Mitel Voice Processing Solutions Installation And Service Manual

(0 Configure Coding format
Configure Frame Coding for Board [ 
] in AT
slot xx Trunk x
(A) AM1 coding
(B) Ah41 with ZCS coding
(C) B8ZS coding
(D) HDBS coding
(X) exit
(D) Display current configuration
(F) reset to de~~~l~Xir
(S) Show board configuration
(W) show default configuration
(X) eXit
(K> digital card clocK reference8.Digital Clock Reference Configuration Menu
(I) set to Internal clock reference
(N) set to Network clock reference
(D) set to Default clock reference
(S) Show current clock...

Index
AAISEl, 1-6
Tl, 2-10
alarm
failure timing, 
2- 11
reporting, 2-10
alarms, carrier group alarm, 
2- 1
alternate mark inversion, 2-5
AMI, 2-16. CP 3151
AM1 with ZCS, 2-16analog applications, mixing digital and analog, 2-6
analog trunks
mixed with digital, 1-2
with El digital trunks, l-5
automatic exit, avoiding, xii
B
B8ZS, 2-l 6
backup clock source, automatic switchover, 1 - 10, 2- 16bearer channels, l-4
bipolar violations, 2-6
bit errorsEl, 1-6
Tl, 2-10
bus clock, MVIP bus, l-5, 2-9
bus master,...

Index
extended superframe, 2-2
framing format, 2- 15
Ffailed seconds
El, 1-6
Tl, 2-10
frame slips, 1-6El, l-6
Tl, 2-10
framing format
CEPT4, CP 3151
CRC, CP 3151
G
Ground start, 2- 150viewing complete, xi
monitoring, trunk conditions and events
El, l-6
Tl, 2-10
MVIP bus master, 
l-5, 2-9
N
network clockbackup, 
l-5,2-9
changing, CP 3 152channel banks, 2-9
El, 1-5
extraction, l-3
reference, 1 - 10,2- 16*.
system reference, l-10,2- 16
Tl, 2-9
NRZ, 2-4HDB3, 1-3, l-9. CP 3151
I
I/O addresses, l-8,2- 15
I/O...

Index
El and SS7, 1-9on trunk channels, CP 3 150robbed-bit, 2-4
slot assignmentsModel 120, 
l-8,2-14Model 640, 1-8, 2-14
Model 70, 
l-8,2-14ss7
connection, l-3
ISUP, l-4
statistics, digital trunk statistics, CP 3 153
system clockEl, 1-3
network clock reference, 
I- 10, 2- 16
reference, 
1-I 0,2- 16T
timeouts, avoiding, xii
trunk configuration
El, l-7
Tl, 2-13
trunk failures,alarms, l-6,
2- 10
trunk monitordisplay, CP3 153trunk number,
CP 3 150W
warnings, documentation conventions for, x
ZIZCS, 2-6
zero...

Issue 1 Release 2.0 January 1996
1 VoiceProcessingSolutions 1
TM, 8 - Trademark of Mite1 Corporation
0 Copyright 1996, Mite1 Corporation
All rights reserved.
Printed in Canada.
PMS Integration
Manual
8. 

Table of ContentsSubject
Overview . . . . . . . . . . . .
Installation, All Integrations
........................................
........................................
PageConfiguration of EECO and HIS Integrations
...........................
EECO Trouble Shooting Guide
.....................................
1.0
2.0
3.0
4.0
HIS Trouble
1.0
2.0
3.0
4.0
5.0
6.0
7.0Implementation
......................................
Protocol...........................................
Physical...

OverviewChapter 1
Overview of PMS lntearations
This document describes how to install, configure and trouble shoot three of Centigram’s
PMS integrations.This information is an expanded version of the Appendix G of the
Installation and Maintenance manual.
There are three PMS Integrations discussed in this document:
1.The EECO PMS Integration
2.The HIS PMS Integration
3.The Encore PMS IntegrationAll the integrations provide the same basic features on room check-in and check-out.
The EECO and HIS...

Installation, All Integrations
Chapter 2
The PMS lntearation installation
INSTRUCTIONS: (For all three Integrations (EECO, HIS, Encore)1.
2.
3.
4.
5.Insert the 
VoiceMemo serialized PMS Integration diskette in the floppy drive.
Execute a 
(S)ystem Shutdown under the System Maintenance console program,
to insure no calls in progress are cut-off. Push the reset button located on the
back of the 
VoiceMemo unit.
After console has displayed “BOOT FROM FLOPPY?” DO NOT INPUT ANY
RESPONSE! The next command will...

VOICEMEMO CONFIGURATION - Offline Menu
--w-e-
(A)
(L)
(W
0-l
(D)
I:;
(S)
(y>
i?
(Cl
(Q)
(xlLinegroup Only Applications
Linegroup and RS232 Only Applications
RS232 Only ApplicationsDTMF to PBX Message tights
Pre-Extension Dial StringDefine tine Groups
Network Menu
Auto-Gather 
- System Billing
System 75 Menu
System 85 Menu
SL-1 /MERIDIAN MenuReport Current Configuration
Quit -- Forget Changes
Exit 
- Save Changes
Input an 
“M” for RS232 Only Applications Menu. The next menu will be as follows:
RS232 Only...