Vodavi Infinite Dvx Iii Hybrid Key Telephone System Installation Manual

in@nite” DVX ’ and DVX I1
Co LINE ATTRIBUTES PROGRAMMING
Digital Key Telephone Systems
PAGE 
“B” CO LINE ATTRIBUTES (Cont’d)
G.Music-On-Hold per CO Line (FPS)
Progmmming StepsIf the Music-On-Hold source needs to be
changed:
1,Press the MUSIC-ON-HOLD flexible button(Page B, Button 
#lo). The foIIowing mes-
sage is shown on the display phone:
2. Enter a one-digit value on the dial pad to
change this feature.
-(01 = CO Line(s) have No Music-On-Hold.
- 111 = CO Line(s) use Channel 1 for Mu-
sic-On-Hold
3....

iqfiiite” DVX’ aud DVX”
Digital Key Telephone Systems
CO LlNE ATTRIBUTEs PROGRAMMtNG
CO 
LINE ATTRIBUTES (Cont’d)
720.3DIALPULSE P-RS
Programming Steps
If this feature is to be assigned:
a. Press FLASH and dial (4 1). The following
message is shown on the display phone:
b.The Dial Pulse features will toggle on and
off with each depression, and the display
will update with each depression.
l LED on = 60/40 (RATIO), 1Opps (SPEED).
LED off = 66/33 (RATIO), 2Opps (SPEED)
c. Press the HOLD button to save the...

ir@titew DVX ’ and DVX I1CO LINE ATTRIBUTE% 
Pl!KJGRAadlwNGDigit& Key Telephone Systems
CO LINE ATTRIBUTE% 
fCont*d)720.4
FLEXIBLE PORT ASSIGNMENT
FEATURE
Progp.rnming Steps
If 
the CO Line numbers need to be relocated to
different ports:
a. Press FLASH and dial 
[42].. The following
message is shown on the display phone:
b.The buttons I through 7 indicate cards 1
through 7. When the relocation program is
initially entered, Button 
# 1 will be lit indi-
cating that the user is programming the CO
Line...

TECHNICAL FACT NOTICEDirect Inward Dialing (DID) Feature.h. . -+I-)
for the infiniteTM DVX “I Digital System
F b
This hardware enhancement is supported with Master software Version 1 .OD or higher, and Slave software, Version
l.lA is required. The Database Upload/Download procedures must be used to properly upgrade this software.
Description:
The Direct Inward Dialing (DID) Interface Board provides for One-Way Direct access to specific stations on specific
DID lines from the public telephone network,...

infinite ” Digital SystemsTF NO: 53
Direct Inward Dialing (Cont’d)
Installation of SRAY (Static RAM) Chips on 
lnfinife DVX ’ Digital System:
The Central Processor Unit (CPU) of the infinite DVX 111 Digital system has two 1 -Megabit SRAM chips on it which
determine the amount of RAM used by the infinite Digital Key Telephone System. To upgrade the 
SRAM chips,
the SRAMs must be removed and the new 
SFtAMs installed in their place. Refer to Figure 1 for switch and chip
locations.
IMPORTANT. . . . . . . ....

infinite n Digital SystemsTF NO: 53
Direct Inward Dialing (Cont’d)
Figure 1 Central Processing Unit (CPU)
a:-’
vodavi cunmunicaiiof)E .syskmsPage3 of 27lFN0.538WOEMlltreeDfiW-kmWI- 

infinite n Digital SystemsTF NO: 53
Direct Inward Dialing (Cont’d)
Installation of DID card:
1.By default, the DID Interface Board must be installed in any CO card slot 5, 6, 7, or 6 on the infinite DVX
“’ Digital system.
2.Connect the provided -46~ assembly cable to the J2 connector on the DID Interface Board.
NOTE: At least one 
OTMF receiver MUST be installed in the system for this feature to operate propeflyf
Figure 2 - DID Interface Board (DID)
vodavi cunmunications sy!3km3
Page 4 of 27TF NOi 53...

infinite m Digital SystemsTF NO: 53
Direct Inward Dialing (Cont’d)
CO Line Connections:
The CO Ports of the DID Interface Board are wired to the main distribution frame via a 
25pair, @O-pin) female
amphenol type connector located on the front edge of the board, conector Jl . A 25pair cable with a %)-pin male
amphenol-type connector is required to extend the CO ports to the main distribution frame. The 
pinouts are shown
below:
,
7
8
9
10
11
12
32Red/OrangeTipPort07
7Orange/RedRing
33Red/GreenTipPort08...

infinite ” Digital SystemsTF NO: 53
Direct Inward Dialing (Cont’d)
Conditions:
.
.
.
.
.
.
.
.
.
.
.
w
The infinite DVX “’ Digital system supports up to 1000 DID numbers, with a maximum of 200 ring lists to which
DID numbers can point.
The maximum number of DID trunk circuits supported is limited to the overall system CO line maximum.
DID calls can be programmed to ring to a group (ACD, UCD, VM, hunt, etc.). The current limitations with trunks
ringing to groups apply.
A DID call may be presented to...

lnfhife ” Digital SystemsTF NO: 53
Direct Inward Dialing (Cont’d)
FLEXIBLE CARD ASSIGNMENTS
Description:
The Flexible Card Assignments feature will provide a means to assign the peripheral cards to alternative peripheral
card slots. This provides complete flexibility in determining station numbers and CO line numbers as long as they
stay within the system numbering plan. A station can be assigned any number between 
190 and 219, while a CO
line can be assigned any number between 1 and 96. Station...