Trillium Panther Ii Feature Module Iv System Manual

Panther II 820/1032/2064-205 
TABLE 2-19 GROUP PARAMETERS 
Feature Access 
Descrhtion 
Code Condition 
(Values) Data 
Code 
Tenant Groups 121YY 
No Assignment* 
Group 1 
Group 2 02 - 
Group 3 
Group 4 :z 
. 
Group 5  Group 6 
:: 
Group 7  Group 8 
0”: 
___ __ 
___ 
__ 
Group 15 15 
______________~_____~~~~~-----~~~~~~~~~~~~~~~~~~~~~-~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~_~~~~~~~~. 
Pickup Groups 
125YY Group l* 
Group 2 “0:. 
Group 3 03 
Group 4 04 
5 
(L Group 5 
I Group 6. 0”: 
Group 7 
Group 8 z 
___...

Trillium Standard Practice 
ZONE PAGING GROUPS: In order to perform the Zone Paging 
feature on the Panther II system, each station must be assigned to at 
least one of the fifteen 2-digit pickup groups (01 to 15). Paging groups 
can be organized by department, function or proximity. 
I 
Preprogrammed Value = No Zone Paging Groups. 
2.2 5 To set up Zone Paging Groups: 
Step 1. At Station 10 (using a Panther II Display Set), dial * # 0 1 5. 
Step 2. Dial 122YY (where YY is a 2-digit station number from 10...

Panther II 820/1032/2064-205 
NOTE: Intercom Tenanting capability will be affected by TENANT TYPE 
programming. 
Preprogrammed Value = All users in Group 1. 
NIGHT TRANSFER STATION GROUPS: (Table 2-20) 
After the lines have been assigned to the four NIGHT TRANSFER 
LINE GROUPS (see GROUP PROGRAMMING - General by Line), 
each station must be assigned to one of the four groups. 
Preprogrammed Value = 
No Night Transfer Station Groups. 
TABLE 2-20 GROUP PARAMETERS BY STATION 
Feature Access Condition Data...

Trillium Standard Practice 
3. PROGRAMMABLE KEYS 
3 .O 1 This subsection discusses how to program Prime Lines, flexible C.O. keys, 
Line Pools, flexible DSS/Speed keys, feature keys and unused keys for an individual 
Set. All programming outlined in this subsection is to be completed by the System 
Manager at each Set. 
Prime Line Select 
3.0 2 For simple call processing, a specific line (0 1 to 20) may be designated as the 
Prime Line for a particular Set. This v  ‘P ensures simple, automatic access to...

Panther II 820/1032/2064-205 
Programming Line Pool Keys (Codes 051 to 054) 
3.0 4 
This feature allows a standard line key to be used to access a group of “like” 
lines for outgoing calls (e.g., 
“same area” WATS lines, local lines, FX lines, and so 
on). It is recommended that one key is programmed for the primary line pool, and that 
the primary line pool be made up of local lines. The System Manager decides which 
C.O. line key on each station Set will be “replaced” by a line pool. 
NOTE: Only one...

TriIIium Standard Practice 
Resetting Keys to their Default Values (Code 000) 
3.10 Keys that have been programmed can be reset to 
their preprogrammed (default) 
setting by using the following procedure (e.g., if you have programmed the Line 1 key 
on a Set as a Night Pickup key, then wish to convert it to a Line 1 key again). Note 
that you can reprogram a key without having to reset it to its default setting fmt. 
To reset keys to the default values: 
l Press the PROGRAM Key (or dial * #), then dial...

SYSTEM MANUAL ,,_/---- /--- 
_ -..- 
__. co. 
: 
/ EVSTALJATIQN & CQiMMISSItiNWiVG  
91-0474-1BZ Dee 1989 Printed in U.S.A. 
F-3612-1  

Trillium Standard Practice 
91-0474-1B Panther II 820/1032/2064-200 
Issue 2, June 1989 
PANTHER@ II 820/1032/2061 
Electronic Key Telephone System 
INSTALLATION AND COMMISSIONING 
TABLE OF CONTENTS PAGE. 
1. GENERAL 
Introduction 
Reason For Issue 
2. HARDWARE OVERVIEW 
Key Service Unit 
Panther Telephone Sets 
3. EQUIPMENT IDENTIFICATION 
General 
Part Numbers 
4 
4 
4 
4. 
5. EQUIPMENT CONFIGURATION 
INSTALLATION REQUIREMENTS 
Space Requirements 
Temperature 
KSU Location 
Power Supply Requirements...

Trillium Standard Practice 
TABLE OF CONTENTS 
7. POWER UP CHECKS 
General 
KSU Check 
Set Check 
FC6 / DOC NOTICES 
PAGE 
38 
I I 
0 Copyright 1989 of Mite1 Corporation. All Rights Reserved. 
@ is a Registered Trademark of Mite1 Corporation. 
8 I 
Installation and Commissioning 
Page ii  

Panther II 820/1032/2064-200 
1. GENERAL 
Introduction 
1.0 1 This Practice 
contains information pertaining to the installation and 
commissioning of the Panther II 820,1032 and 2064 Electronic Key Telephone 
Systems. Installation and commissioning may be defined as the tasks necessary to 
prepare the system for operation. 
Reason For Issue 
1.0 2 
This is the second issue of this Practice. It is one of the set of Trillium Standard 
Practices written to assist a craftsperson install, operate and...