HP Color LaserJet CM1015 User Manual

							
Install memory DIMMs
When installing more memory for the MFP, it is possible to install a DIMM to print characters for
languages such as Chinese, or for the Cyrillic alphabet.
CAUTIONStatic electricity can damage DIMMs. When handling DIMMs, wear an antistatic wrist
strap, or frequently touch the surface of the DIMM antistatic package then touch bare metal on
the MFP.
1. Print a Configuration page by pressing  OK and  Cancel  simultaneously. (A Supplies Status page
may also print.) If the Configuration page does not print in your language, see 
Information pages .
2. After the Configuration page prints, turn the MFP off and disconnect the power cable.
3.On the left rear side of the MFP, open the DIMM door.
ENWW Install memory DIMMs 207
 
						

							
4.Release the locks on each side of the DIMM slot.
5.Remove the DIMM from the antistatic package.
6.Holding the DIMM by the edges as shown in the illustration, align the notches on the DIMM with
the DIMM slot.
208 Chapter 15   Work with memory ENWW
 
						

							
7.Firmly press the DIMM straight into the slot. Firmly close the locks on each side of the DIMM until
they snap into place.
8.Close the DIMM door.
ENWW Install memory DIMMs 209
 
						

							
9.Reconnect the power cable and turn on the MFP.
10.Go to Check DIMM installation .
210 Chapter 15   Work with memory ENWW
 
						

							Check DIMM installation
Check that the DIMMs are installed correctly and working.
1.Turn the MFP on. Check that the Ready light is on after the MFP has completed the startup
sequence. If an error message appears, a DIMM might have been incorrectly installed.
2.Print a Configuration page by pressing OK and Cancel simultaneously. (A Supplies Status page
may also print.)
3.Check the Installed Personalities and Options section on the Configuration page and compare it
with the Configuration page printed before the DIMM installation.
4.If the amount of recognized memory has not increased or the DIMM is not recognized, the following
conditions might exist:
●The DIMM might not be installed correctly. Repeat the installation procedure.
●The DIMM might be defective. Try installing a different DIMM.
5.After the DIMM is installed correctly, go to 
Enable memory if a memory DIMM was installed.
Enable memory
If the MFP has a new memory DIMM installed, all Windows users of the MFP must set the printer driver
to recognize the newly added memory. Macintosh computers automatically recognize new memory.
To enable memory for Windows
1.On the Start menu, point to Settings, and click Printers or Printers and Faxes.
2.Select this MFP and select Properties.
3.On the Configure tab, click More.
4.In the Total Memory field, type the total amount of memory that is now installed.
5.Click OK.
ENWWCheck DIMM installation 211
 
						

							212 Chapter 15   Work with memory ENWW
 
						

							A Accessories and supplies information
The lists of accessories in this section was current at the time of printing. Ordering information and
availability of the accessories might change during the life of the MFP. For the most current ordering
information, visit 
http://www.hp.com.
●
Supplies
●
Memory
●
Cable and interface accessories
●
Paper handling accessories
●
Paper and other print media
●
User-replaceable parts
●
Supplementary Documentation
ENWW213
 
						

							Supplies
Product nameDescriptionPart number
Black print cartridgeLife of 2,500 pages at approximately 5%
coverage.Q6000A
Cyan print cartridgeLife of 2,000 pages at approximately 5%
coverage.Q6001A
Yellow print cartridgeLife of 2,000 pages at approximately 5%
coverage.Q6002A
Magenta print cartridge Life of 2,000 pages at approximately 5%
coverage.Q6003A
NOTEActual yields vary according to usage.
Memory
NOTEThere is no limitation on memory for photos, but there is a photo card limit of 9,999 photos
per card.
Product nameDescriptionPart number
Memory upgrades (DIMMs)64 MB-100 pin, 100 MHz SDRAM DIMMQ7708A
Memory upgrades (DIMMs)128 MB-100 pin, 100 MHz SDRAM
DIMMQ7709A
Memory upgrades (DIMMs) 256 MB 32bit 100 pin SDRAM  
214 Appendix A   Accessories and supplies information ENWW
 
						

							Cable and interface accessories
Product nameDescriptionPart number
USB cable 2-meter standard USB-compatible
device connectorC6518A
Paper handling accessories
Product nameDescriptionPart number
Tray 3 (Optional) Optional 250-sheet universal input tray
(included with the HP Color LaserJet
CM1015/CM1017). Only one optional
250-sheet tray can be installed.Q6459A
ENWW Cable and interface accessories 215
 
						

							Paper and other print media
Product nameDescriptionPart number
HP Multipurpose paper75 g/m2 (20 lb), 96 brightHPM1120
(letter)
HPM1420
(legal)
HP All-in-One Printing Paper81 g/m2 (22 lb), 96 brightHPT 115 (letter)
HP LaserJet Paper90 g/m2 (24 lb), 96 bright
90 g/m
2 (24 lb), 153 whiteness
HPJ1124 (letter)
CHP310 (A4)
HPJ1424 (legal)
HP Premium Choice Paper120 g/m2 (32 lb), 98 bright
120 g/m
2 (32 lb), 158 whiteness
HPU1132
(letter)
CHP410 (A4)
HP Presentation Laser Paper, glossy130 g/m2 (34 lb), 96 brightQ2546A (letter)
HP Professional Paper, glossy130 g/m2 (34 lb), 130 whitenessQ2552A (A4)
HP Photo & Imaging Laser Paper, matte200 g/m2 (54 lb), 96 brightQ6549A (letter)
HP Brochure laser paper, matte160 g/m2 (52 lb), 96 brightQ6543A (letter)
150 sheets
HP Tough paper5 mil thick, Water/Tear proofQ1298A (letter)
Q1298B (A4)
HP Color LaserJet transparencies 5 mil thick C2934A (letter)
50 sheets
C2936A (A4)
50 sheets
User-replaceable parts
Product nameDescriptionPart number
Separation pad and pick-up rollersReplace when the MFP is picking up
multiple sheets or no sheets. Trying
different paper did not resolve the
problem.Q5956-67902
Paper trayA 250-sheet paper tray cassette.Q5956-67901
Dust coverProtects the output of paper cassette
from dust.Q5956-67903
Scanner flatbed coverReplacement partCB394-60106
Control-panel over lay (various
countries/regions)Replacement part (localized)Order at http://www.hp.com/support/
cljCM1015_CM1017
Output tray Replacement part Order at http://www.hp.com/support/cljCM1015_CM1017
216 Appendix A   Accessories and supplies information ENWW