Trillium Panther Ii Feature Module Iv System Manual

Trillium Standard Practice 
Line Lead Designation Conductor Color MDF Terminal RJ21 Pin Number 
11 Tip White-Blue 
1 26 
Ring 
Blue-White 2 1 
12 Tip White-Orange 
3 27 
Ring Orange-White 
4 2 
13 Tip White-Green 
5 28 
Ring 
__ Green-White 
6 3 
14 Tip White-Brown 
7 29 
Ring Brown-White 
a 4 
15 Tip White-Slate 
9 30 
Ring Slate-White 
10 5 
16 Tip 
Red-Blue 11 31 
Ring 
Blue-Red 12 6 
17 Tip Red-Orange 
13 32 
Ring Orange-Red 
14 7 
ia Tip 
Red-Green 15 33 
Ring Green-Red 16 
a 
19 Tip Red-Brown 
17...

Panther II 820/1032/2064-200 
Station Wiring 
6.0 
8 The station wiring comprises up to three 25-pair cables (Panther II 820), four 
25-pair cables (Panther II 1032) or eight 25-pair cables (Panther II 2064), which 
connect the KSU to the MDF, along with the number of 4-wire cables required to 
connect the Panther telephone sets to the MDF. The 25-pair cables are not supplied. 
Each cable must not exceed 25 feet in length and must be fitted with a 50-pin ‘D’ Amp 
connector (male) at one end. Install the...

Panther II 820/1032/2064-200 
Remember that each MDF corresponds to a specific group of stations: 
MDF 1 for Stations 10 to 17; MDF 2 for Stations 18 to 25; MDF 3 for Stations 26 to 33; MDF 4 for Stations 34 to 41. 
STATION STATION 25-PAIR MDF 
CONNECTOR LEAD 
NUMBERS WIRE COLORS WIRE COLORS TERMINAL 
PIN FUNCTION 
MDF MDF MDF MDF 
1 
2 3 4 
10 18 26 34 (G) Green White-Blue 1 26 VT 
(R) Red Blue-White 2 1 VR 
(B) Black White-Orange 3 27 DT 
(Y) 
Yelbw Orange-White 4 2 DR 
.._ 
11 19 27 35 G White-Green 5...

Trillium Standard Practice 
Rcmcmbcr IIUI each MDF corresponds LO a spcdic group ol’ SUI~IIIS: 
MDF 9 for Sations 42 to 40: MDF 6 for S!aions 50 10 57: XlDF 7 for Stilions SX IO 65: MDF X for Scltions M tn 73 
, 
-: 
STAT10 N 
NUMBERS STATION 25-I’.\1 R hl DF CONNECTOR LEAD 
WIRE COLORS WIRE: COLORS TE:RMINAL PIN FUNCTION 
IlDF >lDF \lDF MDF 
5 6 7 8 
-12 SO 58 66 
(C) Green White-Blue 1 26 VT 
(R) Rut Blue-White 2 
1 VR 
(R) Bhck White-Or.qx 3 27 DT 
(Y) Yellow Orange- 
While 3 2 DR 
13 51 59 67 G...

Panther II 820/1032/2064-200 
Panther Telephone Set Installation 
6.0 9 
Installation of a Panther telephone set simply requires the set to be connected, 
through the DBU4 (6conductor mod-to-mod cord) supplied with the set, to the 
previously-installed RJ14C jack. Note: 
If the ‘Off-Hook Voice Announce’feature is 
used on the Panther II Display Set, a 6-conductor cable and jack is required for that 
station. Remember that this feature occupies two station ports; for example, 
tf Station 
12 has ‘Off-Hook...

Panther II 820/1032/2064-200 
Door Answer Unit Installation 
6.10 The 
Door Answer Unit supports a maximum of two Door Modules. It is 
connected to the KSU via a 3-pair modular cord, supplied with the Door Answer Unit. 
One Door Answer Unit can be connected to a Panther II 820 or Panther II 1032 system, 
while two Door Answer Units can be connected to a Panther II 2064 system. 
When the 
Door Answer Unit is incorporated in the Panther II 820 system, C.O. line 8 must not 
be connected at the KSU. When the...

Trillium Standard Practice 
Desk/Wall Mpunt 
Unit 
Figure 6-10 Panther Telephone Set Wall Mounting 
Figure 6-11 Door Module Installation 
Installation and Commissioning 
Page 30  

Panther II 820/1032/2064-200 
Power Fail Transfer Unit Installation 
6.13 
A Power Fail Transfer unit transfers up to four outside lines to four standard 
telephone sets (2500 or single line sets) in the event of a power failure at the KSU. A 
number of Power Fail Transfer units can be cascaded to allow the maximum number of 
C.O. lines to be switched to the corresponding number of standard telephone sets; i.e., 
two Power Fail Transfer units would be required to switch the eight C.O. lines of a 
Panther...