Trillium Panther Ii Feature Module Iv System Manual

This document is for Panther II 820, Panther II 1032, 
Panther II 2064 Systems and for Panther II 
Proprietary Peripherals  

Mite1 Standard Practise Panther II 820/1032/2064-297 
91-0580-1A Issue 1, November 1990 
Panther@ II 820/1032/2064 
Electronic Key Telephone System 
FEATURE MODULE IV & ON PREMISE STATION UNIT 
TABLE OF CONTENTS PAGE 
1. INTRODUCTION ........................................................................................... 1 
General ............................................................................................................ 1 
Reason For Issue...

Mite1 Standard Practise 
TABLE OF CONTENTS PAGE 
3-l: 
3-2: 
3-3: 
3-4 
3-5: 
3-6: 
3-7 
3-8: 
5-l: 
5-2: 
5-3 
5-4: 
5-5: 
5-6: 
5-7: 
5-8 
5-9: 
5-10: 
5-11: Setting Call Forwarding .................................................................................. 27 
Programming Automatic Access to a Voice Mail System .............................. 30 
Programming DTMF Digit Strings for Automatic Access .............................. 30 
Programming the Voice Mailbox Numbers...

Panther II 820/1032/2064-297 
TABLE OF CONTENTS PAGE 
2-l: FIGURES 
Inserting the Feature Module IV Cartridge ........................................................ 4 
3-l: On Premise Station Unit .................................................................................... 8 
3-2: On Premise Unit Installation ............................................................................ 15 
3-3: Connecting the MDF to the KSU ..................................................................... 16...

Panther II 820/1032/2064-297 
1. INTRODUCTION 
General 
1.01 This Practice provides instructions for installing and programming Panther II 820/ 
1032/2064 Systems with Feature Module IV software and the On Premise Station Unit. 
Reason Far Issue 
1.02 This is the first issue of this Practice. It is one of the set of Practices written to assist 
a craftsperson install, operate and maintain the system in the field. 
2. FEATURE MODULE IV SOFTWARE 
General 
2.01 In addition to providing the Panther II...

Mite1 Standard Practise 
Initial Installation 
(FOR PREVIOUSLY INSTALLED SYSTEMS, GO TO THE NEXT SECTION) 
The 
following instructions detail initial installation of the Feature Module IV Cartridge. 
CAUTION: Don’t plug in the KSU power cord until you’re instructed to do so. 
Step 1 
Step 
2 
Step 3 
Step 4 
Step 5 
Step 
6 
Step 7 
Step 
8 
Mount the KSU as per the instructions in the INSTALLATION AND COM- 
MISSIOZ-XNG PRACTICE of the PANTHER II SYSTEM 
MANUAL. 
There are two small grooves on the...

Panther II 820/1032/2064-297 
Replacing the Feature Module Cartridge 
The 
following instructions detail the replacement of a Feature Module Cartridge in an ex- 
isting installation. 
Step 1 
Step 2 
Step 3 
Step 4 
Step 5 
Step 6 
Step 7 
Step 8 
Step 9 
Step 10 
Step 11 UNPLUG THE KSU POWER CORD. Telephone service will be discon- 
nected. 
Remove the Feature Module Cartridge protective cover. The protective cover, 
located half-way down the right-hand side of the KSU, is secured by two 
screws and two...

Mite1 Standard Practise 
rort ror reawe 
Module Cartridge I 
~_ III I II III I II 
Feature Module Cartridge 
Plastic Expansion Plugs 
Figure 2-1 Inserting the Feature Module IV Cartridge 
Feature Module l”V & On Premise Station Unit 
Page 4  

Panther II 820/1032/2064-297 
Additional Features 
2.03 This section provides descriptions and programming instructions for the additional 
features that are available with Feature Module IV software. 
Enhanced Call Forwarding 
In addition to forwarding internal ringing calls and certain transfer ringing calls, Feature 
Module IV software provides call forwarding of 
l Incoming external ringing calls, and 
l Internal DISA ringing calls 
TO PROGRAM CALL FORWARDING AT A PANTHER SET 
(See Note Below): 
Step...