NEC Neax 2400 Ipx Hotel Feature Programming Manual

NEAX2400 IPX Hotel Feature Programming Manual
NDA-24304, Issue 1Page 177
Maid Status M-22
12 ARTDAssign route data of the trunk interfacing with the announcement unit.
(OSGS = 2, TCL = 4, LSG = 5 should be set.)
13 ATRK Assign the trunk interfacing with announcement unit.
14 MBTK Release the Make Busy of the trunk assigned in ATRK.
15 ARSCRelease the call restrictions between the RSC of the station accessing the announcement unit and the
route of the trunk assigned in ATRK.
(RRI = 2, 3)
16 AAEDAssign the...

NEAX2400 IPX Hotel Feature Programming ManualPage 178NDA-24304, Issue 1
M-51 Manual Switching Of C.O. Incoming Call Destination
M-51Manual Switching Of C.O. Incoming Call
Destination
General Description
This feature allows the Console operator to manually change the termination point of a specific group of trunks.
Trunks that normally are used as DIT trunks may be changed to terminate at the Console.
Operating Procedure
To change the termination of DIT trunks from stations to the Console
1. Press...

NEAX2400 IPX Hotel Feature Programming Manual
NDA-24304, Issue 1Page 179
Maid Status - Answerback M-68
M-68Maid Status - Answerback
General Description
This feature allows a maid or other hotel personnel to receive answerback acknowledgment from the PMS (Property
Management System) computer when MAID STATUS has been changed using Guest room station or Special
Administration Station telephones.
Operating Procedure
Service setting from a Guest room station by a maid or repairman
1. Lift handset. Hear dial...

NEAX2400 IPX Hotel Feature Programming ManualPage 180NDA-24304, Issue 1
M-68 Maid Status - Answerback
Assignment Procedure
STEP CMND BIT EXPLANATION
1SYS1
ASYD
INDEX
163b
0Over Time Call timer.
b
1
b2Over Time Call
0/1 = Out/In Service
b
3Over Time Call indication
0/1 = On Console/Hotel Printer
b
4Step Call from Guest Station is allowed
0/1 = Out Service/In
b
5Tone type for Maid Dialing
b
6b5b6b5
0 0 = SST 1 0 = –
0 1 = Announcement 1 1 = Music on Hold b6
b7Start time of Automatic Wake-Up Call
0/1: On...

NEAX2400 IPX Hotel Feature Programming Manual
NDA-24304, Issue 1Page 181
Maid Status - Answerback M-68
Note:Room Cutoff (RSC 13)
Do Not Disturb (RSC 14)
Room Cutoff and Do Not Disturb (RSC 15)
3SYS1
ASYD
INDEX
170b
0Room status data (b2,b1,b0)tobesetatthetimeofCheckout
b
2b1b0b2b1b0000=– 010=Cleaned
0 0 1 = To be Cleaned 0 1 1 = Ready for Occupancy
Note:
Do not assign other data.
b1
b2
b3Restriction at the time of Do not Disturb and Room Cut-Off
0/1 = Room Status Memory/Change of RSCNote
b
4Timing Start...

NEAX2400 IPX Hotel Feature Programming ManualPage 182NDA-24304, Issue 1
O-6 Off-hook Alarm
O-6Off-hook Alarm
General Description
The OFF-HOOK ALARM feature is intended for emergency alert situations. A station user who remains off-hook
without dialing for longer than 30 seconds is automatically routed to theEMGkey on the Console or to a
predesignated station.
Operating Procedure
1. Station user goes off hook. After 30 seconds, a call is routed to theEMGkey on the console or to a
predetermined station.
2....

NEAX2400 IPX Hotel Feature Programming Manual
NDA-24304, Issue 1Page 183
Off-hook Alarm O-6
Assignment Procedure
 When the Off-Hook Alarm termination is a Console:
STEP CMND BIT EXPLANATION
1SYS1
ASYD
INDEX
6
Noteb
0Special Transmitting Tone When Using Sender (Station)
0/1 = Not Required/Required (used with LCR/Speed Calling, etc.)
b
1Not used
b
2Special Transmitting Tone When Using Sender (ATT)
0/1 = Not Required/Required (used with LCR/Speed Calling, etc.)
b
3Not used
b
4
Assign ATT Pattern 1 or 2....

NEAX2400 IPX Hotel Feature Programming ManualPage 184NDA-24304, Issue 1
O-6 Off-hook Alarm
Note:This data is required for sending Howler Tone from Hotel Attendant. Refer to SERVICE CONDITIONS.
 When the Off-Hook Alarm destination is a specific station:
3SYS1
ASYD
INDEX
168b
0Group Announcement Service through PMS
0/1 = Out/In Service
b
1Audit Reports (for Hotel system)
0/1 = Out/In Service
b
2Not used
b
3
b4Off-Hook Alarm (service)
0/1 = Out/In Service
b
5Destination for Off-Hook Alarm Termination
0/1 =...

NEAX2400 IPX Hotel Feature Programming Manual
NDA-24304, Issue 1Page 185
Off-hook Alarm O-6
4ASIDAssign the connection destination to the above GN.
F: Off-Hook Alarm
GN: Group Number assigned in ASGD
S/A: Special Station (Assign S.)
SSTN: Terminated Special Station Number
5ATNRPermit the connection between the special station number tenant and the tenant of the terminating
Off-Hook Alarm station. STEP CMND EXPLANATION 

NEAX2400 IPX Hotel Feature Programming ManualPage 186NDA-24304, Issue 1
O-9 Overtime Call
O-9Overtime Call
General Description
The OVERTIME CALL feature permits the NEAX2400 IPX to measure the length of all outgoing calls, and to print
a message on the hotel printer or alert the Console that the call has exceeded a predetermined time.
Operating Procedure
If the hotel printer is to receive this information, no manual operation is required.
To operate from the Console
1. The OT lamp flashes and an incoming...