Home > Inter-Tel > Communications System > Inter-Tel Imx/Gmx 416/832 Installation Manual

Inter-Tel Imx/Gmx 416/832 Installation Manual

Here you can view all the pages of manual Inter-Tel Imx/Gmx 416/832 Installation Manual. The Inter-Tel manuals for Communications System are available online for free. You can easily download all the documents as PDF.

Page 161

INTER-TELPRACTICES 
IMX/GMX 416/832 INSTALLATION & MAINTENANCE INSTALLATION 
Issue 1, November 1994 
l?IGURE3-46. 68OOOEXPANDEDCO-PROCESSOR(PR068E)CARD 
SERIAL PORT 2 
TO SERIAL PORT 1 
- 60-PIN CONNECTOR 
TO HDLC CARD 
- STRAP LOCATION 
- DB9 CONNECTORS 
Page 3-77  

Page 162

INSULLATION 
Issue 1, November 1994 INTER-TEJA PRACTICES 
lMX/GMX 416/832 INSTALIATION & MAINTENANCE 
FIGURE 3-47. MODEM CARD 
1, 
.-i 
/ 
- MODULAR JACKS 
DIP SWITCHES 
NOTE: Depending on the specific model of Modem Card being installed, the location and order 
of the PHONE jack and the LINE (or WALL) jack can vary from card to card. 
Page 3-78  

Page 163

INTER-TELPRACTKES INSTALLATION 
IMX/GMX 416/832 INST4LLATION & MAINTENANCE Issue 1, November 1994 
FIGURE 3-48. MFM-TYPE DISK CONTROLLER CARD 
5 
5 
s 
5 
5 
5 
5 
5 
: 
: 
/ 
5 
4 
: 
: 
; 
: 
; 
: 
I 
; 
; 
; 
: 
: 4PIN CONNECTOR 
TO SYSTEM STATUS PANEL 
W-PIN CONNECTOR NOT CURRENTLY USED 
19PIN CONNECTOR TO HARD DISK DRIVE 
33-PIN CONNECTOR TO HARD DISK DRIVE 
33-PIN CONNECTOR TO FLOPPY DISK DRIVE 
Page 3-79  

Page 164

INST4LLATION Issue 1, November 1994 INTER-TELPRACTICES 
IMX/GMX 416/832 INSTALLATION & MAINTENANCE 
FIGURE 3-49. IDETYPE DISK CONTROLLER CARD 
STRAPS 
4-PIN CONNECTOR 
TO SYSTEM STATUS PANEL 
40-PIN CONNECTOR TO HARD DISK DRIVE 
34-PIN CONNECTOR TO FLOPPY DISK DRIVE 
NOTE: Both of these connectors on the edge of the card must be plugged into a single large 
(16-bit) slot on the PCMotherboard, rather than plugging only the bottom connector into a small 
(S-bit) slot. For proper slot locations, refer to...

Page 165

INTER-TELPRACTICES 
IMX/GMX 416/832 INSTALLATION % MAINTENANCE INSTALLATION 
Issue 1, November 1994 
G. INSTALL THE COMPUTER DRIVES 
NOTICE 
Personal computer (PC) technology is continually 
evolving. As it does, the 416/832 System will con- 
tinue to incorporate important design enhance- 
ments. Thus, depending on the actual version of 
equipment that is shipped, the following installa- 
tion instructions could vary somewhat. If revised 
instructions are included with the equipment, refer 
to them...

Page 166

INSTALLATION Issue 1, November 1994 INTER-TRLPRACTICES 
IMX/GMX 416/832 INSIXLLATION & MAINTENANCE 
the disk drive mounting shelf until it locks into 
place (see Figure 3-50). 
NOTE: To provide adequate air circulation and 
dissipate excess heat, separate the two disk 
drives in the mounting shelf by installing the 
floppy disk drive in the top slot and the hard disk 
drive in the bottom slot. 
(6) Plug the free end of the disk drive power cable 
(removed in step 3) into one of the vacant disk 
drive...

Page 167

INTER-TELPRACTICES 
IMX/GMX 416/832 INSTALLATION % MAINTENANCE INSTALLATION 
Issue 1, November 1994 
FIGURE 3-50. 
INS’IALLING THE COMPUTER DISK DRIVES 
FLOPPY DISK DRIVE 
. 
. 
. 
* 
.* 
. 
DISK DRIVE 
MOUNTING SHELF 
 
/ 
 
HARD DISK DRIVE 
Page 3-83  

Page 168

INSlXLLATION INTER-TELPRACTICES Issue 1, November 1994 
IMX/GMX 416/832 lNS’E4JLA’I’ION & MAINTENANCE 
I. INSTALL THE TELECO MMUNICATION 
CIRCUITCARDS 
639 With the exception of the Matrix Card (which is 
installed in the last slot of the main cabinet - slot 27) 
and the Expansion Card (which is installed in the last 
slot of the expansion cabinet -slot 27), the telecommu- 
nication circuit cards can be installed in any card slot. 
However, to facilitate installation and programming, it 
is recommended...

Page 169

INTER-TELPRAcITcJ3!3 IMX/GMX 416/8X INSTALLATION % MAINTENANCE INSTALLATION 
Issue 1, November 1994 
(3) 
(4) 
(5) 
(6) 
(7) 
(8) music from either music source. For the Music- 
On-Hold feature, either music source can be as- 
signed on a trunk groupby-trnnk group basis. 
Make sure the main and expansion AC POWER 
switches an? turned OFF. Inserting or removing 
theiUXC with the power on may abnage thepm 
cessoI: 
With the components facing right, slowly and 
carefully insert the MKC in the last (27th)...

Page 170

INS-TION INTER-TELPRACTICES 
Issue 1, November 1994 
IM.X/GMX 416/832 INSTALLATION & MAINTENANCE 
FIGURE 3-51. MATRIX CARD (MXC) 1. 
., 
DTMF EXPANSION 
CHIP SOCKETS 
LED INDICATORS - 
SYSTEM VOLTAGE 
TEST POINTS 
-rDa LAmmm I I 
15PIN CONNECTOR - 
TO HDLC CARD 
RESET SWlTCH 
AMPHENOL-TYPE - 
CONNECTOR 
MUSIC-ON-HOLD 
(MOH) STRAPS . . . ” ,--.--, 
lF7 (4.8Viq 
TFa (GmuNo) 
MODULAR JACK 
l 
TO MODEM CARD 
I 
/ MXC EXPANSION 
CHIP SOCKETS 
Page 3-86  
Start reading Inter-Tel Imx/Gmx 416/832 Installation Manual

Related Manuals for Inter-Tel Imx/Gmx 416/832 Installation Manual

All Inter-Tel manuals