted Allowed 72 (AN3)Announcement Service Group 30 1 Restricted Allowed 73 (AN4)Announcement Service Group 40 1 Restricted Allowed 74 (VRAN)Attendant Delay Announce- ment0 1 Allowed...