Lucent Technologies DEFINITY Enterprise Communications Server Release 8.2 Upgrades And Additions Manual

DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r  555-233-115  Issue 1
April 2000
Adding or Removing Cabinet Hardware 
6-109 Add a Switch Node Carrier (High or Critical Reliability) 
6
Save Translations
1. Log  in at the manag ement terminal.
2. If the system is hig h- or c ritic al-reliab ility, typ e status spe
 and press 
En te r  
to verify that the stand b y SPE is refreshed  and  that the stand b y d isk is in 
servic e.
3. Type save translation [spe-a 
or both]...

DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r  555-233-115  Issue 1
April 2000
Adding or Removing Cabinet Hardware 
6-110 Add a Switch Node Carrier (High or Critical Reliability) 
6
Shut Down DEFINITY AUDIX System
1. Shut down the AUDIX assemb ly and  allow the d isk to c omp letely sp in 
d own. Refer to ‘‘DEFINITY AUDIX Power Procedures’’ on page 6-141
.
!WARNING:
Neg lec ting  to shut d own an AUDIX assembly b efore p owering  d own 
the system c ab inet where it...

DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r  555-233-115  Issue 1
April 2000
Adding or Removing Cabinet Hardware 
6-111 Add a Switch Node Carrier (High or Critical Reliability) 
6
Remove Port Carrier D
NOTE:
Note the p osition of the TDM/LAN c ab les b efore d isc onnec ting .
1.If a switc h node c arrier is b eing  installed  in the “ D”  p osition of an EPN, 
remove the TDM/LAN c ab le from b etween the “ D”  and  “ A”  c arriers.
For other EPNs or the PPN, d...

DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r  555-233-115  Issue 1
April 2000
Adding or Removing Cabinet Hardware 
6-112 Add a Switch Node Carrier (High or Critical Reliability) 
6
Figure 6-38. Locations of Ground JumpersFigure Notes
1.Port Carrier (“ C” Position)
2. Ground  Jump ers
3. Control Carrier (“ A”  Position)4. Switc h Nod e Carrier (“ D”  Position)
5. Switc h Nod e Carrier (“ E”  Position)
6. Cabinet with standard  fan unit and  c arrier
7. Cabinet with...

DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r  555-233-115  Issue 1
April 2000
Adding or Removing Cabinet Hardware 
6-113 Add a Switch Node Carrier (High or Critical Reliability) 
6
Prepare New Switch Node Carrier D
1. Visually inspec t the new c arrier for any d amag e. Verify that the b ac kp lane 
pins are not bent.
2. Plac e the switc h nod e c arrier on the floor so that the rear of the c arrier 
fac es up .
3. Verify that the four AHF105 switc h nod e (SN) b...

DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r  555-233-115  Issue 1
April 2000
Adding or Removing Cabinet Hardware 
6-114 Add a Switch Node Carrier (High or Critical Reliability) 
6
Install New Switch Node Carrier D
1.Install the J58890SA switc h nod e c arrier in p osition “ D”  b y lining  up  the 
p lastic  alignment tip s on the top rear of the c arrier with the sc rew holes in 
the c ab inet. These alig nment tip s will sup port the c arrier while the sc rews...

DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r  555-233-115  Issue 1
April 2000
Adding or Removing Cabinet Hardware 
6-115 Add a Switch Node Carrier (High or Critical Reliability) 
6
Figure 6-40. Locations of Top and Bottom Ground Straps on Standard and 
Enhanced Carriers
8.If a switc h node c arrier is b eing  installed  in the “ D”  p osition of the PPN, 
install the TDM/LAN c able (b etween the “ E”  and  “ D”  c arriers) to the 
p in-field  b loc k marked  “...

DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r  555-233-115  Issue 1
April 2000
Adding or Removing Cabinet Hardware 
6-116 Add a Switch Node Carrier (High or Critical Reliability) 
6
9. Also, for the PPN, connect the loose end of the TDM/LAN c able (between 
the “ A”  and  “ D”  c arriers) to the other pin-field  b loc k marked  “ TDM/LAN”  on 
the rig ht sid e of the “ D”  c arrier. See Figure 6-41
 and  Table 6-10. The other 
end  remained  c onnec ted  to the “ A”...

DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r  555-233-115  Issue 1
April 2000
Adding or Removing Cabinet Hardware 
6-117 Add a Switch Node Carrier (High or Critical Reliability) 
6
Figure 6-42. TDM/LAN Connections for Critical Reliability R8r PPN
CONTROL
CARRIERCONTROL CARRIER
SWITCH NODE CARRIERD POSITIONA POSITION SLOT 21
PORT CARRIERTDM/LAN BUS TERMINATOR
(ZAHF4)
J58890BB
SLOT 21
C POSITION
TDM/LAN BUS
TERMINATOR
(ZAHF4)
REAR VIEWE POSITION
SWITCH NODE...

DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r  555-233-115  Issue 1
April 2000
Adding or Removing Cabinet Hardware 
6-118 Add a Switch Node Carrier (High or Critical Reliability) 
6
10.If a switc h node c arrier is b eing  installed  in the “ D”  p osition of an EPN, 
verify that the ZAHF4 TDM/LAN b us terminator is installed  at slot “ 02”  of 
exp ansion c ontrol c arrier “ A” . See Figure 6-42
.
If a switc h node c arrier is b eing  installed  in the “ E”  p...