Epson Aculaser CX28DN User Manual

							Scanning With the Machine 179
1In the main screen (Scan mode), press the + or , key to select CANCEL 
RESERV
., and then press the Select key.
2Press the + or , key to select the job to be deleted, and then press the 
Select key.
To check the information for the selected job, press the ) key.
If no jobs are queued for transmission, NONE appears.
3Press the + or , key to select YES, and then press the Select key.
The main screen (Scan mode) appears again.
 
						

							Scanning With the Machine 180
 
						

							9Replacing
Consumables
 
						

							Replacing Consumables 182
Replacing Consumables
Note
Failure to follow instructions as outlined in this manual could result in 
voiding your warranty.
Note
If an error message (Toner Empty, I-UNIT END, etc.) appears, print 
out the configuration page, and then check the status of the other 
consumables. For details on the error messages, refer to “Error Messages” 
on page 255. For details on printing the configuration page, refer to 
“Printing a Configuration Page” on page 213.
About Toner Cartridges
Your machine uses four toner cartridges: black, yellow, magenta, and cyan. 
Handle the toner cartridges carefully to avoid spilling toner inside the machine 
or on yourself.
Install only new toner cartridges in your machine. If a used toner car-
tridge is installed, the indicator message will not clear and the supplies 
status in the Status Monitor will not be updated.
The toner is nontoxic. If you get toner on your skin, wash it off with 
cool water and a mild soap. If you get toner on your clothes, lightly 
dust them off as best as you can. If some toner remains on your 
clothes, use cool, not hot water, to rinse the toner off.
CAUTION
If you get toner in your eyes, wash it out immediately with cool water 
and consult a doctor. 
Note
Do not use refilled toner cartridges or unapproved toner cartridges. Any 
damage to the machine or quality problems caused by a refilled toner 
cartridge or an unapproved toner cartridge will void your warranty. No 
technical support is provided to recover from these problems.
 
						

							Replacing Consumables 183
When replacing a toner cartridge, refer to the following table. For optimum 
print quality and performance, use only approved Epson toner cartridges, as 
listed in the table below. You can find the toner cartridge part numbers on the 
consumables reorder label inside the front cover your machine.
For optimum print quality and performance, use only the corre-
sponded TYPE genuine Epson toner cartridges.
Keep toner cartridges: 
„In their packaging until you’re ready to install them.
„In a cool, dry location away from sunlight (due to heat). 
„The maximum storage temperature is 35°C (95°F) and the maximum stor-
age humidity is 85% (noncondensing). If the toner cartridge is moved from 
a cold place to a warm, humid place, condensation may occur, degrading 
print quality. Allow the toner to adapt to the environment for about one 
hour before use.
„Level during handling and storage. 
Do not hold, stand or store cartridges on their ends or turn them upside 
down; the toner inside the cartridges may become caked or unequally 
distributed.
„Away from salty air and corrosive gases such as aerosols.
Toner Cartridge Type Toner Cartridge Parts Number
High-Capacity Toner Cartridge -Black (K) S050493
High-Capacity Toner Cartridge -Yellow (Y) S050490
High-Capacity Toner Cartridge -Magenta (M) S050491
High-Capacity Toner Cartridge -Cyan (C) S050492
Y
 
						

							Replacing Consumables 184
Replacing a Toner Cartridge
Note
Be careful not to spill toner while replacing a toner cartridge. If toner 
spills, immediately wipe it off with a soft, dry cloth.
If 
MACHINE SETTING/TONER EMPTY in the UTILITY menu is set to 
STOP, the message TONER EMPTY/CHANGE X TONER (where “X” indi-
cates the color of the toner) appears when the toner cartridge is nearly empty. 
Follow the steps below to replace the toner cartridge. 
1Check the message window to see which color toner cartridge needs 
replacing.
2Open the machine’s front cover.
3Pull the front lever of the color 
toner cartridge indicated to the 
right.
The replacement procedure for 
the toner cartridge is the same 
for all colors (yellow: Y, magenta: 
M, cyan: C, and black: K).
The following instructions show 
the procedure to replace the 
toner cartridge (Y).
Y
YMCK
 
						

							Replacing Consumables 185
4Lower the lever to release the 
lock.
5Grab the handle of the toner car-
tridge to be replaced, and then 
pull out the cartridge. 
The following instructions show 
the procedure to replace the 
toner cartridge(Y).
Note
Dispose of the used toner cartridge according to your local regulations. 
Do not burn the toner cartridge.
For details, refer to “About Toner Cartridges” on page 182.
6Check the color of the new toner cartridge to be installed.
7Remove the toner cartridge from the bag.
Y
Y
Y
Y
 
						

							Replacing Consumables 186
8Shake the cartridge to distribute 
the toner.
9Make sure that the toner car-
tridge is the same color as the 
machine compartment, and then 
insert the toner cartridge into the 
machine.
10Make sure that the toner car-
tridge is securely installed, and 
then peel off the protective film.
Y
3 ×
YY
Y
Y
 
						

							Replacing Consumables 187
11Raise the front lever to its origi-
nal position.
12Pull the lever to the left to lock it 
in place.
The front lever should be 
securely returned to its 
original position; other-
wise, the front cover of 
the machine cannot be 
closed.
13Close the front cover.
Y
Y
Y
 
						

							Replacing Consumables 188
Replacing an Imaging Unit
When replacing an imaging unit, refer to the following table. For optimum print 
quality and performance, use only approved Epson imaging units, as listed in 
the table below. You can find the imaging unit part numbers on the consum-
ables reorder label inside the front cover your machine.
Note
Do not touch the OPC drum 
surface. This could lower image 
quality.
Exposure to light can damage the 
drum, causing dark or light areas 
to appear on the printed page and 
reducing the service life of the 
drum.
You are advised to replace the indicated imaging unit when the message 
I-UNIT END/REPLACE X appears.
1Check the message window to see which color imaging unit needs replac-
ing.
Imaging Unit Type Imaging Unit Parts Number
Imaging Unit -Black (K) S051194
Imaging Unit -Yellow (Y) S051191
Imaging Unit -Magenta (M) S051192
Imaging Unit -Cyan (C) S051193
Y
P
U
S
H