Lucent Technologies DEFINITY Enterprise Communication Server Release 8.2 Installation And Test For Multi-Carrier Cabinets Manual

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Install Telecommunications Cabling 
2-15 Install Sneak Fuse Panels 
2
Tab le 2-2 is a p inout of the c ab le wiring  and  assoc iated  fuse numb ers.
6. Sec ure the top  of eac h B25A c ab le with the c ap tive sc rew on the 
c onnec tor.
7. Sec ure the b ottom of eac h c ab le with a sup p lied  c ab le tie wrap.
Table 2-2. Sneak Fuse Connector Pinout
Connector 
Pin 
NumbersPair/Fuse 
Number
26/1...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Install Telecommunications Cabling 
2-16 Cable Installation 
2
Cable Installation
Labels
The purple p ort lab el shown in Fig ure 2-8 is installed  on both end s of the 25-pair 
c ab les c onnec ting  to the trunk/auxiliary field  and /or d istrib ution field.
The top  b lue/yellow b uild ing  and floor labels are for c ab les c onnec ting  from the 
eq uip ment room to a site/satellite loc ation on...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Install Telecommunications Cabling 
2-17 Cable Installation 
2
Tab le 2-3 d etails the lab el name and rang e of eac h lab el. 
Fi g u re  2 - 9 shows the p roper way to install a lab el on a 25-p air c ab le c onnec tor. 
Install the lab el near the rear of the c onnec tor so it is not ob sc ured  b y the c ab inet 
c onnec tor retainers. It c an also b e installed  on the skin of the c ab le near...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Install Telecommunications Cabling 
2-18 Cable Installation 
2
Cable Routing Guidelines
General
The following guid elines should  b e used  when installing the eq uipment room 
c ab ling. Following  these guid elines will maximize use of the c ab le slac k 
manag ers and  make future c abling  ad d itions and  c hang es easier.
Fi g u re  2 - 1 0
 and Fig ure 2-11 show typ ic al c ab le routing...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Install Telecommunications Cabling 
2-19 Cable Installation 
2
Figure 2-11. Cable Routing to Bottom Terminal Blocks
Route Cables to Main Distribution Frame
The following guid elines should  b e followed when routing  c ab les from the 
c ab inet to the MDF.
nEac h p ort c ab le is c onnec ted at the c ab inet and  then routed  along  the 
front troug h of the c ab le slac k manag er to the c onnec...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Install Telecommunications Cabling 
2-20 Cable Installation 
2
nRoute the c ab le from the c ab inet to the wall. Plac e the c ab le b eside 1 of 
the rows of columns in the cable slack manager.
NOTE:
Retainers mounted  on the c olumns keep  the c ab le from p rotrud ing  
above the top of the base of the cable slack manager.
nDetermine the leng th of the c ab le req uired  to reac h from the c ab...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Install Telecommunications Cabling 
2-21 Cable Installation 
2
Connect Control Carrier Outputs Cable
Plug  the c onnec tor c ab le in the AUX
 c onnec tor on the rear of the Control Carrier. 
Route the c onnec tor c ab le throug h the c ab le slac k manag er to the assig ned  
110-typ e terminal b loc k in the yellow field  of the trunk/auxiliary field.
Install Trunk Cables Among Network Interface,...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Install Telecommunications Cabling 
2-22 Cable Installation 
2
Figure 2-12. Connect Trunk Pairs Using Concentrator Cables Figure Notes:
1. Trunk/Auxiliary Field
2. To Control Carrier AUX Connec tor
3. Conc entrator Cable (WP90929, List 1)
4. Conc entrator Cable (WP90929, List 3)
5. A25D (Male-to-Male) Cab le
6. Alternate Bloc k/Rows7. RJ21X/RJ2GX Network Interface
8. Sneak Fuse Panel
9. B25A Cable...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Install Telecommunications Cabling 
2-23 Cable Installation 
2
Connect Trunk Pairs to Cabinet Using Jumper
Wires To Establish 3-Pair Modularity
Figure 2-13 on p ag e 2-23 and Fig ure 2-14 on p age 2-24 show trunk p airs 
c onnec ted  to the c ab inet with jump er wires to estab lish 3-p air mod ularity.
Figure 2-13. 3-Pair Modularity for Trunk Pairs for 1-Pair Trunks
To c onnec t the trunk p airs to...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Install Telecommunications Cabling 
2-24 Cable Installation 
2
Figure 2-14. 3-Pair Modularity for Trunk Pairs for 3-Pair Tie Trunks
Install Cables Between Cabinet and MDF
1.Install “ D”  ring s on the wall b etween the c ab le slac k manag er and  the 
terminal/c onnec ting  b loc ks mounted  on the MDF.
2. Install a self-adhesive p ort lab el on the b ac k of eac h c onnec tor on the 
c onnec tor c...