Mitel Voice Processing Solutions Installation And Service Manual

System Administration Task listPage 1 of 1
VoiceMemo Release 6.OA and later
TaskProcedure
System AdministrationActivate New Software......................................................................Cl? 7025
Add or Cancel a Phoneline Exception...............................................
Cl? 7022
Back Up a Class of Service
................................................................Cl?5412
Change Module
StatusFromHard Disk...........................................Cl’5314
Diagnose a Disk With...

cp 5303Recover a Lost Console 
PasscodePage 1 of 1VoiceMemo Release 6.OA and later
This procedure describes how to access the console after the Root or Super-user console
passcode has been lost.
It is assumed the module attached to the console has been shut down following the
procedure listed in CP 6268.
WARNING!This procedure requires the server to be removed from normal operation.
Centigram recommends that you run this process during periods of low
call 
trafhc.
Step8.
1.Start the Series 6 server and...

CP 5304View or Edit History FilePage 1 of 1
VoiceMemo Release 6.OA and later
The History File is a record of modifications made to the server. Entries are made to the
record by the system administrator, your distributor, or Centigram technical personnel.
You must review this record prior to updating software on the server to verify that no
custom changes have been made to the server that are over-written with the new
software.This procedure describes how to view or edit the History File.
step
1.Reach the...

View Hard Disk Operational ParametersPage 1 of 2VoiceMemo Release 6.OA and later
This procedure describes how to determine the hard disk size and manufacturer.
Step
1.Reach the System Maintenance Menu, then go to the Hard Disk Utilities Menu.
2.Review the hard disk information.
Select:(0) Display the Operation Parameters for a disk
Prompt: Enter the hard disk as bus:id pair:
Response: The bus and SCSI ID numbers, separated by a colon, of the disk to be
reviewed.
0The following is a sample Operational...

CP 5313
Page 2 of 2
VoiceMemo Release 6.OA and later
StepPage 3 
- Format Parameters
Tracks per zone:6Alternate sectors per zone:3Alternate tracks per zone:0Alternate tracks per logical unit: 6
Sectors per track:
-74
Data bytes per sector:512
Interleave factor:
1
Track skew factor:23
Cylinder skew factor:29Flags:
0x40
Changeable page 3 data:
*.
tpz=o,aspz=65535, atpz=O
atpl=65535,sec_per-trk=O,data-bytes=65535interleave=O, trk-skew=O, cyl-skew=O,flags=OxOPage 4 
- Drive Geometry Parameters
Number of...

cl? 5314
Change Module Status From Hard Disk
Page 1 of2
VoiceMemo Release 6.OA and later
This procedure describes how to change the status of a module using the Maintenance
From Hard Disk Menu. When changing the status of multiple modules, always change
the one the console is attached to last.
FOR THE MODEL 120 AND MODEL 70 ONLY: Some system prompts in thisprocedure may contain generic references to other multiple-module Centigram Series 6
products. In such cases, shaded areas indicate a difference in...

CP 5314Page 2 of 2
VoiceMemo Release 6.OA and later
Refirence
GBDisable The Module
6.Shut down the module.
Select:(D) DISABLE a module
Prompt: Input a module id in the following range:
n n 
n nWhich module?
Response: Enter the number of the module you want to shut down. (Enter 1 or a
for 
AIP120/70.)8.
Note:When changing the status of multiple modules, change the
module attached to the console last.
Prompt: Type disableto confirm your request:
Response: disableThe module you specify automatically resets...

c&412Back Up a Class of ServicePage 1 of 1
VoiceMemo Release 6.OA and laterThis procedure describes how to back up the defined Classes Of Service (COS) for the
system. This program should be run in addition to the floppy backup program. This
program is not a replacement for the floppy backup program.
Step
1.From the System Maintenance Menu, go to the System Configuration Menu.
2. Start the backup.
Select:(B) Backup COS
Prompt: VoiceMemo Selective Backup
Insert Backup Diskette 1 in floppy drive 

EnterY...

cl?5413
Restore a Class of ServicePage 1 of 1VoiceMemo Release 6.0 and later
This procedure describes how to restore the defined Classes Of Service (COS) for the
server. This program is not the same as the restore program found on the Maintenance
From Hard Disk Menu.
Step
1.From the System Maintenance Menu, go to the System Configuration Menu.
2. Start the restore.
Select:(A) Restore COS
prompt: VoiceMemo System Configuration, FCOS and LCOS
Restore Program
Insert Backup Diskette 1 in floppy drive
EnterY...

cl?5414Set the System Time and DatePage 1 of 1
VoiceMemo Release 6.OA and later
This procedure describes how to set the system time and date.
StepReference
1.Reach the System Maintenance Menu, then go to the System Maintenance -Additional Options Menu.
2.Change the time and date as necessary.
Select:(T) Time and Date
Prompt: System time/date: [current settings]
Menu Map 12
Enter new value or press 
 to leave unchanged.
Enter date (mm-dd-yy)*.Response: The correct date in the format of mm-dd-yy,
or press...