Inter-Tel Imx/Gmx 416/832 Installation Manual

INTER-TELPRACTICES 
IMX/GMX 416/832 INSTALLATfON & MAINTENANCE INSTALLATION 
Issue 1, November 1994 
FIGURE 3-41. MXIC PC MOTHERBOARD 
MOUNTING 
NOT CURRENTLY USED 
- HDLC CARD 
CONNECTOR 
MONITOR CARD 
CONNECTOR 
PROWPR068E CARD 
CONNECTOR 
MODEM CARD 
CONNECTOR 
NOT CURRENTLY USED 
ISK CONTROLLER 
CARD CONNECTOR 
12-PIN CONNECTOR 
TO POWER SUPPLY ’ NOT CURRENTLY USED 
5.PIN DIN CONNECTOR 
TO PROGRAMMING KEYBOARD 
Page 3-67  

INSTALLATION 
Issue 1, November 1994 INTER-TELPRACTICES 
IMX/GMX 416/832 INSTALLATION & MAINTENANCE 
NOTE: The M396F PC Motherboard can only be used 
with HDLC Cards that have been modified and labeled 
with EN-2279 or stamped with artwork number 
826.3806-1, -2, or higher. 
(1) 
(2) 
(3) 
(4 
(5) Ensue that the system AC POWER is turned 
OFF. 
NOTE: When inserting or removing the com- 
puter cards, the system power must be turned off 
to prevent damage to the cards. 
Measure the voltage of the battery...

INTER-TELPRACTICES 
IMWGMX 416/832 INSTALLATION 81 -ANCE INSTALLATION 
Issue 1, November 1994 
FIGURE 3-42. 
M396F PC MOTHERBOARD 
HDLC CARD 
CONNECTOR 
MONITOR CARD 
CONNECTOR 
PR068/PR068E CARD 
CONNECTOR 
MODEM CARD 
CONNECTOR 
NOT CURRENTLY USED 
DISK CONTROLLER 
 BAITERY 
12-PIN CONNECTOR 
TO POWER SUPPLY 
CARD CONNECTOR 
5-PIN DIN CONNECTOR 
TO PFiOGFWhMNG KEYBOARD 
Page 3-69  

IN-ION 
Issue 1, November 1994 
INTER-TELPRACTICES 
lMX/GMX 416/832 INSTALLATION 8z MAINTENANCE 
High-Level.Data Link Control (EIDLC) Card 
6.25 Attach the High-Level Data Link Control 
(HDLC) Card to the PC Motherboard as follows. For a 
drawing of the card, refer to Figure 3-43 on page 3-74. 
NOTE: Only HDLC Cards that have been modified and 
labeled with ECN-2279 or stamped with artwork num- 
ber 826.3806-1, -2, or higher can be used with the 
VLSI, MXIC, and M396F PC Motherboards. 
(1) Check to make...

INTER-TELPRACTICES 
IMX/GMX 416/832 INSlALLATION & MAINTENANCE INSTALLATION 
Issue 1. November 1994 
Monitor Card 
6.27 Attach the Monitor Card to the PC Motherboard 
as follows. For a drawing of the card, refer to Figure 
3-44 on page 3-75. 
(1) 
(2) 
(3) 
Check to see that all components on the card are 
seated securely in their sockets and that no pins 
are bent. 
With the componentsfacing lef, insert the Mon- 
itor Card in the slot labeled MGA and attach it 
securely to the PC Motherboard. 
NOTE: The...

INSTALLATION 
Issue 1, November 1994 INTER-TELPRACTICES 
IMX/GMX 416/832 INSTALLATION & MAINTENANCE 
(1) 
(2) 
(3) 
tom edge of the Pro68lPro68E Card. Then attach 
the free end of the g-pin serial port 2 interface 
cable to the j&f DB9 connector on the bottom 
edge of the card. 
NOTE: The serial port 1 and serial port 2 inter- 
face cables come pre-routed in the equipment 
cabinet. The free ends of the cables lie in the sof- 
fit (cable shelf), while the other ends of the 
cables are attached to the...

INTER-TELPRACTICES 
IMX/GMX 416/832 INST4LLATION & MAINTENANCE INSTALLATION 
Issue 1, November 1994 
(5) Attach the appropriate end of the huni 20-ton- 
drcctor 
(A) disk-to-controller interface cable in- 
cluded with the system to the 19-pin connector 
on the front edge of the MFM-type Disk Control- 
ler Card. 
NOTE: Be sure that the colored edge of the disk- 
to-controller cable aligns with Pin 1 on the con- 
nector. The other end of the cable will be 
connected to the hard disk drive after it is in-...

INSTALLATION 
Issue 1, November 1994 INTER-TELPRACTIcES 
lMX/GMX 416/832 INSTALLATION & MAINTENANCE 
FIGURE 3-43. HIGH-LEVEL DATA LINK (HDLC) CARD 
RESET SWlTCH 
v 4-PIN & 2-PIN CONNECTORS 
TO SYSTEM STATUS PANEL 
.- 2-PIN CONNECTOR 
TO PC MOTHERBOAFiD 
50-PIN CONNECTOR  . 
TO PRO68 CARD 
,- SPIN CONNECTOR 
TO POWER SUPPLY 
> 
STRAP LOCATIONS 
DIP SWlTCHES 
DB15 CONNECTOR 
TO MATRIX CARD 
Page 3-74  

INTER-TELPRACTICE!J 
lMX/GMX 416/832 INSTALLATION & MAINTENANCE INSTALLATION 
Issue 1, November 1994 
FIGURE 3-44. MONITOR CARD 
DB9 CONNECTOR 
TO PFiOGFiAMMING MONITOR 
DB25 CONNECTOR 
NOT CURREKnY USED 
Page 3-75  

INSTALLATION 
Issue 1, November 1994 INTER-TEJAPRAcTIcES 
IMX/GMX 416/832 DFWiLLATION & MAINTENANCE 
FIGURE3-45. 6?3000CO-PROCXSSOR(PR068) I-x 
., 
:) 
. 
PRO69 MEMORY 
CARD 
512K OR 3MB 
STRAP 
LOCATIONS 
DIP SWITCHES CONNECTOR 
TO HDLC CARD 
- DB9 CONNECTORS 
Page 3-76