Lucent Technologies DEFINITY Enterprise Communication Server Release 8.2 Installation And Test For Multi-Carrier Cabinets Manual

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Accessing and Activating the System 
3-45 Administer Fiber Links (Release 8r Only) 
3
NOTE:
When you ad minister DS1 Converter TN1654 c irc uit p ac ks, d ifferent field s 
display.
For field  d efinitions of the field s d isp layed  on p ag e 3 of the Fib er Link 
Ad ministration form, refer b ac k to the p revious sec tion.
DS1 Converter Complex Administration for T1 TN1654 Circuit Packs. 
Screen...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Accessing and Activating the System 
3-46 Administer Fiber Links (Release 8r Only) 
3
estab lishes a link on a T1/E1 fac ility. The initial id le c od e used  b y the 
TN1654 is overwritten b y the c enter stag e switc h to an “ all ones”  p attern 
onc e framing is estab lished  on that T1/E1 fac ility.
nFraming Mode
 — For TN1654 with 1.544 Mb p s Bit Rate, this is a 
d isp lay-only field ....

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Accessing and Activating the System 
3-47 Administer Fiber Links (Release 8r Only) 
3
nBit Rate — Disp lays when the DS1 Converter c irc uit pac k is TN1654. 
Enter either 1.544
 for d omestic  T1 op eration or 2.048
 for international E1 
op eration.
NOTE:
Sinc e one b it rate ap p lies for all fac ilities within the same DS1 
Converter c omp lex, Bit Rate
 d isp lays only und er Fac ility A. To...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Accessing and Activating the System 
3-48 Reboot High Reliability System 
3
Reboot High Reliability System
1. Type reset system 4
 and p ress En t e r.
2. When the login:
 prompt appears, login as craft.
3. Ab out eig ht minutes after b ooting and  at the Command:
 p rompt, typ e 
status spe
 and press 
En t e r.
4. Verify that handshake, shadowing,
 and refreshed
 are all shown to 
b e either yes...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Accessing and Activating the System 
3-49 Save Translations 
3
Save Translations
Save Translations (Release 8si)
For stand ard  reliab ility systems, 1 translation c ard  p lus 1 b ac kup  is required . For 
high or c ritic al reliab ility systems, 2 translation c ard s p lus 2 b ac kup s are 
req uired .
!CAUTION:
Do not attemp t to save translations on the orang e-lab eled , 10 MB memory 
c ard ....

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Accessing and Activating the System 
3-50 Installation Completion 
3
Installation Completion
1. The system must now b e tested  for p rop er op eration. See Chap ter 4, ‘‘Te s t  
the System’’.
2. After c omp letion of the system tests, install the telep hones and  other 
eq uip ment. See Chapter 5, ‘‘
Install and  Wire Telep hones and  Other 
Eq uip ment’’.
3. Ad minister the system b y ad d ing...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Accessing and Activating the System 
3-51 DEFINITY AUDIX Power Procedures 
3
nIf the AUDIX remained in the c ab inet b ut p ower was removed  from the 
c ab inet:
1. Power up  the c ab inet. The AUDIX reb oots automatic ally.
2. Check for AUDIX System errors.
nIf the AUDIX remained in the c ab inet and  the c ab inet was not p owered  
down:
1. At the AUDIX c onsole, hold  the 
crtl key and  enter...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Accessing and Activating the System 
3-52 DEFINITY AUDIX Power Procedures 
3 

Test the System 
4-1  
4
DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
4
Test the System
The following tests p rovid e verific ation of the TDM b us c ables and  terminators, 
and  fib er op tic  inter-c ab inet c ab les. If a FAIL result c od e is seen or other 
p rob lems are ind ic ated , c hec k these c ab les. If p rob lems c ontinue, refer to 
DEFINITY Enterp rise Communic ations Server Release 8 Maintenanc e for R8r or 
DEFINITY Enterp...

DEFINITY ECS Release 8.2 Installation and Test
for Multi-Carrier Cabinets  555-233-114  Issue 1
April 2000
Test the System 
4-2 Check System Status for Each Cabinet 
4
Check System Status for Each Cabinet
1. Verify the terminal sc reen d isp lays: Command:
2. Type status cabinet 
 
and  press 
En t e r.
3. Verify the sc reen d isp lays system status sc reens similar to Sc re e n  4 - 1
:
Screen 4-1. Example System Status Screen for Cabinet 1
Check Circuit Pack Configuration
1. Verify the sc reen d isp...